RESUMO

OBJECTIVE: This study assessed whether combining photobiomodulation therapy (PBMT) with casein phosphopeptide-amorphous calcium phosphate fluoride (CPP-ACPF) paste can effectively reduce post-home whitening tooth sensitivity (TS) without compromising shade change. METHODS: Fifty participants were selected and assigned to one of four groups: (1) PLACEBO group-received a placebo paste and PBMT simulation; (2) PBMT group-received a placebo paste + PBMT; (3) CPP-ACPF group-received CPP-ACPF paste and PBMT simulation; (4) CPP-ACPF + PBMT group-received both CPP-ACPF paste and PBMT. The participants used whitening trays containing 22% carbamide peroxide for 2 h a day for 21 days. TS was measured daily using a visual analog scale, while shade change was assessed using a spectrophotometer: before bleaching treatment (T0), after the first (T1), second (T2), and third (T3) weeks of treatment, and 30 days (T4) after completing the whitening treatment. RESULTS: Intragroup analysis revealed that the PLACEBO group had the highest increase in sensitivity during the whitening treatment. The CPP-ACPF and PBMT groups showed no significant difference tooth whitening (TW) between weeks regarding aesthetic change. The CPP-ACPF and PBMT group exhibited a significant reduction in TS between the first and third and between the second and third weeks TW, but not between the first and second. Conversely, the PLACEBO group showed a higher sensitivity than the other groups (p < .05). The CPP-ACPF and PBMT groups did not differ from each other. Furthermore, the CPP-ACPF and PBMT group showed a greater decrease in sensitivity than the PLACEBO group at T1, T2, and T3 (p < .01), and was significantly differed from CPP-ACPF and PBMT groups only at T2 and T3. All groups confirmed TW effectiveness. Student's and paired t-test did not reveal any significant difference between groups (p > .05). CONCLUSION: Therefore, PBMT associated with CPP-ACPF paste can reduce TS without compromising the efficacy of TW.

Assuntos

RESUMO

This study evaluated the influence of formulation and thermal treatment on the degree of conversion, fracture toughness, flexural strength, and elastic modulus of experimental composites. Six composites were analyzed at BisGMA : TEGDMA molar ratios of 1 : 1 and 7 : 3 with filler at 30, 50, and 70 wt%. The degree of conversion was analyzed by Fourier transform infrared spectroscopy, fracture toughness was measured using the single-edge notched beam, and flexural strength and elastic modulus were measured with the 3-point bend test. For all tests, one-half of the specimens received thermal treatment at 170°C for 10 min. Data were analyzed by the Kruskal-Wallis or ANOVA/Tukey's test (α = 5%). The 1 : 1 BisGMA : TEGDMA ratio showed higher properties than the 7 : 3 ratio. Although the material with 70% filler had a conversion lower than the one with 50%, it showed higher mechanical properties. The thermal treatment improved all properties in all materials. Therefore, the use of an equimolar ratio of BisGMA : TEGDMA can be paired with 70 wt% filler to design dental composites that possess increased advantageous physical and chemical properties. Furthermore, the simple and low-cost method of thermal treatment proposed for use in clinical dentistry has been shown to effectively improve the properties of all evaluated materials.

Assuntos

RESUMO

AIM: Evaluate in situ the effect of nanohydroxyapatite paste (nano-HAP) before bleaching with hydrogen peroxide 35% (HP35%) by ion chromatography (IC) Knoop hardness number (KHN) and tristimulus colorimetry (TC). MATERIALS AND METHODS: A total of 60 fragments were obtained from third molars included (3 mm × 3 mm × 3 mm) and the specimens were divided into three groups (n = 20): Gas chromatography (CG) (negative control group) = no bleaching; HP35% (positive control group) = HP35% whitening (whiteness HP35%); nano-HAP = application for 10 minutes before bleaching treatment + HP35%. The specimens were fixed to the volunteers' molars. The KHN and TC were measured before and after bleaching. For IC, the dentin layer was removed, leaving the enamel that was crushed, and autoclaved for chemical quantification (calcium, fluorine, and phosphorus). The results of KHN and TC were analyzed statistically by analysis of variance (ANOVA) followed by Tukey test (p < 0.05). RESULTS: The HP35% group showed reduction of the Ca, F, and P ions. The initial and final KHN mean of the CG and nano-HAP did not differ statistically; however, the group of HP35% did differ statistically. The mean ΔE of the HP35% and nano-HAP groups did not differ statistically from each other. However, they differed from the CG. CONCLUSION: The nano-HAP paste preserved the KHN, promoted the lower loss of Ca and P ions and an increase of F ions when compared with the CG, but did not influence the effectiveness of the bleaching treatment. CLINICAL SIGNIFICANCE: Nano-HA is a biomaterial that has shown positive results in the prevention of deleterious effects on the enamel by the action of the office bleaching treatment.

Assuntos

RESUMO

OBJECTIVE: We evaluated the effects of internal bleaching on the adhesion of glass-fiber posts (GFPs) luted with different resin cements. METHODS: Forty extracted human single-root teeth were endodontically treated and divided into four groups (n=10): G1- conventional resin cement (CRC); G2- self-adhesive resin cement (SARC); G3- bleaching + CRC; and G4- bleaching + SARC. Specimens were sectioned transversally into three slices to perform the push-out test at the coronal, middle and apical regions of the root canals. Data were analyzed using analysis of variance and Tukey's test (p<0.05). RESULTS: The push-out bond strength of GFPs luted with SARC after bleaching (G4) was significantly lower than that of the other groups (p<0.001). We found no statistically significant differences in push-out bond strength among the other groups. SIGNIFICANCE: Internal bleaching reduced the adhesion of GFPs luted with SARC. The adhesion of GFPs luted with CRC was not decreased after bleaching.

RESUMO

The effect of bleaching treatments containing added calcium and combined with neutral or acidic fluoride gels on tooth enamel was investigated in vitro through Knoop microhardness (KHN) and surface roughness (SR) measurements. A total of 60 bovine incisors were tested, including 30 for SR measurements and 30 for KHN measurements. The specimens were divided into 12 groups and subjected to a bleaching agent with hydrogen peroxide 35% (Whiteness HP 35% Maxx, FGM) or hydrogen peroxide 35% with calcium (Whiteness HP 35% Blue Calcium, FGM) and a fluoride treatment flugel acidulated phosphate fluoride (APF) or flugel neutral fluoride (NF). Control specimens were submitted to bleaching treatments without fluoride. Microhardness tests were performed using a Knoop indentor. Roughness measurements were obtained using a roughness analyzer. Measurements were obtained before and after treatment. The specimens were stored in distilled water at 37 °C between treatments. The results were analyzed using descriptive and inferential statistics. Treatments using APF combined with 35% HP caused a decrease in microhardness, while NF combined with HP 35% Ca increased the enamel hardness. Fluoride gels did not alter the SR of the bleached enamel.