RESUMEN

The current research describes a phytochemical analysis and antimicrobial activity of essential oils extracted from the leaves of two Vietnamese Annonaceae species Goniothalamus yunnanensis W.T.Wang and G. touranensis Ast. By the GC-FID/MS (gas chromatography-flame ionization detection/mass spectrometry) analyses, sesquiterpene hydrocarbons accounted for the highest percentage of 68.22% in G. yunnanensis leaf essential oil with bicyclogermacrene (31.03%) and (E)-caryophyllene (21.12%) being the main compounds. G. touranensis leaf essential oil was dominated by monoterpene hydrocarbons (57.08%) with p-cymene (19.95%) and α-pinene (16.82%) being the major compounds. Two oil samples showed strong antibacterial effects on the Gram-positive bacteria Enterococcus faecalis ATCC51299, Staphylococcus aureus ATCC29213, and Bacillus cereus ATCC11778 with the MIC values of 16-64 µg/mL. They also inhibited the growth of the yeast Candida albicans ATCC 60193 with the same MIC value of 128 µg/mL. Both two oil samples showed strong mosquito larvicidal activity against four-instar larvae of Aedes aegypti and Ae. albopictus with the 24-h LC50 values of 16.75-27.60 µg/mL and 24-h LC90 values of 24.31-46.18 µg/mL. Docking results indicated that bicyclogermacrene and p-cymene exhibited the highest ΔG (binding affinity) values of -8.208 and -6.799 kcal/mol with the olfactory binding proteins (OBPs) of Ae. aegypti and Ae. albopictus, respectively.

RESUMEN

The biomaterials based on chitosan andEclipta prostrataL. extract have been prepared by microemulsion method and solution method (with and without sodium tripolyphosphate (STPP) as a cross-linking agent). The main component inEclipta prostrataL. extract is flavonoid groups. The structure of the chitosan/extract biomaterials was studied by infrared spectroscopy. The chitosan/extract biomaterial using STPP cross-linker appeared an absorption band at 1152 cm-1attributed to the vibrations of C-O-P bonds, which proved that chitosan has crosslinked with STPP. The morphology of the biomaterials was investigated by the dynamic light scattering technique and field emission scanning electron microscopy. The obtained results showed that the particle size of the chitosan/extract biomaterials prepared by microemulsion method and solution method with STPP ranged from 68.06 nm to 1484 nm, with an average particle size of 304.9-1019 nm. The microemulsion method produced biomaterials with much smaller average particle size than the solution method using cross-linkers. The hemostatic ability of the biomaterials was better than that of the control sample based on the time of blood clotting formation and glomerular aggregation ability. The sample with the ratio ofE. prostrataL. extract: chitosan of 1:30 had the lowest hemostasis time (6 min 46 s) and its glomerular aggregation rate after 5 min was 13.05%. This indicated that the biomaterials based on chitosan andE. prostrataL. extract are promising for application in biomedicine as hemostatic materials.

Asunto(s)

RESUMEN

Cytotoxic, antioxidative, and antimicrobial activities of Camellia annamensis, and its chemical compositions were first provided in the current study. Phenolic contents in the methanol extracts of its leaves and flowers were 222.73 ± 0.09 and 64.44 ± 0.08 mg GAE/g extract, whereas flavonoid contents in these parts were 108.80 ± 0.28 and 131.26 ± 0.39 mg rutin/g extract, respectively. By using HPLC-DAD analysis, gallic acid (43.72 ± 0.09 - 81.89 ± 1.83 mg/g) and (-)-epigallocatechin gallate (67.31 ± 1.26 - 70.68 ± 7.82 mg/g) were identified as the major compounds. C. annamensis leaf and flower extracts were moderately cytotoxic against A549, HT-29, SK-Mel-2, MCF-7, HepG2, HeLa, and MKN-7. Particularly, they are better than the standards trolox (IC50 7.57 ± 0.23 µg/mL) in lipid peroxidation inhibitory evaluation, and streptomycin (IC50/MIC = 45.34-50.34/128-256 µg/mL) in antimicrobial assay against the Gram-positive bacteria Enterococcus faecalis ATCC299212, Staphylococcus aureus ATCC25923, and the Gram-negative bacterium Salmonella enterica ATCC13076.

RESUMEN

The essential oils of five Vietnamese Syzygium species (Syzygium levinei, S. acuminatissimum, S. vestitum, S. cumini, and S. buxifolium) were first hydro-distilled and analyzed using GC-FID/MS (gas chromatography-flame ionization detection/mass spectrometry). Monoterpene hydrocarbons, sesquiterpene hydrocarbons, and oxygenated sesquiterpenoids were the main chemical classes in these oils. All these essential oils showed good-excellent antimicrobial activities against Gram-positive bacteria Enterococcus faecalis, Staphylococcus aureus, and Bacillus cereus, and the yeast Candida albicans. S. levinei leaf essential oil, rich in bicyclogermacrene (25.3%), (E)-ß-elemene (12.2%), (E)-caryophyllene (8.2%), and ß-selinene (7.4%), as well as S. acuminatissimum fruit essential oil containing (E)-caryophyllene (14.2%), α-pinene (12.1%), caryophyllene oxide (10.9%), ß-selinene (10.8%), α-selinene (8.0%), and α-humulene (5.7%), established the same MIC value of 8 µg/mL against E. faecalis and B. cereus, which were much better than the positive control streptomycin (MIC 128-256 µg/mL). The studied essential oils showed the potential to defend against mosquitoes since they caused the 24 and 48 h LC50 values of less than 50 µg/mL against the growth of Culex quinquefasciatus and Aedes aegypti larvae. Especially, S. buxifolium leaf essential oil strongly inhibited Ae. aegypti larvae with 24 and 48 h LC50 values of 6.73 and 6.73 µg/mL, respectively, and 24 and 48 h LC90 values of 13.37 and 10.83 µg/mL, respectively. These findings imply that Vietnamese Syzygium essential oils might have potential for use as supplemental antibacterial agents or as "green" alternatives for the control of mosquitoes.

