For acellular pertussis (aP) vaccines, the current European Pharmacopoeia (Ph. Eur.) monograph Pertussis vaccine (acellular, component, adsorbed) (1356) requires an immunogenicity assay in mice or guinea pigs to assess the potency of each lot of vaccine (Ph. Eur. general method 2.7.16. Assay of pertussis vaccine (acellular)). This biological assay, carried out on the final bulk of the vaccine lot, is based on the measurement of the specific antibody response to the 5 antigenic components (pertussis toxin (PT), Fimbrial haemagglutinin (FHA), pertactin (PRN) and Fimbriae 2 and 3 (FIM2/3)) that are present in the combined aP vaccines. In the mouse assay, serum antibody levels are measured by ELISA. The immunogenicity of a vaccine under test is estimated versus a homologous reference vaccine and a reference antiserum e.g. the first Ph. Eur. Biological Reference Preparation for Bordetella (B.) pertussis mouse anti-serum (BRP1), established in 1998, is used to normalise the titre of antibodies (expressed in ELISA Units (ELU)/mL). In anticipation of the depletion of BRP1 stocks, a project was launched in 2013 by the Biological Standardisation Programme (BSP) of the European Directorate for the Quality of Medicines & HealthCare (EDQM) in order to establish a new standardised reference serum. The project, referred to herein as BSP129, was conducted in 2 phases: 1) the production and characterisation of a mouse serum pool (using a multicomponent aP vaccine marketed in Canada similar to the vaccine used in the BRP1 production as immunogen) and of candidate BRP batches (cBRPs) and 2) an international collaborative study aimed at calibrating the cBRPs in terms of antibody levels against PT, FHA, PRN and FIM2/3. This article presents the design and results of the first phase of the collaborative study to establish the optimal conditions for immunisation and bleeding of mice in order to produce a large pool of hyper-immune serum against the 5 antigens. After the characterisation of this pool, cBRP pilot lots were manufactured by freeze-drying diluted solutions of the hyper-immune serum pool. The pilot lots were then characterised in two Official Medicines Control Laboratories (OMCLs) for their antibody contents against aP vaccine antigens using in-house ELISA (based on methods developed by 2 European vaccine manufacturers) and Multiplex Immunoassay (MIA) methods. The antibody titres recovered demonstrated that a dilution factor of 1/40 could be considered for the scaled-up manufacture of candidate reference preparations (cBRPs). Three batches (15 000 vials) of cBRP were manufactured and fully characterised. In light of the data obtained, and although titration results between the ELISA methods were sometimes discrepant, it was agreed that the establishment study (phase 2) could be launched. Real-time and accelerated stability studies were also included in the first study phase to document the stability of the cBRPs in freeze-dried form and after reconstitution and storage at -20°C±5°C. The results showed that the stability of the freeze-dried cBRPs at usual storage and shipment temperatures is acceptable and that reconstituted cBRP solutions are stable for 12 months at -20°C±5°C. It could therefore be recommended to freeze small aliquots of the 1 mL solution obtained by the reconstitution of one BRP vial in order to store them for use in separate assays. With the application of this strategy, the stocks of the BRP1 replacement batches should cover the needs of OMCLs and manufacturers for at least the next decade.