RESUMO
This study investigated the resin-dentin bond strength (µTBS), degree of conversion (DC), and antibacterial potential of an innovative adhesive system containing a quaternary ammonium methacrylate polymer (QAMP) using in situ and in vitro assays. Forty-two human third molars were flattened until the dentin was exposed and were randomly distributed into three groups of self-etching adhesive systems: Clearfil™ SE Bond containing 5% QAMP (experimental group), Clearfil™ Protect Bond (positive control) and Clearfil™ SE Bond (negative control). After light curing, three 1 mm-increments of composite resin were bonded to each dentin surface. A total of thirty of these bonded teeth (10 teeth per group) was sectioned to obtain stick-shaped specimens and tested under tensile stress immediately, and after 6 and 12 months of storage in distilled water. Twelve bonded teeth (4 teeth per group) were longitudinally sectioned in a mesio-to-distal direction to obtain resin-bonded dentin slabs. In situ DC was evaluated by micro-Raman spectroscopy. In vitro DC of thin films of each adhesive system was measured using Fourier transform infrared spectroscopy. In vitro susceptibility tests of these three adhesive systems were performed by the minimum inhibitory/minimum bactericidal concentration (MIC/MBC) assays against Streptococcus mutans, Lactobacillus casei, and Actinomyces naeslundii. No statistically significant difference in µTBS was observed between Clearfil™ SE Bond containing 5% QAMP and Clearfil™ SE Bond (p>0.05) immediately, and after 6 and 12 months of water storage. However Clearfil™ Protect Bond showed a significant reduction of µTBS after 12 months of storage (p=0.039). In addition, QAMP provided no significant change in DC after incorporating into Clearfil™ SE Bond (p>0.05). Clearfil™ SE Bond containing 5% QAMP demonstrated MIC/MBC values similar to the positive control against L. casei and A. naeslundii and higher than the negative control for all evaluated bacterial strains. The use of QAMP in an adhesive system demonstrated effective bond strength, a suitable degree of conversion, and adequate antibacterial effects against oral bacteria, and may be useful as a new approach to provide long-lasting results for dental adhesives.
Assuntos
Cimentos Dentários/química , Metacrilatos/química , Polímeros/química , Compostos de Amônio Quaternário/química , Actinomyces/efeitos dos fármacos , Resinas Compostas/química , Resinas Compostas/farmacologia , Lâmpadas de Polimerização Dentária , Colagem Dentária , Cimentos Dentários/farmacologia , Humanos , Lacticaseibacillus casei/efeitos dos fármacos , Teste de Materiais , Testes de Sensibilidade Microbiana , Streptococcus mutans/efeitos dos fármacos , Propriedades de Superfície , Resistência à Tração , Fatores de TempoRESUMO
The increased resistance of Candida albicans to antibiotic therapy indicates the need for alternative treatments for oral candidiasis. Photodynamic therapy (PDT) has been researched as an alternative tool to inactivate pathogenic microorganisms. It uses a combination of a photosensitizer and a visible light source. This study evaluated the susceptibility of C. albicans to PDT and compared the efficacy of 100 microg/mL methylene blue (MB) and toluidine blue (TB) as photosensitizers. The light source was Indium-Gallium-Aluminum Phosphide (InGaAIP) laser at 53 J/cm2. Suspensions of 108 cells/mL of C. albicans were subject to PDT for 5 minutes in 96-well plates, then decimal dilutions were plated on Sabouraud Dextrose agar After 48h incubation at 37 degreesC, the number of CFU/mL were obtained and submitted to statistical analysis using Kolmogorov-Smirnov, ANOVA (p<0.0001) and Tukey tests. The results showed that MB or laser irradiation alone did not have statistically significant antifungal activity compared to the positive control group (p> 0. 05). Conversely, the number of viable C. albicans cells was reduced significantly after PDT using MB or mainly TB associated to diode laser irradiation. The data proved the efficacy of PDT against C. albicans cells, regardless of the photosensitizer used.