RESUMO
Aims: To compare the shaping efficiency of the XP-endo Shaper with or without glide path preparation with sequenced Scout Race files in J-shaped resin blocks Material and Methods: Forty simulated J-shaped root canals were classified into two groups (n=20). While the root canals were shaped with XPS after a glide path was created with Scout Race files in Group 1, the same procedures were done without the glide path preparation in Group 2. The pre-and post-instrumentation images were taken and superimposed. Transportation value (TV), centering ability (CA) and the total amount of resin removed (TRR) was calculated by using the obtained images with Adobe Photoshop CS5 software. These parameters were calculated based on 18 reference points (9 inner/9 outer walls) with 1-mm intervals according to 3 sections (coronal, middle, and apical of the canals). The data were analyzed with Kruskal-Wallis and then Dunn's multiple comparison tests (p ≤ 0.05). Results: More resin was removed in Group 2 apical and coronal sections than in Group 1 (p=0.036). In Group 2, a higher transportation value was obtained in apical and middle sections compared to Group 1 (p<0.001). Group 1 showed a higher centering ratio in apical and middle sections than in Group 2 (p<0.001). The centering ability of the instruments was decreased in the curvature part (middle section) of the canals. Conclusions: Within the limits of this study, glide path preparation using Scout Race instruments improved the shaping ability of XPS instrument by leading to less transportation and maintaining centering ability.
RESUMO
OBJECTIVES: The aim of this study is to evaluate the effect of using gel and solution forms of NaOCI during the chemomechanical preparation of the root canals on postoperative pain at different time intervals. METHODOLOGY: 114 patients with mandibular molar teeth and symptomatic irreversible pulpitis were included in the study. All patients were divided into two groups based on the irrigant used during root canal preparation (n=57): Group 1, 5.25% NaOCI, Group 2, 5.25% NaOCI gel. All groups were filled with gutta-percha and AH Plus root canal sealer using single-cone technique. VAS scale (1-10) was used for postoperative pain assessment. After endodontic treatment, all patients were asked to record their postoperative pain levels at the 6th, 24th, 48th, 72nd hours, and 1 week later. The data were analyzed using Chi-Squared, Independent Samples T, Cochran Q and Friedman tests. RESULTS: Statistically significant difference was not found between the distributions of pain levels at different times according to the groups (p>0.050). A statistically significant difference was observed between the distributions of pain levels measured at different times in the solution group (p<0.001). A statistically significant difference was found between the distributions of pain levels measured at different times in the gel group (p<0.001). In both groups, highest postoperative pain levels occurred in the first 6 hours. Pain levels of the gel group as 38,5% mild, 17.3% moderate, 5.8% severe and pain levels of the solution group were obtained as 46.2% mild, 26.9% moderate, 9.6% severe at the 6th hour. CONCLUSIONS: The use of the gel form of NaOCI during the chemomechanical preparation of the root canals showed similar postoperative pain when compared to the solution form.
Assuntos
Materiais Restauradores do Canal Radicular , Hipoclorito de Sódio , Cavidade Pulpar , Guta-Percha , Humanos , Dente Molar , Dor Pós-Operatória/prevenção & controle , Obturação do Canal Radicular , Preparo de Canal RadicularRESUMO
Abstract Objectives The aim of this study is to evaluate the effect of using gel and solution forms of NaOCI during the chemomechanical preparation of the root canals on postoperative pain at different time intervals. Methodology 114 patients with mandibular molar teeth and symptomatic irreversible pulpitis were included in the study. All patients were divided into two groups based on the irrigant used during root canal preparation (n=57): Group 1, 5.25% NaOCI, Group 2, 5.25% NaOCI gel. All groups were filled with gutta-percha and AH Plus root canal sealer using single-cone technique. VAS scale (1-10) was used for postoperative pain assessment. After endodontic treatment, all patients were asked to record their postoperative pain levels at the 6th, 24th, 48th, 72nd hours, and 1 week later. The data were analyzed using Chi-Squared, Independent Samples T, Cochran Q and Friedman tests. Results Statistically significant difference was not found between the distributions of pain levels at different times according to the groups (p>0.050). A statistically significant difference was observed between the distributions of pain levels measured at different times in the solution group (p<0.001). A statistically significant difference was found between the distributions of pain levels measured at different times in the gel group (p<0.001). In both groups, highest postoperative pain levels occurred in the first 6 hours. Pain levels of the gel group as 38,5% mild, 17.3% moderate, 5.8% severe and pain levels of the solution group were obtained as 46.2% mild, 26.9% moderate, 9.6% severe at the 6th hour. Conclusions The use of the gel form of NaOCI during the chemomechanical preparation of the root canals showed similar postoperative pain when compared to the solution form.
Assuntos
Humanos , Materiais Restauradores do Canal Radicular , Hipoclorito de Sódio , Dor Pós-Operatória/prevenção & controle , Obturação do Canal Radicular , Preparo de Canal Radicular , Polpa Dentária , Cavidade Pulpar , Dente MolarRESUMO
OBJECTIVES: To investigate the effectiveness of root canal irrigation with chitosan on the dislocation resistance of a root canal sealer (MTA Fillapex) in vitro, measured by the push-out bond strength test. MATERIALS AND METHODS: Root canals of mandibular premolars (n = 57) were prepared using rotary files with 5.25% sodium hypochlorite as the irrigant during instrumentation. Following this, the specimens were randomly divided into three groups (n = 19) based on the final irrigant: group 1, 0.2% chitosan solution; group 2, 17% EDTA solution; group 3, saline. Three specimens from each group were analyzed using scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS). The remaining specimens of each group were divided into two subgroups (n = 8) based on the method of agitation of the final irrigants (chitosan/EDTA/saline): subgroup A, sonic (Endoactivator, Dentsply Maillefer); subgroup B, no activation (control). After irrigation, all specimens obturated with a commercial mineral trioxide aggregate-resin hybrid sealer (MTA Fillapex, Angelus, Londrina, Brazil). Dislocation resistance was measured using the push-out bond strength test after 3 weeks. The data were analyzed using Kruskal-Wallis test (P = 0.05). RESULTS: Immaterial of the irrigant agitation, groups irrigated with chitosan showed significantly higher bond strength values than those irrigated with EDTA (P < 0.05). Groups irrigated with saline showed the least bond strength values (P < 0.05). When EDTA was used, sonic agitation significantly improved the bond strength of the sealer, compared to the control (P < 0.05). There was no significant difference between sonic agitation and the control when chitosan solution was used as the final irrigant (P > 0.05). The nitrogen/carbon ratio was significantly higher in chitosan groups compared to the control group (P < 0.05). CONCLUSION: This study provides the first evidence that chitosan irrigation improves the dislocation resistance of MTA-resin hybrid root canal sealer, compared to EDTA and saline irrigation. CLINICAL RELEVANCE: Chitosan-based irrigation has been previously shown to demonstrate anti-biofilm properties in the root canal. The present study demonstrates that chitosan can improve the bond strength of a root filling material, which may contribute to better sealing of the root canal system.