RESUMO

The sarcoendoplasmic reticulum Ca2+-ATPase (SERCA) is a membrane protein that is destabilized during purification in the absence of calcium ions. The disaccharide trehalose is a protein stabilizer that accumulates in the yeast cytoplasm when under stress. In the present work, SERCA was purified by including trehalose in the purification protocol. The purified SERCA showed high protein purity (~95%) and ATPase activity. ATP hydrolysis was dependent on the presence of Ca2+ and the enzyme kinetics showed a hyperbolic dependence on ATP (Km = 12.16 ± 2.25 µM ATP). FITC labeling showed the integrity of the ATP-binding site and the identity of the isolated enzyme as a P-type ATPase. Circular dichroism (CD) spectral changes at a wavelength of 225 nm were observed upon titration with ATP, indicating α-helical rearrangements in the nucleotide-binding domain (N-domain), which correlated with ATP affinity (Km). The presence of Ca2+ did not affect FITC labeling or the ATP-mediated structural changes at the N-domain. The use of trehalose in the SERCA purification protocol stabilized the enzyme. The isolated SERCA appears to be suitable for structural and ligand binding studies, e.g., for testing newly designed or natural inhibitors. The use of trehalose is recommended for the isolation of unstable enzymes.

RESUMO

Immobilization of lipase from Burkholderia gladioli BRM58833 on octyl sepharose (OCT) resulted in catalysts with higher activity and stability. Following, strategies were studied to further stabilize and secure the enzyme to the support using functionalized polymers, like polyethylenimine (PEI) and aldehyde-dextran (DEXa), to cover the catalyst with layers at different combinations. Alternatively, the construction of a bifunctional layer was studied using methoxypolyethylene glycol amine (NH 2 -PEG) and glycine. The catalyst OCT-PEI-DEXa was the most thermostable, with a 263.8-fold increase in stability when compared to the control condition. When evaluated under alkaline conditions, OCT-DEXa-PEG 10 /Gly was the most stable, reaching stability 70.1 times greater than the control condition. Proportionally, the stabilization obtained for B. gladioli BRM58833 lipase was superior to that obtained for the commercial B. cepacia lipase. Preliminary results in the hydrolysis of fish oil demonstrated the potential of the coating technique with bifunctional polymers, resulting in a stable catalyst with greater catalytic capacity for the production of omega-3 PUFAs. According to the results obtained, it is possible to modulate B. gladioli BRM58833 lipase properties like stability and catalytic activity for enrichment of omega-3 fatty acids.

RESUMO

The use of enzymes in industrial processes requires the improvement of their features in many instances. Enzyme immobilization, a requirement to facilitate the recovery and reuse of these water-soluble catalysts, is one of the tools that researchers may utilize to improve many of their properties. This review is focused on how enzyme immobilization may improve enzyme stability. Starting from the stabilization effects that an enzyme may experience by the mere fact of being inside a solid particle, we detail other possibilities to stabilize enzymes: generation of favorable enzyme environments, prevention of enzyme subunit dissociation in multimeric enzymes, generation of more stable enzyme conformations, or enzyme rigidification via multipoint covalent attachment. In this last point, we will discuss the features of an "ideal" immobilization protocol to maximize the intensity of the enzyme-support interactions. The most interesting active groups in the support (glutaraldehyde, epoxide, glyoxyl and vinyl sulfone) will be also presented, discussing their main properties and uses. Some instances in which the number of enzyme-support bonds is not directly related to a higher stabilization will be also presented. Finally, the possibility of coupling site-directed mutagenesis or chemical modification to get a more intense multipoint covalent immobilization will be discussed.

Assuntos

RESUMO

Attainment of a stable and highly active ß-xylosidase is of major importance for the efficient and cost-competitive hydrolysis of hemicellulose xylan, as well as for its industrial conversion into biofuels and biochemicals. Here, a recombinant ß-xylosidase of the glycoside hydrolase family (GH43) from Bacillus subtilis was produced in Escherichia coli culture, purified, and subsequently immobilized on agarose and chitosan. Glutaraldehyde and glyoxyl groups were evaluated as activating agents to select the most efficient derivative. Multi-point immobilization on agarose led to an extraordinary thermal stability (half-lives 3604 and 164-fold higher than the free enzyme, at 50° and 35 °C, respectively). Even for chitosan activated with glutaraldehyde, a low-cost support, thermal stability of the immobilized enzyme was 326 and 12-fold higher than the free enzyme at 50° and 35°C, respectively. Immobilized enzymes showed no release of any subunit for the agarose-glyoxyl derivative, and only a few ones for the support activated with glutaraldehyde. Most remarkably, the enzyme kinetic behavior after immobilization increased up to 4-fold in relation to the free one. ß-xylosidase, a tetrameric enzyme with four identical subunits, exists in equilibrium between the monomeric and oligomeric forms in solution. Depending on the pH of immobilization, the enzyme oligomerization can be favored, thus explaining the hyperactivation phenomenon. Both glyoxyl-agarose and chitosan-glutaraldehyde derivatives were used to catalyze corncob xylan hydrolysis, reaching 72 % conversion, representing a xylose productivity of around 20 g L-1 h-1. After ten 4h-cycles (pH 6.0, 35 °C), the xylan-to-xylose conversion remained approximately unchanged. Therefore, the immobilized ß-xylosidases prepared in this work can be of great interest as biocatalysts in a biorefinery context.

