RESUMO

BACKGROUND: Hexahydro-2H-pyrano[3,2-c]quinolines are known to have antibacterial, antifungal, and antitumor properties. Great efforts have been made to develop new synthetic methods that lead to the synthesis of valuable libraries. Extensive methodologies, low yields, excessive amounts of catalyst and expensive reactants are some of the limitations of current methodologies. AIMS AND OBJECTIVE: Developing a useful and efficient method to construct diversely substituted hexahydro-2Hpyrano[ 3,2-c]quinolines into good to excellent yields through a cationic imino-Diels-Alder/N-debenzylation methodology. METHOD: The cationic imino-Diels-Alder/N-debenzylation methodology was used for the preparation of substituted hexahydro-2H-pyrano[3,2-c]quinolines. It involves the use of Sc(OTf)3 for activation of cationic imino- Diels-Alder cycloaddition reaction of N-benzylanilines, 3,4-dihydro-2H-pyran and paraformaldehyde in MeCN; and microwave irradiation to shorten reaction time to afford new 6-benzyl-hexahydro-2H-pyrano[3,2- c]quinolines whose catalytic transfer debenzylation reactions with HCO2NH4 in the presence of Pd/C (10%) and methanol give the new 5-unsubstituted pyrano[3,2-c]quinolines in excellent yields. RESULTS: We found that optimal conditions for the preparation of hexahydro-2H-pyrano[3,2-c]quinolines were Sc(OTf)3 0.5 % and acetonitrile at 160°C for 15 min; and using paraformaldehyde obtained the 6-benzylhexahydro- 2H-pyrano [3,2-c]quinolines with excellent yields, while the N-debenzylation process using ammonium formate in the presence of Pd/C and methanol resulted in the synthesis of hexahydro-2H-pyrano [3,2-c] quinolines with quantitative yields (95-98%). CONCLUSION: We describe an efficient method to synthesize hexahydro-2H-pyrano[3,2-c]quinolines via the cationic imino-Diels-Alder/N-debenzylation methodology using Sc(OTf)3 0.5 % as Lewis Acid catalyst. Excellent yields of the products, use of MW irradiation, short times of reactions, and an efficient and highly diversified method are some of the main advantages of this new protocol.

Assuntos

RESUMO

BACKGROUND: Hafnium(IV) tetrachloride efficiently catalyzes the protection of a variety of aldehydes and ketones, including benzophenone, acetophenone, and cyclohexanone, to the corresponding dimethyl acetals and 1,3-dioxolanes, under microwave heating. Substrates possessing acid-labile protecting groups (TBDPS and Boc) chemoselectively generated the corresponding acetal/ketal in excellent yields. AIMS AND OBJECTIVES: In this study. the selective protection of aldehydes and ketones using a Hafnium(IV) chloride, which is a novel catalyst, under microwave heating was observed. Hence, it is imperative to find suitable conditions to promote the protection reaction in high yields and short reaction times. This study was undertaken not only to find a novel catalyst but also to perform the reaction with substrates bearing acid-labile protecting groups, and study the more challenging ketones as benzophenone. MATERIALS AND METHODS: Using a microwave synthesis reactor Monowave 400 of Anton Paar, the protection reaction was performed on a raging temperature of 100°C ±1, a pressure of 2.9 bar, and an electric power of 50 W. More than 40 substrates have been screened and protected, not only the aldehydes were protected in high yields but also the more challenging ketones such as benzophenone were protected. All the products were purified by simple flash column chromatography, using silica gel and hexanes/ethyl acetate (90:10) as eluents. Finally, the protected substrates were characterized by NMR 1H, 13C and APCI-HRMS-QTOF. RESULTS: Preliminary screening allowed us to find that 5 mol % of the catalyst is enough to furnish the protected aldehyde or ketone in up to 99% yield. Also it was found that substrates with a variety of substitutions on the aromatic ring (aldehyde or ketone), that include electron-withdrawing and electrondonating group, can be protected using this methodology in high yields. The more challenging cyclic ketones were also protected in up to 86% yield. It was found that trimethyl orthoformate is a very good additive to obtain the protected acetophenone. Finally, the protection of aldehydes with sensitive functional groups was performed. Indeed, it was found that substrates bearing acid labile groups such as Boc and TBDPS, chemoselectively generated the corresponding acetal/ketal compound while keeping the protective groups intact in up to 73% yield. CONCLUSION: Hafnium(IV) chloride as a catalyst provides a simple, highly efficient, and general chemoselective methodology for the protection of a variety of structurally diverse aldehydes and ketones. The major advantages offered by this method are: high yields, low catalyst loading, air-stability, and non-toxicity.

