RESUMEN

In this work, chitosan chains were crosslinked with different contents of vanillin (Van), characterized and loaded with curcumin (CUR), a hydrophobic drug. Sodium dodecyl sulfate (SDS), Tween 20® (T20) and ß-cyclodextrin (ßCD) were used as curcumin carriers. Films prepared with Van 20 % yielded gel content of 70 %, swelling degree of ~23 gwater/g, bound water and capillary water, as revealed by Time-Domain Nuclear Magnetic Resonance measurements. Films prepared with higher Van contents showed small swelling degree (< 1.6 gwater/g) and hydrophobicity, making them inadequate for drug loading. UV-Vis and fluorescence spectroscopic studies indicated that Van 20 % combined with SDS and SDS/ßCD presented the highest CUR uptake (~3.0 mg/g), favored by electrostatic interactions and hydrophobic interactions. CHI and Van 20 % films did not present any cytotoxicity in human neuroblastoma SH-SY5Y cells. At pH 1.0 the films were completely soluble, pointing to their potential application as gastric delivery systems for hydrophobic drugs. Chemical compounds studied in the manuscript: Chitosan, vanillin, curcumin, ß-cyclodextrin, sodium dodecyl sulfate, polyethylene glycol sorbitan monolaurate.

Asunto(s)

RESUMEN

BACKGROUND: A high-fiber emulsion gel (EG) containing inulin, soy protein isolate, and soybean oil was applied as animal fat replacer in reduced salt and fat Bologna sausage containing mechanically deboned chicken meat, pork meat, and pork back fat. Technological and microbiological properties were evaluated for 60 days at 4 °C. RESULTS: A reduction of 11 to 34% and 35 to 45% of fat and sodium were obtained in reformulated products, respectively. An increase in fiber content and polyunsaturated fatty acid was noticed in the formulations with EG. The addition of EG in Bologna increased L* (lightness) values and reduced a* (redness/greenness) values comparing to control treatment. Microstructural properties of sausages exhibited a denser network with the presence of EG. Softer, more elastic, cohesive and resilient samples with a higher intensity of lipid oxidation (P < 0.05) were observed in EG added sausages. The nuclear magnetic resonance (NMR) data shows that the presence of EG recovers the matrix that has been weakened due to reduction of fat and salt. Sensory evaluation showed that the incorporation of the EGs resulted in acceptable scores. CONCLUSION: These results suggest that inulin-based EG is a potential fat substitute for developing healthier meat products, with better fatty acids composition and stable to chilled storage. © 2020 Society of Chemical Industry.

Asunto(s)

RESUMEN

Tryptophan (Trp) decorated hydroxypropyl methylcellulose (HPMC) cryogels were prepared by a one-step reaction with citric acid. The increase of Trp content in the 3D network from 0 to 2.18 wt% increased the apparent density from 0.0267 g.cm-3 to 0.0381 g.cm-3 and the compression modulus from 94 kPa to 201 kPa, due to hydrophobic interactions between Trp molecules. The increase of Trp content in HPMC-Trp hydrogels increased the amount of non-freezing water, estimated from differential scanning calorimetry, and the amount of freezing water, which was determined by time-domain nuclear magnetic resonance. The adsorption capacity of methylene blue (MB) and rhodamine B (RB) on HPMC-Trp hydrogels increased with Trp content and the amount of freezing water. HPMC-Trp hydrogels could be recycled 6 times keeping the original adsorptive capacity. The diffusional constants of MB and RB tended to increase with Trp content. RB adsorbed on HPMC-Trp hydrogels presented a bathochromic shift of fluorescence.

RESUMEN

Exploitation of plant lignocellulosic biomass is hampered by our ignorance of the molecular basis for its properties such as strength and digestibility. Xylan, the most prevalent non-cellulosic polysaccharide, binds to cellulose microfibrils. The nature of this interaction remains unclear, despite its importance. Here we show that the majority of xylan, which forms a threefold helical screw in solution, flattens into a twofold helical screw ribbon to bind intimately to cellulose microfibrils in the cell wall. 13C solid-state magic-angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopy, supported by in silico predictions of chemical shifts, shows both two- and threefold screw xylan conformations are present in fresh Arabidopsis stems. The twofold screw xylan is spatially close to cellulose, and has similar rigidity to the cellulose microfibrils, but reverts to the threefold screw conformation in the cellulose-deficient irx3 mutant. The discovery that induced polysaccharide conformation underlies cell wall assembly provides new principles to understand biomass properties.

Asunto(s)

