RESUMO
The mechanical properties of the adhesive cement used in resin-bonded fixed partial dentures (RBFPD) can modify the clinical performance of the rehabilitation. The goal of this study was to evaluate the influence of the elastic modulus of different cements on the stress distribution in RBFPD using finite element analysis. For that an anterior 3-unit prosthesis was modeled based in a stereolithography file. The model was meshed with tetrahedral elements and materials considered isotropic, linearly elastic and homogeneous. The force applied to the palatal area of the lateral incisor (pontic) at 45° was 100 N. The cements used presented 7 different elastic modulus (E): 2, 6, 10, 14, 18, 22 or 26 GPa. The total deformation, von-Mises stress and maximum principal stress criteria were used to calculate the results. The lower tensile stress occurred in the cement layer with E = 2 GPa [25.6 (canine) and 16.32 MPa (incisor)]. For the prosthesis, the model with the lower tensile stress [287 (canine) and 248 MPa (incisor)] occurred when the cement presented E = 26 GPa. In this way, the stress concentration may have its magnitude modified depending on the stiffness of the cement. Since more flexible cements concentrate less tensile stress in its structure, but allow an increased displacement of the prosthesis, which is friable and rigid and ends up concentrating more tensile stress at its connector. In that way the clinician should avoid the use of adhesive cement with lower elastic modulus due to it increases the stress concentration in the ceramic.
Assuntos
Cimentos Dentários/farmacologia , Análise do Estresse Dentário , Prótese Adesiva , Cimentos de Resina/farmacologia , Módulo de Elasticidade , Análise de Elementos Finitos , Humanos , Incisivo , Estresse MecânicoRESUMO
Coloring in drinks decreases the color stability of composite restorations, reducing their longevity. The purpose of this in vitro study was to evaluate the effect of immersion media on color stability of seven different composite resins (Solidex - Shofu, Resilab-Wilcos, Signum - Heraeus, Epricord - Tokuyama, Adoro - Ivoclar Vivadent, Admira - Voco and Sinfony - 3MESPE). Seven resin-based composite specimens were prepared using a cylindrical teflon mold 2 mm thick and 10 mm in diameter Fifteen specimens of each resin were light-cured according to manufacturers' instructions and randomized into 3 groups (n= 5) according to immersion media: coffee, cola beverage and water A digital spectrophotometer Easy Shade (VITA) was used to evaluate the color changes at baseline and 7 days after immersion in each solution. Specimens were stored in the different staining media for 24 h/day during one week. The color differences were analyzed by two-way ANOVA and Tukey 's test (p< 0.05). Color change was observed after one week of immersion and there were statistical differences in staining, composite and interaction factors. The least staining was observed in Admira (deltaE= 3.934+/-0.814) and Resilab (deltaE= 3.993+/-0.735), followed by Adoro (deltaE= 4.044+/-1.001), Epri-cord (deltaE= 4.049+/-1.234), Signum (deltaE= 4.260+/-1.785), Solidex (deltaE=5,122+/-0.534) and Sinfony (deltaE=5.126+/-0.838). All of the composites tested except Adoro were susceptible to staining by substances present in coffee and cola, when stored in beverage for seven days. The lowest deltaE means were obtained with Admira.