RESUMO
Thin films of cobalt phthalocyanine (CoPc) were deposited onto solid substrates through physical vapor deposition (PVD) by thermal evaporation up to 60 nm thick to determine their molecular architecture and electrical properties. The growth was monitored using UV-Vis absorption spectroscopy, revealing a linear increase for absorbance versus thickness. PVD films were found in the crystalline alpha phase and with the CoPc molecules forming ca. 45 degrees in relation to the substrate surface. The film surface was fairly homogeneous at the micro and nanoscales, with the roughness at ca. 3 nm. DC and AC electrical measurements were carried out for devices built with distinct structures. Perpendicular contact was established by depositing 60 nm CoPc PVD films between indium tin oxide (ITO) and Al, forming a sandwich-type structure (ITO/CoPc/Al). The current versus DC voltage curve indicated a Schottky diode behavior with a rectification factor of 4.2. The AC conductivity at low frequencies increased about 2 orders of magnitude (10(-9) to 10(-7) S/m) with increasing DC bias (0 to 5 V) and the dielectric constant at 1 kHz was 3.45. The parallel contact was obtained by depositing 120 nm CoPc PVD film onto interdigitated electrodes, forming an IDE-structured device. The latter presented a DC conductivity of 5.5 x 10(-10) S/m while the AC conductivity varied from 10(-9) to 10(-1) S/m between 1 Hz and 1 MHz, respectively, presenting no dependence on DC bias. As proof-of-principle, the IDE-structured device was applied as gas sensor for trifluoroacetic acid (TFA).
RESUMO
The heat balance method is widely used to measure sap flow of different plant species. This work focused on the performance and applicability of the method, using 2-year old lemon plants, with 18 mm in diameter, the sensors were evaluated on potted-plants in a greenhouse under natural temperature and solar radiation conditions. The method performance was tested by comparing the computed mass flow with weight losses. A regression equation was used to analyse the data collected. The results showed that sensor precision reached 8% in the hourly scale and 11% in the daily scale. The time constant of 12 minutes indicated that the method was accurate to measure sap flow with good precision. Also we concluded that the method is adequate for agronomic and physiological use.
O método de balanço de calor é usado para monitorar fluxo de seiva em plantas de diversas espécies. Neste trabalho, estudou-se o desempenho e aplicabilidade do método, em mudas de limoeiro com diâmetros em torno de 18 mm. Os sensores foram avaliados em plantas envasadas, em casa de vegetação, sob condições naturais de temperatura e radiação solar. O desempenho do método foi avaliado comparando-se o fluxo de massa computado e as medidas gravimétricas de perda de massa, fazendo-se depois, análise de regressão. Os resultados indicam que os sensores tiveram uma precisão de 8% na escala horária e 11% na escala diária. A constante de tempo foi de 12 minutos, o que é um indicativo de que o método é adequado para medir fluxo de seiva em mudas de citros com boa precisão, e suficientemente apropriado para ser usado em aplicações agronômicas e fisiológicas.
RESUMO
The heat balance method is widely used to measure sap flow of different plant species. This work focused on the performance and applicability of the method, using 2-year old lemon plants, with 18 mm in diameter, the sensors were evaluated on potted-plants in a greenhouse under natural temperature and solar radiation conditions. The method performance was tested by comparing the computed mass flow with weight losses. A regression equation was used to analyse the data collected. The results showed that sensor precision reached 8% in the hourly scale and 11% in the daily scale. The time constant of 12 minutes indicated that the method was accurate to measure sap flow with good precision. Also we concluded that the method is adequate for agronomic and physiological use.
O método de balanço de calor é usado para monitorar fluxo de seiva em plantas de diversas espécies. Neste trabalho, estudou-se o desempenho e aplicabilidade do método, em mudas de limoeiro com diâmetros em torno de 18 mm. Os sensores foram avaliados em plantas envasadas, em casa de vegetação, sob condições naturais de temperatura e radiação solar. O desempenho do método foi avaliado comparando-se o fluxo de massa computado e as medidas gravimétricas de perda de massa, fazendo-se depois, análise de regressão. Os resultados indicam que os sensores tiveram uma precisão de 8% na escala horária e 11% na escala diária. A constante de tempo foi de 12 minutos, o que é um indicativo de que o método é adequado para medir fluxo de seiva em mudas de citros com boa precisão, e suficientemente apropriado para ser usado em aplicações agronômicas e fisiológicas.