RESUMO
The present work aims to evaluate the treatment of the effluent from the textile industry via advanced oxidative processes of photo-Fenton assisted by different sources (natural sunlight, UV-A or visible LED lamps). To identify the best operating conditions, a factorial design was carried out for each process. It was observed that after the optimization of the processes, chemical oxygen demand (COD) removals greater than 88% were achieved. In addition, it was observed that the use of the LED lamp required lower reagent concentrations compared to solar and UV-A sources. A kinetic study was carried out under the best conditions obtained and it was observed that the sources showed rapid evolution, reaching a COD removal equilibrium with 30 min of reaction. Reagent monitoring was also carried out, and it was observed that they were not limiting to the reaction. Phytotoxicity analysis was also satisfactory since the treated effluents allowed a higher relative growth and germination index of the cucumber roots compared to the raw effluent. Finally, the cost analysis indicated that the use of LED lamps resulted in a reduction in electrical consumption compared to the UV-A lamp, as well as a reduction in the cost of reagents due to the lower concentration of reagents required compared to processes assisted by natural sunlight and UV-A.
Assuntos
Águas Residuárias , Poluentes Químicos da Água , Peróxido de Hidrogênio , Cinética , Oxirredução , Luz Solar , Têxteis , Raios Ultravioleta , Eliminação de Resíduos LíquidosRESUMO
Multilayer graphene oxide (mGO) was synthesized and functionalized via co-precipitation method to produce magnetic Fe3O4-functionalized multilayer graphene oxide nanocomposite (MmGO). Photocatalytic properties of MmGO were investigated in the photodegradation of raw textile wastewater samples. Fourier-transformed infrared spectroscopy revealed Fe-O vibrations, characterized by the band shift from 636.27 to 587.25 cm-1 on MmGO. X-ray diffraction confirmed the successful oxidation of graphite by the (002) peak at 10° and indicated the presence of Fe3O4 on MmGO surface by the peaks at 2θ 35.8° (311), 42.71° (400), 54.09° (511), and 62.8° (440). There was no detection of coercivity field and remnant magnetization, evidencing a material with superparamagnetic properties. Then, the textile effluent was treated by heterogeneous photo-Fenton (HPF) reaction. A 22 factorial design was conducted to evaluate the effects of MmGO dosage and H2O2 concentration on HPF, with color and turbidity removal as response variables. The kinetic behavior of the adsorption and HPF processes was investigated separately, in which, the equilibrium was reached within 60 and 120 min, for adsorption and HPF, respectively. Pseudo-second-order model exhibited the best fit, with COD uptake capacity at equilibrium of 4094.94 mg g-1, for chemical oxygen demand. The modeling of kinetics data showed that the Chan and Chu model was the most representative for HPF, with initial removal rate of 95.52 min-1. The removal of organic matter was 76.36% greater than that reached by conventional treatment at textile mills. The presence of Fe3O4 nanoparticles attached to MmGO surface was responsible for the increase of electron mobility and the enhancement of its photocatalytic properties. Finally, MmGO presented low phytotoxic to Cucumis sativus L. with a RGI of 0.53. These results bring satisfactory perspectives regarding further employment, on large scale, of MmGO as nanocatalyst of textile pollutants.
Assuntos
Grafite , Poluentes Químicos da Água , Adsorção , Peróxido de Hidrogênio , Cinética , Têxteis , Águas ResiduáriasRESUMO
The dyes used in textile industries are usually difficult to degrade in aquatic environments, being highly toxic to micro fauna and flora. Thus, textile wastewater treatments have been developed, among them, one that stands out is adsorption process. With the rise of nanomaterials applied to adsorption, graphene oxide (GO) shows promise in the removal of dyes. This work aimed to produce a more economical and environmentally friendly GO by reducing H2SO4 concentration during the synthesis. Adsorption tests were performed with methylene blue (MB) and brilliant blue (BB), adsorbent regeneration tests, as well as a kinetic study using real wastewater, and toxicological assays with lettuce seeds. Results showed that the sample produced with less H2SO4 (GO-21) performed better for MB (99% removal) and BB (29% removal); and recycling test showed that despite the decrease in removal efficiency, it remained high in the first cycles. Kinetics showed that equilibrium was reached in 30 min, removing 67.43% of color and 90.23% of the effluent's turbidity. Phytotoxicity assays indicated that the wastewater treated with GO-21 was the least toxic, compared to other wastewater samples analyzed. Therefore, GO has demonstrated its potential to be an effective and less toxic option to treat textile effluents.[Formula: see text].
Assuntos
Corantes/isolamento & purificação , Grafite/síntese química , Lactuca/efeitos dos fármacos , Águas Residuárias/toxicidade , Poluentes Químicos da Água/isolamento & purificação , Purificação da Água/métodos , Adsorção , Cor , Corantes/química , Biomarcadores Ambientais/efeitos dos fármacos , Grafite/química , Cinética , Indústria Têxtil , Águas Residuárias/química , Poluentes Químicos da Água/químicaRESUMO
An upflow anaerobic sludge blanket (UASB)-submerged aerated biofilter (SAB) system was evaluated to remove color and chemical oxygen demand (COD) from real textile effluent. The system was operated for 335 days in three phases (P-1, P-2, P-3) with total hydraulic retention time varying from 21 h to 14 h. The results showed that high sulfate levels (>300 mg SO4(2-)/L) impaired the dye reduction. The best color removal efficiencies of 30% and 96% for the UASB and the reactor system, respectively, were obtained in P-1; the SAB higher efficiency was associated with adsorption. The best COD removal efficiency of 71% for the reactor system was obtained in P-2. Precipitation of some material composed mostly of sulfur (98%) and some metals occurred in the UASB. However, the precipitated sulfur was again oxidized in the SAB. The system also showed an effective toxicity reduction in tests (Daphnia magna) with the treated effluent.