RESUMO
In this report, we describe a rapid and reliable process to bond channels fabricated in glass substrates. Glass channels were fabricated by photolithography and wet chemical etching. The resulting channels were bonded against another glass plate containing a 50-microm thick PDMS layer. This same PDMS layer was also used to provide the electrical insulation of planar electrodes to carry out capacitively coupled contactless conductivity detection. The analytical performance of the proposed device was shown by using both LIF and capacitively coupled contactless conductivity detection systems. Efficiency around 47,000 plates/m was achieved with good chip-to-chip repeatability and satisfactory long-term stability of EOF. The RSD for the EOF measured in three different devices was ca. 7%. For a chip-to-chip comparison, the RSD values for migration time, electrophoretic current and peak area were below 10%. With the proposed approach, a single chip can be fabricated in less than 30 min including patterning, etching and sealing steps. This fabrication process is faster and easier than the thermal bonding process. Besides, the proposed method does not require high temperatures and provides excellent day-to-day and device-to-device repeatability.
Assuntos
Eletroforese em Microchip/instrumentação , Vidro , Microtecnologia/métodos , Dimetilpolisiloxanos/química , Eletroforese em Microchip/economia , Desenho de Equipamento , Vidro/química , Fatores de TempoRESUMO
Prototypes of microfluidic paper-based separation devices with amperometric detection were developed and evaluated. Photolithography was used to make a gold electrochemical microcell on polyester and that microcell was coupled to a strip of paper where a chromatographic separation occurs. The device performance was demonstrated with the separation and quantification of uric and ascorbic acid in mixtures. The method provides an analytical alternative for the determination of compounds where low cost and simplicity are essential.