STATEMENT OF PROBLEM: Excessive stress on abutment teeth adjacent to a maxillary resection defect during loading of partial denture obturator frameworks may shorten the life of the teeth. PURPOSE: The aim of this study was to photoelastically compare the forces exerted on the supporting structures of abutment teeth in 3 differently sized surgical resections with removable partial denture designs used to restore such maxillectomy defects. MATERIAL AND METHODS: Composite photoelastic models were constructed of a human maxilla that had undergone each of 3 maxillectomies: partial, radical, and radical involving the contralateral premaxilla. The abutment teeth included all remaining anterior teeth, the first premolar, and second molar, except the radical maxillectomy, which included the contralateral premaxilla where all remaining teeth were used as abutment teeth. All abutment teeth were restored with complete metal crowns, and removable partial denture frameworks were fabricated. Loading zones were selected according to the resection, and a 10-lb load was applied at each load point. The resulting stresses were observed and recorded photographically in a circular polariscope. The 2 teeth adjacent to the resection were then splinted, and the loading regimens were repeated. RESULTS: Without splinting, loads closer to the defect produced lingual tipping of the teeth adjacent to the resection and a mesial tipping tendency of the second molar. The tipping effects were greatest in the model with the largest resection. Splinting reduced tipping of the teeth adjacent to the resection and produced more uniform stress around these 2 abutment tooth roots for all of the models. CONCLUSION: The results of this in vitro study suggest that splinting the 2 teeth adjacent to a resection defect improves stress distribution around the roots during loading. This could increase the clinical life of the abutment teeth.