RESUMO

An edible Mushroom-Nafion modified glassy carbon electrode (M2N5-GCE) was prepared using a homogeneous mixture varying the concentrations of these, in addition to the origin of the mushroom (Shiitake, Lentinula edodes, M1 and Abrantes, Agariscus bisporus, M2) and applied to the As(III) determination by anodic stripping voltammetry. After choosing the optimal conditions in the preparation of the electrode, the second stage was to study the effects of various parameters such as supporting electrolyte, pH, accumulation potential, and time (Eacc, tacc). The optimum experimental conditions chosen were Britton Robinson buffer 0.01 mol L-1 pH:4.6; Eacc: -1.0 and tacc: 60 s obtaining a signal of oxidation of As(0) to As(III) about 0.08 V. Peak current was proportional to arsenic concentration over the 19.6-117.6 µg L-1 range, with a 3σ detection limit of 13.4 µg L-1. The method was validated using As(III) spiked tap water from the laboratory with satisfactory results (RE:3.0 %). Finally, the method was applied to the determination of As(III) in water samples from the Loa River (Northern Chile) in the presence of As(V) in a concentration >20 times higher (RE: 2.3 %).

Assuntos

Agaricales , Arsênio , Carbono , Eletrodos , Polímeros de Fluorcarboneto , Polímeros de Fluorcarboneto/química , Carbono/química , Arsênio/análise , Arsênio/química , Agaricales/química , Técnicas Eletroquímicas/métodos , Limite de Detecção , Concentração de Íons de Hidrogênio , Poluentes Químicos da Água/análise , Poluentes Químicos da Água/química , Eletroquímica

RESUMO

Herein, a simple, green, and relatively inexpensive approach to determine nickel (Ni) in biodiesel samples by square wave adsorptive cathodic stripping voltammetry (SWAdCSV) is presented. A method based on the accumulation of Ni as Ni(II)-dimethylglyoxime (Ni(II)(HDMG)2) on the glassy carbon electrode was carried out in a solution containing the aqueous phase extract (APhEx) obtained from an extraction induced by microemulsion breaking (EIMB), which was achieved by adding a few microliters of ultrapure water to a microemulsion composed of biodiesel, n-propanol and a diluted HNO3 solution. The LOD and LOQ were 0.2 µg L-1 and 0.8 µg L-1, respectively, and the accuracy was evaluated by recovery assays of spiked samples and by analyzing a standard reference material. Results obtained from a comparative method (HR-CS GF AAS) were also used for this evaluation. The method was applied to biodiesel samples produced from different feedstocks. To the best of the authors knowledge, it is the first time that: 1) Ni in biodiesel is determined by a voltammetric method; 2) EIMB is applied to extract Ni from this matrix and 3) this type of sample preparation method is used with adsorptive stripping voltammetry.

RESUMO

A fast, sensitive, and selective method for the simultaneous determination of one pair of synthetic colorants commonly found mixed in food products, Amaranth (AM) and Tartrazine (TZ), based on their adsorption and oxidation on a screen-printed electrode (SPE) is presented. The variation of peak current with pH, supporting electrolyte, adsorption time, and adsorption potential were optimized using square wave adsorptive voltammetry. The optimal conditions were found to be: pH 3.2 (PBS), Eads 0.00 V, and tads 30 s. Under these conditions, the AM and TZ signals were observed at 0.56 and 0.74 V, respectively. A linear response were found over the 0.15 to 1.20 µmol L-1 and 0.15 to 0.80 µmol L-1 concentrations, with detection limits (3σ/slope) of 26 and 70 nmol L-1 for AM and TZ, respectively. Reproducibility for 17.7 µmol L-1 AM and TZ solutions were 2.5 and 3.0% (n = 7), respectively, using three different electrodes. The method was validated by determining AM and TZ in spiked tap water and unflavored gelatin spiked with AM and TZ. Because a beverage containing both AM and TZ was not found, the method was applied to the determination of AM in a kola soft drink and TZ in an orange jelly and a soft drink powder.

RESUMO

Tryptamine, a biogenic amine, is an indole derivative with an electrophilic substituent at the C3 position of the pyrrole ring of the indole moiety. The electrochemical oxidation of tryptamine was investigated using glassy carbon electrode (GCE), and focusing on trace level determination in food products by square wave adsorptive stripping voltammetry (SWAdSV). The electrochemical responses of tryptamine were evaluated using differing voltammetric techniques over a wide pH range, a quasi-reversible electron-transfer to redox system represented by coupled peaks P1-P3, and an irreversible reaction for peak P2 were demonstrated. The proton and electron counts associated with the oxidation reactions were estimated. The nature of the mass transfer process was predominantly diffusion-limited for the oxidation process of P1, the most selective and sensitive analytical response (acetate buffer solution pH 5.3), being used for the development of SWAdSV method, under optimum conditions. The excellent response allowed the development of an electroanalytical method with a linear response range of from 4.7-54.5)×10(-)(8)molL(-1), low detection limit (0.8×10(-)(9)molL(-)(1)), and quantification limit (2.7×10(-9)molL(-1)), and acceptable levels of repeatability (3.6%), and reproducibility (3.8%). Tryptamine content was determined in bananas, tomatoes, cheese (mozzarella and gorgonzola), and cold meats (chicken sausage and pepperoni sausage), yielding recoveries above 90%, with excellent analytical performance using simple and low cost instrumentation.

Assuntos

Triptaminas/análise , Adsorção , Carbono , Eletrodos , Reprodutibilidade dos Testes

RESUMO

The determination of Sb(III) on an ex-situ bismuth screen-printed carbon electrode (ex-situ BiSPCE) by means of adsorptive stripping voltammetry (AdSV) using quercetin-5'-sulfonic acid as chelating agent was optimized. The effect of different experimental parameters such pH, ligand concentration (CQSA), accumulation potential (Eacc) and accumulation time (tacc) were studied to obtain a wide linear range, the highest sensitivity and the lowest detection limit. Ex-situ BiSPCE was analytically compared with a sputtered bismuth screen-printed electrode (BispSPE) under optimal conditions. The obtained analytical parameters suggest that ex-situ BiSPCE behaves much better than BispSPE and the first was selected for this study. Optimal parameters were pH=4.6; CQSA=10.0 to 20.0×10(-6)molL(-1); Eacc=-0.5V and tacc=60s. Peak area is proportional to Sb(III) concentration up to 100.0µgL(-1) (tacc 60s) and 45.0µgL(-1) (tacc 120s) range, with detection limits of 1.2µgL(-)(1) (tacc 60s) and 0.8µgL(-1) (tacc 120s). The relative standard deviation for a Sb(III) solution (20.0µgL(-1)) was 3.9% for ten successive assays. Thus, the effect of various interfering metal ions was studied and the methodology was validated using a spiked groundwater reference material with very satisfactory results.