RESUMO

In this work, the thermal properties of ternary Li3x Co7-4x Sb2+x O12 solid solutions are studied for different concentrations in the range 0 ≤ x ≤ 0.7. Samples are elaborated at four different sintering temperatures: 1100, 1150, 1200 and 1250 °C. The effect of increasing the content of Li+ and Sb5+, accompanied by the reduction of Co2+, on the thermal properties is studied. It is shown that a thermal diffusivity gap, which is more pronounced for low values of x, can be triggered at a certain threshold sintering temperature (around 1150 °C in this study). This effect is explained by the increase of contact area between adjacent grains. Nevertheless, this effect is found to be less pronounced in the thermal conductivity. Moreover, a new framework for heat diffusion in solids is presented that establishes that both the heat flux and the thermal energy (or heat) satisfy a diffusion equation and therefore highlights the importance of thermal diffusivity in transient heat conduction phenomena.

RESUMO

Cadmium is a major heavy metal found in polluted aquatic environments, mainly derived from industrial production processes. We evaluated the biosorption of solubilized Cd2+ using the extracellular polymeric substances (EPS) produced by Bacillus sp. MC3B-22 and Microbacterium sp. MC3B-10 (Microbactan); these bacteria were originally isolated from intertidal biofilms off the coast of Campeche, Mexico. EPS were incubated with different concentrations of cadmium in ultrapure water. Residual Cd2+ concentrations were determined by Inductive Coupled Plasma-Optic Emission Spectrometry and the maximum sorption capacity (Qmax) was calculated according to the Langmuir model. EPS were characterized by X-ray photoelectron spectroscopy (XPS) before and after sorption. The Qmax of Cd2+ was 97 mg g-1 for Microbactan and 141 mg g-1 for MC3B-22 EPS, these adsorption levels being significantly higher than previously reported for other microbial EPS. In addition, XPS analysis revealed changes in structure of EPS after biosorption and showed that amino functional groups contributed to the binding of Cd2+, unlike other studies that show the carbohydrate fraction is responsible for this activity. This work expands the current view of bacterial species capable of synthesizing EPS with biosorbent potential for cadmium and provides evidence that different chemical moieties, other than carbohydrates, participate in this process.

Assuntos

RESUMO

Chemical and biological weathering were studied on two historic churches in the city of Rio de Janeiro, Brazil. The churches exhibited contour scaling, granular disintegration and black crust development. High levels of SO4 were found in façade stones of one church, São José, with significant levels of lead and copper. This suggests that vehicle emissions were important in stonework decay. Both gypsum and halite were detected, typical of buildings influenced by marine atmosphere and fuel-polluted environment. There was little bioweathering on this church, although the filamentous cyanobacterium Scytonema detected could be involved in black crust production. The other church (Nossa Senhora da Gloria) showed strong granular disintegration, with a green coloration on internal surfaces of some flakes removed for study. This church showed lower levels of geochemically important weathering compounds but was more colonized by fungi and cyanobacteria. The latter were shown by scanning electron microscopy to grow within the granitic gneiss stone and were probably involved in dissolution and redeposition of minerals. This church is rather far from the intense traffic of the centre of Rio de Janeiro and from Guanabara Bay, source of marine aerosols; it is located upon a green hill, where plant-associated fungi and cyanobacteria can readily gain access to the façade. The results of this study show the importance of local environment on the relative proportions of chemical and biological weathering of stone.

Assuntos