RESUMO
The use of semiconductors for bacterial photoinactivation is a promising approach that has attracted great interest in wastewater remediation. The photoinactivator Cu-TTC/ZTO/TO was synthesized by the solvothermal method from the coordination complex Cu(C3H3N3S3)3 (Cu-TTC) and the hybrid semiconductor ZnTiO3/TiO2 (ZTO/TO). In this study, the effect of photocatalyst composition/concentration as well as radiation intensity on the photoinactivation of the gram-negative bacteria Escherichia coli and the gram-positive bacteria Staphylococcus aureus in aqueous solutions was investigated. The results revealed that 25 mg/mL of photoinactivator, in a Cu-TTC:ZTO/TO molar ratio of 1:2 (w/w%) presents a higher rate of bacterial photoinactivation under simulated solar light (λ = 300-800 nm) in comparison to the individual components. The evidence of this study suggests that the presence of the Cu(C3H3N3S3)3 coordination complex in the ZnTiO3/TiO2 hybrid semiconductor would contribute to the generation of reactive oxygen species (ROS) that are essential to initiate the bacterial photoinactivation process. Finally, the results obtained allow us to predict that the Cu-TTC/ZTO/TO photocatalyst could be used for effective bacterial inactivation of E. coli and S. aureus in aqueous systems under simulated solar light.
RESUMO
The use of ultraviolet (UV) and blue irradiation to sterilize surfaces is well established, but commercial applications would be enhanced if the light source is replaced with ambient light. In this paper, it is shown that nanofibers can be explored as an alternative methodology to UV and blue irradiation for bacterial inactivation. It is demonstrated that this is indeed possible using spun nanofibers of poly[lactic-co-(glycolic acid)] (PLGA). This work shows that PLGA spun scaffolds can promote photoinactivation of Staphylococcus aureus and Escherichia coli bacteria with ambient light or with laser irradiation at 630 nm. With the optimized scaffold composition of PLGA85:15 nanofibers, the minimum intensity required to kill the bacteria is much lower than in antimicrobial blue light applications. The enhanced effect introduced by PLGA scaffolds is due to their nanofiber structures since PLGA spun nanofibers were able to inactivate both S. aureus and E. coli bacteria, but cast films had no effect. These findings pave the way for an entirely different method to sterilize surfaces, which is less costly and environmentally friendly than current procedures. In addition, the scaffolds could also be used in cancer treatment with fewer side effects since photosensitizers are not required.