RESUMO

A facile and reproducible route that can lead to two-dimensional arrays of nanopores in thin polymer films is demonstrated. The formation of the pores in the polymer films involves breath figure phenomenon and occurs during the film deposition by spin coating. The formation of nanoporous thin films takes only few seconds, and the method does not require complex equipment or expensive chemicals. This method also constitutes a straightforward approach to control the size of the pores formed in thin films. Besides allowing control over the average pore size of the porous films, the use of dynamic deposition with the breath figure phenomenon causes the reduction in the pore size to nanometer scale. The nanoporous arrays obtained by the breath figure are applied as substrates for cell growth, and the effect of their nanopore size on cell growth was evaluated. Notably, it is found that cell viability is related to pore size, where 2D nanoporous structure is more beneficial for cell culture than 2D microporous structures. The change in the average pore size of the polymer films from 1.22 µm to 346 nm results in a threefold increase in cell viability.

Assuntos

Proliferação de Células , Nanotecnologia/instrumentação , Animais , Sobrevivência Celular , Células Cultivadas , Chlorocebus aethiops , Nanoporos , Tamanho da Partícula , Polímeros/química , Propriedades de Superfície , Células Vero

RESUMO

Thermosensitive surfaces were developed by the grafting of a thin layer of PNIPAAm through an UV-induced photopolymerization reaction of vinyl monomers with a free radical-activated polypropylene (PP) surface. PNIPAAm layer covering the PP surface corrected, to some extension, both depressions and fissures of the previously modified PP surfaces. The layered surfaces have morphological characteristic different from those of the non-layered surfaces, and their thickness was dependent on irradiation time. Water contact angles of the layered surfaces revealed a transition at approximately 33.5-36.5 °C as a result of a response to the variation of temperature. There was an increase in the values of the contact angles with an increase in temperature from 26 °C to 44 °C, revealing the nature both hydrophilic and hydrophobic of the surfaces due to a conformational rearrangement of PNIPAAm exposing its isopropyl groups to the liquid drop. This work offers a chemically stable thermosensitive surface (because it is covalently structured) with great potential for use as sensors and actuators.