Asunto(s)

RESUMEN

A chemical investigation of K. heteroclite led to isolation of two new dibenzocyclooctadienes (1 and 2) together with 14 known compounds (3-16) by using multiple chromatographic techniques. New compounds (1 and 2) were obtained and identified by spectroscopic methods (HR-ESI-MS, 1D and 2D NMR, and ECD) as well as by comparison of their experimental data with those reported in the literatures. All the isolates were evaluated for their ability to modulate TNF-α production in lipopolysaccharide (LPS) stimulated RAW264.7 cells. Among them, compound 5 displayed the most inhibition against tumor necrosis factor (TNF)-α production with IC50 value of 6.16±0.14 µM. Whereas, compounds (1, 3, and 6) showed the significant inhibition (IC50 values ranging from 9.41 to 14.54 µM), and compounds (2, 4, 9, 10, 13, 15, and 16) exhibited moderate inhibition (IC50 values ranging from 19.27 to 40.64 µM) toward TNF-α production, respectively.

Asunto(s)

Asunto(s)

RESUMEN

Eight polythiophene derivatives containing pyrazoline side groups were synthesized by a chemical oxidative coupling polymerization using FeCl3. The crystal structures of four monomers were determined which confirm the almost perpendicular orientation of the thiophene and pyrazoline rings, while the other substituents are more coplanar. Analyses of IR, 1H-NMR, Raman and UV-Vis spectra demonstrated that the suggested polymerization was successful to generate the synthesized polythiophenes with the expected structures. The morphology of the synthesized polythiophenes was studied by SEM. The different substituents attached to the 1- and 3-positions of the pyrazoline side chain led to differences in optical properties, electrical conductivity, and thermal stability of the synthesized polythiophenes. By adding a pyrazoline side chain to polythiophenes, some polymers achieve good solubility, electrical conductivity of about 1.3 × 10-6 S/cm, high fluorescence intensity (above 40,000 a.u.) at 505-550 nm and thermal stability up to 590°C in the air.

RESUMEN

: This paper analyzes the nonlinear buckling and post-buckling characteristics of the porous eccentrically stiffened functionally graded sandwich truncated conical shells resting on the Pasternak elastic foundation subjected to axial compressive loads. The core layer is made of a porous material (metal foam) characterized by a porosity coefficient which influences the physical properties of the shells in the form of a harmonic function in the shell's thickness direction. The physical properties of the functionally graded (FG) coatings and stiffeners depend on the volume fractions of the constituents which play the role of the exponent in the exponential function of the thickness direction coordinate axis. The classical shell theory and the smeared stiffeners technique are applied to derive the governing equations taking the von Kármán geometrical nonlinearity into account. Based on the displacement approach, the explicit expressions of the critical buckling load and the post-buckling load-deflection curves for the sandwich truncated conical shells with simply supported edge conditions are obtained by applying the Galerkin method. The effects of material properties, core layer thickness, number of stiffeners, dimensional parameters, semi vertex angle and elastic foundation on buckling and post-buckling behaviors of the shell are investigated. The obtained results are validated by comparing with those in the literature.

RESUMEN

Two new drimane-type compounds, nigrofomins A ( 1) and B ( 2), possessing a rare dioxabicyclooctane moiety, were purified from the fruiting bodies of Nigrofomes melanoporus. Their structures were determined using 1D-, 2D-NMR and HR-ESI-MS spectroscopic analyses. In addition, 1 was established by X-ray crystallographic studies. Both nigrofomins A ( 1) and B ( 2) exhibited cytotoxicity on acute T-cell leukemia (Jurkat), human nasopharyngeal carcinoma (NPC-TW01), and lung cancer (NCI-H661) cells with IC (50) values in the range of 99.44-246.32 µM. Furthermore, the effects of 1 and 2 on cell-cycle progression of Jurkat cells displayed a concentration-dependent accumulation in the G (0)/G (1) phase.

Asunto(s)

RESUMEN

The surface structure of liquid and amorphous aluminosilicate nanoparticles of composition Al(2)O(3)·2SiO(2) has been investigated in a model of different sizes ranging from 2.0 to 5.0 nm with the Born-Mayer type pair potential under non-periodic boundary conditions. Models have been obtained by cooling from the melts at a constant density of 2.6 g cm(-3) via molecular dynamics (MD) simulation. The surface structure has been investigated via the coordination number, bond-angle distributions and structural point defects. Calculations show that surface effects on surface static and thermodynamic properties of models are significant according to the change in the number of Al atoms in the surface layers. Evolution of the local environment of oxygen in the surface shell of nanoparticles upon cooling from the melt toward the glassy state was also found and discussed. In addition, the nanosize dependence of the glass transition temperature was presented.