RESUMEN

BACKGROUND: Heavy usage of gasoline, burgeoning fuel prices, and environmental issues have paved the way for the exploration of cellulosic ethanol. Cellulosic ethanol production technologies are emerging and require continued technological advancements. One of the most challenging issues is the pretreatment of lignocellulosic biomass for the desired sugars yields after enzymatic hydrolysis. We hypothesized that consecutive dilute sulfuric acid-dilute sodium hydroxide pretreatment would overcome the native recalcitrance of sugarcane bagasse (SB) by enhancing cellulase accessibility of the embedded cellulosic microfibrils. RESULTS: SB hemicellulosic hydrolysate after concentration by vacuum evaporation and detoxification showed 30.89 g/l xylose along with other products (0.32 g/l glucose, 2.31 g/l arabinose, and 1.26 g/l acetic acid). The recovered cellulignin was subsequently delignified by sodium hydroxide mediated pretreatment. The acid-base pretreated material released 48.50 g/l total reducing sugars (0.91 g sugars/g cellulose amount in SB) after enzymatic hydrolysis. Ultra-structural mapping of acid-base pretreated and enzyme hydrolyzed SB by microscopic analysis (scanning electron microcopy (SEM), transmitted light microscopy (TLM), and spectroscopic analysis (X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, Fourier transform near-infrared (FT-NIR) spectroscopy, and nuclear magnetic resonance (NMR) spectroscopy) elucidated the molecular changes in hemicellulose, cellulose, and lignin components of bagasse. The detoxified hemicellulosic hydrolysate was fermented by Scheffersomyces shehatae (syn. Candida shehatae UFMG HM 52.2) and resulted in 9.11 g/l ethanol production (yield 0.38 g/g) after 48 hours of fermentation. Enzymatic hydrolysate when fermented by Saccharomyces cerevisiae 174 revealed 8.13 g/l ethanol (yield 0.22 g/g) after 72 hours of fermentation. CONCLUSIONS: Multi-scale structural studies of SB after sequential acid-base pretreatment and enzymatic hydrolysis showed marked changes in hemicellulose and lignin removal at molecular level. The cellulosic material showed high saccharification efficiency after enzymatic hydrolysis. Hemicellulosic and cellulosic hydrolysates revealed moderate ethanol production by S. shehatae and S. cerevisiae under batch fermentation conditions.

RESUMEN

BACKGROUND: The search for promising and renewable sources of carbohydrates for the production of biofuels and other biorenewables has been stimulated by an increase in global energy demand in the face of growing concern over greenhouse gas emissions and fuel security. In particular, interest has focused on non-food lignocellulosic biomass as a potential source of abundant and sustainable feedstock for biorefineries. Here we investigate the potential of three Brazilian grasses (Panicum maximum, Pennisetum purpureum and Brachiaria brizantha), as well as bark residues from the harvesting of two commercial Eucalyptus clones (E. grandis and E. grandis x urophylla) for biofuel production, and compare these to sugarcane bagasse. The effects of hot water, acid, alkaline and sulfite pretreatments (at increasing temperatures) on the chemical composition, morphology and saccharification yields of these different biomass types were evaluated. RESULTS: The average yield (per hectare), availability and general composition of all five biomasses were compared. Compositional analyses indicate a high level of hemicellulose and lignin removal in all grass varieties (including sugarcane bagasse) after acid and alkaline pretreatment with increasing temperatures, whilst the biomasses pretreated with hot water or sulfite showed little variation from the control. For all biomasses, higher cellulose enrichment resulted from treatment with sodium hydroxide at 130°C. At 180°C, a decrease in cellulose content was observed, which is associated with high amorphous cellulose removal and 5-hydroxymethyl-furaldehyde production. Morphological analysis showed the effects of different pretreatments on the biomass surface, revealing a high production of microfibrillated cellulose on grass surfaces, after treatment with 1% sodium hydroxide at 130°C for 30 minutes. This may explain the higher hydrolysis yields resulting from these pretreatments, since these cellulosic nanoparticles can be easily accessed and cleaved by cellulases. CONCLUSION: Our results show the potential of three Brazilian grasses with high productivity yields as valuable sources of carbohydrates for ethanol production and other biomaterials. Sodium hydroxide at 130°C was found to be the most effective pretreatment for enhanced saccharification yields. It was also efficient in the production of microfibrillated cellulose on grass surfaces, thereby revealing their potential as a source of natural fillers used for bionanocomposites production.

RESUMEN

BACKGROUND: In recent years, the growing demand for biofuels has encouraged the search for different sources of underutilized lignocellulosic feedstocks that are available in sufficient abundance to be used for sustainable biofuel production. Much attention has been focused on biomass from grass. However, large amounts of timber residues such as eucalyptus bark are available and represent a potential source for conversion to bioethanol. In the present paper, we investigate the effects of a delignification process with increasing sodium hydroxide concentrations, preceded or not by diluted acid, on the bark of two eucalyptus clones: Eucalyptus grandis (EG) and the hybrid, E. grandis x urophylla (HGU). The enzymatic digestibility and total cellulose conversion were measured, along with the effect on the composition of the solid and the liquor fractions. Barks were also assessed using Fourier-transform infrared spectroscopy (FTIR), solid-state nuclear magnetic resonance (NMR), X-Ray diffraction, and scanning electron microscopy (SEM). RESULTS: Compositional analysis revealed an increase in the cellulose content, reaching around 81% and 76% of glucose for HGU and EG, respectively, using a two-step treatment with HCl 1%, followed by 4% NaOH. Lignin removal was 84% (HGU) and 79% (EG), while the hemicellulose removal was 95% and 97% for HGU and EG, respectively. However, when we applied a one-step treatment, with 4% NaOH, higher hydrolysis efficiencies were found after 48 h for both clones, reaching almost 100% for HGU and 80% for EG, in spite of the lower lignin and hemicellulose removal. Total cellulose conversion increased from 5% and 7% to around 65% for HGU and 59% for EG. NMR and FTIR provided important insight into the lignin and hemicellulose removal and SEM studies shed light on the cell-wall unstructuring after pretreatment and lignin migration and precipitation on the fibers surface, which explain the different hydrolysis rates found for the clones. CONCLUSION: Our results show that the single step alkaline pretreatment improves the enzymatic digestibility of Eucalyptus bark. Furthermore, the chemical and physical methods combined in this study provide a better comprehension of the pretreatment effects on cell-wall and the factors that influence enzymatic digestibility of this forest residue.