Assuntos

RESUMO

In this work, we computationally evaluated the influence of six different molecular solvents, described as a polarizable continuum model at the M06-2X/6-31+G(d,p) level, on the activation barrier/reaction rate, overall energy change, TS geometry, and degree of (a)synchronicity of two concerted Diels-Alder cycloadditions of acrolein (R1) and its complex with Lewis acid acrolein···BH3 (R2) to cyclopentadiene. In gas-phase, we found that both exothermicity and activation barrier are only reduced by about 2.0 kcal mol-1, and the asynchronicity character of the mechanism is accentuated when BH3 is included. An increment in the solvent's polarity lowers the activation energy of R1 by 1.3 kcal mol-1, while for R2 the reaction rate is enhanced by more than 2000 times at room temperature (i.e., the activation energy decreases by 4.5 kcal mol-1) if the highest polar media is employed. Therefore, a synergistic effect is achieved when both external agents, i.e., Lewis acid catalyst and polar solvent, are included together. This effect was ascribed to the ability of the solvent to favor the encounter between cyclopentadiene and acrolein···BH3. This was validated by the asymmetry of the TS which becomes highly pronounced when either both or just BH3 is considered or the solvent's polarity is increased. Finally, the reaction force constant κ(ξ) reveals that an increment in the solvent's polarity is able to turn a moderate asynchronous mechanism of the formation of the new C-C σ-bonds into a highly asynchronous one. Graphical abstract A synergistic effect is achieved when both external agents, i.e., Lewis acid catalyst and polar solvent, are included together: lowered energy barriers and increased asynchronicities.

RESUMO

A theoretical study was undertaken regarding the regioselective Lewis acid-promoted intramolecular cyclization of novel enaminones 1-3 leading to the corresponding benzofurans 4-5 and indoles 6. The density functional theory (DFT) and hard and soft acids and bases (HSAB) principle provided data to describe the electronic effects of the substituents in the reactivity of the benzene ring and the enaminone moiety. The condensed and local Fukui functions for nucleophilic and electrophilic attacks of the reactants accounted for the experimentally observed preference, in regard to precursors 1-3, of the cyclization between the C6' carbon (rather than the C2' carbon) of the benzene ring and the C3 center of the enaminone moiety.

Assuntos

RESUMO

In this study, the effect of zeolite chemical surface characteristics on the oxidative regeneration of toluene saturated-zeolite samples is investigated. A Chilean natural zeolite (53% clinoptilolite, 40% mordenite and 7% quartz) was chemically modified by acid treatment with hydrochloric acid and by ion-exchange with ammonium sulphate. Thermal pre-treatments at 623 and 823K were applied and six zeolite samples with different chemical surface characteristics were generated. Chemical modification of natural zeolite followed by thermal out-gassing allows distinguishing the role of acidic surface sites on the regeneration of exhausted zeolites. An increase in Brønsted acid sites on zeolite surface is observed as a result of ammonium-exchange treatment followed by thermal treatment at 623K, thus increasing the adsorption capacity toward toluene. High ozone consumption could be associated to a high content of Lewis acid sites, since these could decompose ozone into atomic active oxygen species. Then, surface oxidation reactions could take part among adsorbed toluene at Brønsted acid sites and surface atomic oxygen species, reducing the amount of adsorbed toluene after the regenerative oxidation with ozone. Experimental results show that the presence of adsorbed oxidation by-products has a negative impact on the recovery of zeolite adsorption capacity.

Assuntos