RESUMO

Achieving sustainability in life involves increasing efforts to recover resources. This research proposes the recovery of Zn from the Milluni lagoons, an important water supply for Bolivia, where high concentrations of Zn have been identified that exceed permitted limits, exposing a risk to health and ecosystems. The application of reverse osmosis (RO), operated with low pressures, is proposed as a first stage for the concentration of Zn and subsequent recovery of this metal through chemical precipitation. The aim was to maintain the separation efficiency of the RO operated at low pressures without presenting operational problems. As a result, 98.83% metal concentration was achieved with a laboratory-scale pilot system. The above means an important potential for large-scale Zn concentration, apart from orienting the RO toward sustainability by working with low pressures that reduce energy costs during its operation. This study can be used as a valuable reference for the advancement of sustainable technologies in the field of water treatment that simultaneously allow the recovery of resources to promote a circular economy. Finally, this study exposes an alternative for regions with heavy metal water contamination in Bolivia and worldwide.

RESUMO

Electronic waste recycling is a strategy that contributes to implement a circular economy model which include reuse, component and raw material recovery and minimum final deposition. Given the importance of reincorporating the components of electronic devices into the productive chain and a correct recovery for some hazardous metals such as lead contained in such residues. This study is focused on the effect of maximum available content (MAC) of metal, sulfuric acid initial concentration, agitation velocity, and oxidising agent on the recovery of copper, lead and iron from electronic waste through acid leaching. A solid-state characterization before and after treatment and electrochemical analysis was carried out to analyse MCA effects and surface chemistry. It was found that sub-millimetric particles show a better available extraction percentage in case of copper and iron, being opposite for lead. Presence of hydrogen peroxide enhance the extraction efficiency, however, this cause iron and lead precipitation, therefore it is inefficient for metals recovery as well as for reagent consumption. The presence of calcium salts reacts producing gypsum, which reduces the extraction yield of copper at particle size below 250 µm.

RESUMO

The electrochemical ion pumping device is a promising alternative for the development of the industry of recovering metals from natural sources-such as seawater, geothermal water, well brine, or reverse osmosis brine-using electrochemical systems, which is considered a non-evaporative process. This technology is potentially used for metals like Li, Cu, Ca, Mg, Na, K, Sr, and others that are mostly obtained from natural brine sources through a combination of pumping, solar evaporation, and solvent extraction steps. As the future demand for metals for the electronic industry increases, new forms of marine mining processing alternatives are being implemented. Unfortunately, both land and marine mining, such as off-shore and deep sea types, have great potential for severe environmental disruption. In this context, a green alternative is the mixing entropy battery, which is a promising technique whereby the ions are captured from a saline natural source and released into a recovery solution with low ionic force using intercalation materials such as Prussian Blue Analogue (PBA) to store cations inside its crystal structure. This new technique, called "electrochemical ion pumping", has been proposed for water desalination, lithium concentration, and blue energy recovery using the difference in salt concentration. The raw material for this technology is a saline solution containing ions of interest, such as seawater, natural brines, or industrial waste. In particular, six main ions of interest-Na+, K+, Mg2+, Ca2+, Cl-, and SO42--are found in seawater, and they constitute 99.5% of the world's total dissolved salts. This manuscript provides relevant information about this new non-evaporative process for recovering metals from aqueous salty solutions using hexacianometals such as CuHCF, NiHCF, and CoHCF as electrodes, among others, for selective ion removal.

RESUMO

Spent Li-ion batteries (LIBs) despite being produced with valuable metals from non-renewable natural resources are considered hazardous solid wastes because they contain metals and organic solvents pollutants for the environment. Due to this, it becomes necessary to know the chemical composition of these spent batteries to assist in the proper disposal and/or recycling process. This study aimed to provide quantitative data regarding the chemical composition of the cathode active material (CAM) of eight different spent LIBs used in cell phones and propose relationship with their energy capacity, year of manufacture and brand. CAM powder was leached using an environmentally friendly process with citric acid (2.0 mol L-1) and H2O2 (0.25 mol L-1), and the metals concentrations were determined by inductively coupled plasma optical emission spectrometry (ICP OES). Co (43-67 wt%), Li (5.3-6.8 wt%), Mn (0.8-8.2 wt%), Ni (0.1-11.7 wt%) and Al (0.06-3.2 wt%) were present in higher concentrations, whereas Cr (0.0005-0.002 wt%), Cu (0.01-0.05 wt%), Mg (0.005-0.02 wt%), Ti (0.001-0.07 wt%), Ga (0.0009-0.03 wt%) and Zn (0.009-0.05 wt%) were present in lower concentrations. The result obtained showed a considerable variation between CAM elemental composition, which may be related to type of electrolyte, energy capacity and year of manufacture. Since this difference in chemical composition is not shown on product labels, this work using a green leaching process and a suitable analytical method may assist in the recycling processes and avoid the inappropriate disposal of the material.

