RESUMO
Ion bombardment is an important tool of materials processing, but usually leads to erosion of the surface and significant thickness reductions when thin layers are used. The growing use of polymer thin films in a variety of applications, from coatings and membranes to biomedical and electronic devices, calls for a deeper understanding of the thinning process induced by energetic ions espe-cially for very thin films. Here, thinning and surface morphology changes induced by high-energy ion bombardment in PMMA and PVC thin films were investigated, focusing on the role of the initial thickness of the films and the stopping power of the ions. We used thin films with initial thicknesses varying from 13 to 800 nm, and light and heavy ions as projectiles in the energy range of 2-2000 MeV, where the electronic stopping dominates. Thickness reductions as a function of fluence were monitored and thinning cross sections were extracted from curves. A supralinear scaling between the thinning cross sections and the electronic stopping power of the beams was observed, with a much enhanced thinning efficiency for the swift heavy ions. The scaling with the stopping power dE/dx is almost independent of the initial thickness of the films. At intermediate and large fluences, changes in the physicochemical properties of the irradiated polymers may modulate and decelerate the thinning process of the remaining film. The importance of this secondary process depends on the stopping power and the balance between erosion and the chemical transformations induced by the beam. We also observe a trend for the thinning efficiency to become larger in very thin films. Depending on the type of beam and polymer, this effect is more or less pronounced. PMMA films irradiated with 2 MeV H+ show the most systematic correlation between initial thickness and thinning cross sections, while in PVC films the initial thickness plays a minor role for all investigated beams.
RESUMO
Radiolysis of biomolecules by fast ions has interest in medical applications and astrobiology. The radiolysis of solid D-valine (0.2-2 µm thick) was performed at room temperature by 1.5 MeV H+, He+, N+, and 230 MeV S15+ ion beams. The samples were prepared by spraying/dropping valine-water-ethanol solution on ZnSe substrate. Radiolysis was monitored by infrared spectroscopy (FTIR) through the evolution of the intensity of the valine infrared 2900, 1329, 1271, 948, and 716 cm-1 bands as a function of projectile fluence. At the end of sample irradiation, residues (tholins) presenting a brownish color are observed. The dependence of the apparent (sputtering + radiolysis) destruction cross section, σd, on the beam stopping power in valine is found to follow the power law σd = aSen, with n close to 1. Thus, σd is approximately proportional to the absorbed dose. Destruction rates due to the main galactic cosmic ray species are calculated, yielding a million year half-life for solid valine in space. Data obtained in this work aim a better understanding on the radioresistance of complex organic molecules and formation of radioproducts.
Assuntos
Valina/química , Radiação Cósmica , Hélio/química , Hidrogênio/química , Método de Monte Carlo , Nitrogênio/química , Compostos de Selênio/metabolismo , Espectrofotometria Infravermelho , Compostos de Zinco/metabolismoRESUMO
ABSTRACT Screening promising L. thermophiles with high productivity, high efficiency and strong adaptability are very important in lactic acid industry. For this purpose, 80MeV/u carbon ions were applied to irradiate L. thermophiles. After high-throughput screening, a mutant, named SRZ50, was obtained. Different carbon sources or nitrogen sources were provided to investigate carbon or nitrogen source utilization between mutant SRZ50 and wild type, and different fermentation periods were also chose to study fermentation characteristic between mutant SRZ50 and wild type. The results showed that mutant SRZ50 exhibited the enhanced L-(+)-lactic acid production from wild type. When glucose or fructose was the sole carbon source, the L(+)-lactic acid production by mutant SRZ50 was both the highest, respectively, 23.16 ± 0.72 g/L or 23.24 ± 0.66 g/L, which had a significant increase from that of wild type (P<0.01), following obvious increase in biomass (P<0.05). When yeast powder was the sole nitrogen source, it can promote mutant SRZ50 to accumulate the highest L-(+)-lactic acid accumulation, which also had a significant increase from that of wild type (P<0.01). Under different fermentation periods, it was obtained that mutant SRZ50 all exhibited significant increase in L-(+)-lactic acid accumulation from wild type. In conclusion, a mutant strain with improved production profiles for L-(+)-lactic acid, was obtained, indicating that heavy ions can be an efficient tool to improve metabolic product accumulations in microbes.