RESUMO
Tons of crude oil were found on the Brazilian coast in 2019, and studies assessing its chemical composition are still scarce. This study aimed to develop a new and simple technique of cold vapor generation using infrared irradiation coupled with atomic absorption spectrometry to determine mercury content in sediments contaminated by crude oil. Experimental conditions were evaluated, including formic acid concentration, reactor temperature, and carrier gas flow rate. The accuracy of the method was validated by comparison with mercury contents in a certified reference material (PACS-2). The detection limit was found to be 0.44 µg kg-1. The developed method was applied to determine the total mercury content in marine sediment samples collected from beaches in Ceará State. Mercury concentrations ranged from 0.41 to 0.95 mg kg-1. The proposed method is efficient, simple, low-cost, and adequate for its purpose.
Assuntos
Monitoramento Ambiental , Sedimentos Geológicos , Mercúrio , Poluição por Petróleo , Poluentes Químicos da Água , Mercúrio/análise , Sedimentos Geológicos/química , Brasil , Poluentes Químicos da Água/análise , Monitoramento Ambiental/métodos , Poluição por Petróleo/análise , Petróleo/análise , Espectrofotometria AtômicaRESUMO
The Ocean decade (2021-2030) for sustainable development proclaimed in 2017 by the UN, seeks to promote and conserve the sustainable use of oceans, seas, and marine resources. For this, the distribution of n-alkanes, polycyclic aromatic hydrocarbons (PAHs), and biomarkers, in sediments from the Fortaleza coastal zone (Mucuripe harbor (MH) and Inner Continental shelf (ICS)) were used to assess the impacts of anthropogenic activities in the area. The concentrations of total n-alkanes (Σ16 n-alkanes) in MH and ICS sediments varied from 35.9 to 94.9 and 17.9 to 197.3 µg g-1, respectively, while the isoprenoids phytane and pristane in MH and ICS sediments ranged from 0.1 to 1.69 ug g-1 and from 0.14 and 1.20 µg g-1, respectively. Most of the sediment samples presented carbon preference index (CPI) values close to unity, indicating that the area is submitted to petroleum-related sources. The concentrations of Σ16 PAHs in MH and ICS sediments varied from 87.0 to 562.0 and 98 to 288.0 ng g-1. This work presents the first investigation of the petroleum biomarkers hopanes and steranes in the Fortaleza coastal zone, in which ΣBiomarkers varied from 0.10 to 1.79 and 0.02 to 0.24 ug g-1 in MH and ICS sediments, respectively. The presence at stations of biomarkers also indicates petrogenic input. The diagnosis of the distribution of pollutants in the investigated zones of the Fortaleza coast suggests contamination from urban areas and oil spills and vessel traffic.