RESUMO

Marine microorganisms that are obtained from hydrothermal vent sediments present a great metabolic potential for applications in environmental biotechnology. However, the work done regarding their applications in engineered systems is still scarce. Hence, in this work, the sulfate reduction process carried out by a marine microbial community in an upflow anaerobic sludge blanket (UASB) reactor was investigated for 190 days under sequential batch mode. The effects of 1000 to 5500 mg L-1 of SO4-2 and the chemical oxygen demand (COD)/SO4-2 ratio were studied along with a kinetic characterization with lactate as the electron donor. Also, the feasibility of using the sulfide produced in the UASB for copper precipitation in a second column was studied under continuous mode. The system presented here is an alternative to sulfidogenesis, particularly when it is necessary to avoid toxicity to sulfide and competition with methanogens. The bioreactor performed better with relatively low concentrations of sulfate (up to 1100 mg L-1) and COD/SO4-2 ratios between 1.4 and 3.6. Under the continuous regime, the biogenic sulfide was sufficient to precipitate copper at a removal rate of 234 mg L-1 day-1. Finally, the identification of the microorganisms in the sludge was carried out; some genera of microorganisms identified were Desulfitobacterium and Clostridium.

Assuntos

RESUMO

Biomining is an applied biotechnology for mineral processing and metal extraction from ores and concentrates. This alternative technology for recovering metals involves the hydrometallurgical processes known as bioleaching and biooxidation where the metal is directly solubilized or released from the matrix for further solubilization, respectively. Several commercial applications of biomining can be found around the world to recover mainly copper and gold but also other metals; most of them are operating at temperatures below 40-50 °C using mesophilic and moderate thermophilic microorganisms. Although biomining offers an economically viable and cleaner option, its share of the world´s production of metals has not grown as much as it was expected, mainly considering that due to environmental restrictions in many countries smelting and roasting technologies are being eliminated. The slow rate of biomining processes is for sure the main reason of their poor implementation. In this scenario the use of thermophiles could be advantageous because higher operational temperature would increase the rate of the process and in addition it would eliminate the energy input for cooling the system (bioleaching reactions are exothermic causing a serious temperature increase in bioreactors and inside heaps that adversely affects most of the mesophilic microorganisms) and it would decrease the passivation of mineral surfaces. In the last few years many thermophilic bacteria and archaea have been isolated, characterized, and even used for extracting metals. This paper reviews the current status of biomining using thermophiles, describes the main characteristics of thermophilic biominers and discusses the future for this biotechnology.

Assuntos

RESUMO

The utilisation of steelmaking slag as recycled aggregate for concretes is a widely investigated solution for mitigating the expenditure and environmental impacts of its storage. The Brazilian steel industry is investing in research and slag reprocessing practices, aiming to reuse most of its metallic fraction and properly allocate the non-metallic fraction, saving energy and reducing mining impacts. Research results demonstrate the technical and environmental feasibility of steel slag aggregates for civil construction. However, it is essential to evaluate whether the processing of the slag is economically feasible for this purpose. Economic analysis of the processing of steel slag was conducted through simulation - Monte Carlo method - in which it is possible to determine the risks and uncertainties inherent to the project. The costs that comprise the proposed project, from design through construction and operation itself, were estimated at US$2.8 million. The result of the simulation indicates economic feasibility of the project with 98% certainty, and an estimated profit of around 42%.

Assuntos

RESUMO

The proper disposal of electrical and electronic waste is currently a concern of researchers and environmental managers not only because of the large volume of such waste generated, but also because of the heavy metals and toxic substances it contains. This study analyzed printed circuit boards (PCBs) from discarded computers to determine their metal content and characterized them as solid waste and fuel. The analysis showed that PCBs consist of approximately 26% metal, made up mainly of copper, lead, aluminum, iron and tin, as well as other heavy metals such as cadmium and nickel. Comparison with the results of other studies indicated that the concentration of precious metals (gold and silver) has declined over time. Analysis of the leachate revealed high concentrations of cadmium and lead, giving the residue the characteristics of hazardous waste. After milling the PCBs, we found that larger amounts of metal were concentrated in smaller fractions, while the lightest fraction, obtained by density separation, had a gross calorific value of approximately 11 MJ/kg, although with a high ash content. Milling followed by density separation proved potentially useful for recovery of metals and energy-rich fractions.