Assuntos

RESUMO

Attainment of a stable and highly active β-xylosidase is of major importance for the efficient and cost-competitive hydrolysis of hemicellulose xylan, as well as for its industrial conversion into biofuels and biochemicals. Here, a recombinant β-xylosidase of the glycoside hydrolase family (GH43) from Bacillus subtilis was produced in Escherichia coli culture, purified, and subsequently immobilized on agarose and chitosan. Glutaraldehyde and glyoxyl groups were evaluated as activating agents to select the most efficient derivative. Multi-point immobilization on agarose led to an extraordinary thermal stability (half-lives 3604 and 164-fold higher than the free enzyme, at 50° and 35 °C, respectively). Even for chitosan activated with glutaraldehyde, a low-cost support, thermal stability of the immobilized enzyme was 326 and 12-fold higher than the free enzyme at 50° and 35°C, respectively. Immobilized enzymes showed no release of any subunit for the agarose-glyoxyl derivative, and only a few ones for the support activated with glutaraldehyde. Most remarkably, the enzyme kinetic behavior after immobilization increased up to 4-fold in relation to the free one. β-xylosidase, a tetrameric enzyme with four identical subunits, exists in equilibrium between the monomeric and oligomeric forms in solution. Depending on the pH of immobilization, the enzyme oligomerization can be favored, thus explaining the hyperactivation phenomenon. Both glyoxyl-agarose and chitosan-glutaraldehyde derivatives were used to catalyze corncob xylan hydrolysis, reaching 72 % conversion, representing a xylose productivity of around 20 g L−1 h−1. After ten 4h-cycles (pH 6.0, 35 °C), the xylan-to-xylose conversion remained approximately unchanged. Therefore, the immobilized β-xylosidases prepared in this work can be of great interest as biocatalysts in a biorefinery context.

RESUMO

ß-Glucosidases from two different commercial preparations, Pectinex Ultra SP-L and Celluclast® 1.5L, were immobilized on divinylsulfone (DVS) supports at pH 5.0, 7.0, 9.0, and 10. In addition, the biocatalysts were also immobilized in agarose beads activated by glyoxyl, and epoxide as reagent groups. The best immobilization results were observed using higher pH values on DVS-agarose, and for Celluclast® 1.5L, good results were also obtained using the glyoxil-agarose immobilization. The biocatalyst obtained using Pectinex Ultra SP-L showed the highest thermal stability, at 65°C, and an operational stability of 67% of activity after 10 reuses cycles when immobilized on DVS-agarose immobilized at pH 10 and blocked with ethylenediamine. The ß-glucosidase from Celluclast® 1.5L produced best results when immobilized on DVS-agarose immobilized at pH 9 and blocked with glycine, reaching 7.76-fold higher thermal stability compared to its free form and maintaining 76% of its activity after 10 successive cycles. The new biocatalysts obtained by these protocols showed reduction of glucose inhibition of enzymes, demonstrating the influence of immobilization protocols, pH, and blocking agent.

Assuntos

RESUMO

Three ß-glucosidases (Pectinex Ultra SP-L, Pectinex Ultra Clear and homemade preparation from Aspergillus niger) were immobilized using different strategies: ionic adsorption on aminated (MANAE)-agarose beads at pH 5, 7, and 9, followed by biocatalysts modification with glutaraldehyde, or on glutaraldehyde pre-activated supports. The pH of the immobilization was altered to allow different enzyme molecule orientations on the support surface. The biocatalysts from Pectinex Ultra SP-L showed the highest thermal and operational stabilities when immobilized on MANAE-agarose-glutaraldehyde at pH 7. The ß-glucosidase from Pectinex Ultra Clear and from A. niger produced best results when immobilized on MANAE-agarose beads at pH 5 and 7, respectively, which was later treated with glutaraldehyde. The best immobilization results using pre-activated supports were observed for the enzyme present in Pectinex Ultra SP-L, to which the highest thermal stabilities were obtained. Remarkably, the enzyme from A. niger, immobilized on MANAE-agarose at pH 9 and subsequently treated with glutaraldehyde, produced the highest stabilization (approximately 560 times more stable than soluble enzyme at 60 °C). Results showed that optimal protocol for ß-glucosidases immobilizations using the glutaraldehyde chemistry must be individually tested and tailored to each type of enzyme.

