RESUMO

Siparuna glycycarpa occurs in the Amazon region, and some species of this genus are used in Brazilian folk medicine. A recent study showed the inhibitory effect of this species against influenza A(H1N1)pdm09 virus, and in order to acquire active fractions, a polar solvent system n-butanol-methanol-water (9:1:10, v/v) was selected and used for bioassay-guided fractionation of n-butanol extract by centrifugal partition chromatography (CPC). The upper phase was used as stationary phase and the lower phase as mobile (descending mode). Among the collected fractions, the ones coded SGA, SGC, SGD, and SGO showed the highest antiviral inhibition levels (above 74%) at 100 µg·mL-1 after 24 h of infection. The bioactive fractions chemical profiles were investigated by LC-HRMS/MS data in positive and negative ionization modes exploring the Global Natural Products Social Molecular Networking (GNPS) platform to build a molecular network. Benzylisoquinoline alkaloids were annotated in the fractions coded SGA, SGC, and SGD collected during elution step. Aporphine alkaloids, O-glycosylated flavonoids, and dihydrochalcones in SGO were acquired with the change of mobile phase from lower aqueous to upper organic. Benzylisoquinolinic and aporphine alkaloids as well as glycosylated flavonoids were annotated in the most bioactive fractions suggesting this group of compounds as responsible for antiviral activity.

Assuntos

RESUMO

The detailed metabolite profiling of Laguncularia racemosa was accomplished by high-performance countercurrent chromatography (HPCCC) using the three-phase system n-hexane-tert-butyl methyl ether-acetonitrile-water 2:3:3:2 (v/v/v/v) in step-gradient elution mode. The gradient elution was adjusted to the chemical complexity of the L. racemosa ethyl acetate partition and strongly improved the polarity range of chromatography. The three-phase solvent system was chosen for the gradient to avoid equilibrium problems when changing mobile phase compositions encountered between the gradient steps. The tentative recognition of metabolites including the identification of novel ones was possible due to the off-line injection of fractions to electrospray ionization mass spectrometry (ESI-MS/MS) in the sequence of recovery. The off-line hyphenation profiling experiment of HPCCC and ESI-MS projected the preparative elution by selected single ion traces in the negative ionization mode. Co-elution effects were monitored and MS/MS fragmentation data of more than 100 substances were used for structural characterization and identification. The metabolite profile in the L. racemosa extract comprised flavonoids, hydrolysable tannins, condensed tannins and low molecular weight polyphenols.

Assuntos

RESUMO

The present study reports the improved enzymatic synthesis of ethyl valerate (green apple flavor) by esterification reaction of ethanol and valeric acid in heptane medium. Lipase from Thermomyces lanuginosus (TLL) was immobilized by physical adsorption on polyhydroxybutyrate (PHB) particles and used as a potential biocatalyst. The effect of certain parameters that influence the ester synthesis was evaluated by factorial design. The experimental conditions that maximized the synthesis of ethyl valerate were 30.5°C, 18% m/v of biocatalyst (TLL-PHB), absence of molecular sieves, agitation of 234 rpm, and 1,000 mM of each reactant (ethanol and valeric acid). Under these conditions, conversion percentage ≈92% after 105 min of reaction was observed. Soluble TLL was also used as biocatalyst and the highest conversion was of 82% after 120 min of reaction. Esterification reaction performed in a solvent-free system exhibited conversion of 13% after 45 min of reaction catalyzed by immobilized lipase, while the soluble lipase did not exhibit catalytic activity. The synthesis of the ester was confirmed by Fourier transform infrared spectroscopy and gas chromatography-mass spectrometry analyses. After six consecutive cycles of ethyl valerate synthesis, the prepared biocatalyst retained ≈86% of its original activity.

Assuntos

RESUMO

This paper describes the results obtained on the preparation of films composed of linter cellulose and the corresponding acetates. The acetylation was carried out in the LiCl/DMAc solvent system. Films were prepared from a LiCl/DMAc solution of cellulose acetates (degree of substitution, DS 0.8-2.9) mixed with linter cellulose (5, 10 and 15 wt %). Detailed characterization of the films revealed the following: (i) they exhibited fibrous structures on their surfaces. The strong tendency of the linter cellulose chains to aggregate in LiCl/DMAc suggests that these fibrous elements consist of cellulose chains, as can be deduced from SEM images of the film of cellulose proper; (ii) the cellulose acetate films obtained from samples with DS 2.1 and 2.9 exhibited microspheres on the surface, whose formation seems to be favored for acetates with higher DS; (iii) AFM analysis showed that, in general, the presence of cellulose increased both the asperity thickness and the surface roughness of the analyzed films, indicating that cellulose chains are at least partially organized in domains and not molecularly dispersed between acetate chains; and (iv) the films prepared from cellulose and acetates exhibited lower hygroscopicity than the acetate films, also suggesting that the cellulose chains are organized into domains, probably due to strong intermolecular interactions. The linter and sisal acetates (the latter from a prior study), and their respective films, were prepared using the same processes; however, the two sets of films presented more differences (as in humidity absorption, optical, and tensile properties) than similarities (as in some morphological aspects), most likely due to the different properties of the starting materials. Potential applications of the films prepared in tissue engineering scaffold coatings and/or drug delivery are mentioned.