Assuntos

RESUMO

Lipases are promising enzymes that catalyze the hydrolysis of triacylglycerol ester bonds at the oil/water interface. Apart from allowing biocatalyst reuse, immobilization can also affect enzyme structure consequently influencing its activity, selectivity, and stability. The lipase from Penicillium sp. section Gracilenta (CBMAI 1583) was successfully immobilized on supports bearing butyl, phenyl, octyl, octadecyl, and divinylbenzyl hydrophobic moieties wherein lipases were adsorbed through the highly hydrophobic opened active site. The highest activity in aqueous medium was observed for the enzyme adsorbed on octyl support, with a 150% hyperactivation regarding the soluble enzyme activity, and the highest adsorption strength was verified with the most hydrophobic support (octadecyl Sepabeads), requiring 5% Triton X-100 to desorb the enzyme from the support. Most of the derivatives presented improved properties such as higher stability to pH, temperature, and organic solvents than the covalently immobilized CNBr derivative (prepared under very mild experimental conditions and thus a reference mimicking free-enzyme behavior). A 30.8- and 46.3-fold thermostabilization was achieved in aqueous medium, respectively, by the octyl Sepharose and Toyopearl butyl derivatives at 60 °C, in relation to the CNBr derivative. The octyl- and phenyl-agarose derivatives retained 50% activity after four and seven cycles of p-nitrophenyl palmitate hydrolysis, respectively. Different derivatives exhibited different properties regarding their properties for fish oil hydrolysis in aqueous medium and ethanolysis in anhydrous medium. The most active derivative in ethanolysis of fish oil was the enzyme adsorbed on a surface covered by divinylbenzyl moieties and it was 50-fold more active than the enzyme adsorbed on octadecyl support. Despite having identical mechanisms of immobilization, different hydrophobic supports seem to promote different shapes of the adsorbed open active site of the lipase and hence different functional properties.

Assuntos

RESUMO

In this review, we detail the efforts performed to couple the purification and the immobilization of industrial enzymes in a single step. The use of antibodies, the development of specific domains with affinity for some specific supports will be revised. Moreover, we will discuss the use of domains that increase the affinity for standard matrices (ionic exchangers, silicates). We will show how the control of the immobilization conditions may convert some unspecific supports in largely specific ones. The development of tailor-made heterofunctional supports as a tool to immobilize-stabilize-purify some proteins will be discussed in deep, using low concentration of adsorbent groups and a dense layer of groups able to give an intense multipoint covalent attachment. The final coupling of mutagenesis and tailor made supports will be the last part of the review.

Assuntos

RESUMO

Lecitase Ultra has been immobilized on cyanogen bromide agarose (via covalent attachment) and on octyl agarose (via physical adsorption on the hydrophobic support by interfacial activation). Both immobilized preparations have been incubated in dextran sulfate (DS) or polyethylenimine (PEI) solutions to coat the enzyme surface. Then, the activity versus different substrates and under different experimental conditions was evaluated. The PEI coating generally produced a significant increase in enzyme activity, in some cases even by more than a 30-fold factor (using the octyl-Lecitase at pH 5 in the hydrolysis of methyl phenyl acetate). In opposition, the DS coating usually produced some negative effects on the enzyme activity. The rate of irreversible inhibition of the covalent preparation using diethyl p-nitrophenylphosphate did not increase after PEI coating suggesting that the increase in Lecitase activity is not a consequence of the stabilization of the open form of Lecitase. Moreover, the coating greatly increased the stability of the immobilized Lecitase, for example using DS and the covalent preparation, the half-life was increased by a 30-fold factor in 30% acetonitrile. The stabilizing effect was not found in all cases, in certain cases even a certain destabilization is found (e.g., octyl-Lecitase-DS at pH 7). Thus, the effects of the ionic polymer coating strongly depend on the substrate, experimental conditions and immobilization technique employed.

Assuntos