RESUMO
OBJECTIVE: Evaluate the color and translucency of a nanoceramic resin subjected to hygiene practices and immersion in coffee over time. MATERIALS AND METHODS: Specimens (n = 80, HT and LT, 0.5-mm thick) of a nanoceramic resin were obtained and were divided in groups according to the simulated oral hygiene: no intervention (NT), brushing with an electric brush and water (BN), brushing with an electric brush and toothpaste for 10 s (BT), and immersion in mouthwash for 30 s (MW). Oral hygiene practices were repeated after staining in coffee solution for 15, 48, 336, 1440, 8640, and 35,040 min. Spectral wavelengths were recorded with a spectrophotometer at each time. ∆E00, ∆L', ∆C', ∆H', and TP00 were calculated by CIEDE2000 and were evaluated by 2-way ANOVA, repeated measures ANOVA, and Tukey's HSD test (α = 0.05). RESULTS: ANOVA showed significance among factors for ΔE00 (p < 0.05), with higher ΔE00 for NT-HT (11.7) and NT-LT (11.2). After T6 (2-year simulation), the lowest values were found for BT-HT (5.3) and BT-LT (4.9). All groups showed a reduction in lightness and translucency and increased chroma and hue. However, the smallest variations were found in the BT groups (p < 0.05). CONCLUSIONS: Brushing with toothpaste effectively minimized the color change of NCRs caused by coffee staining. CLINICAL SIGNIFICANCE: Oral hygiene practices, such as brushing with toothpaste, might be important to minimize staining of nanoceramic resin restorations, especially in patients who frequently consume coffee.
Assuntos
Café , Cor , Higiene Bucal , Cerâmica/química , Humanos , Espectrofotometria , Escovação Dentária , Cremes Dentais/químicaRESUMO
OBJECTIVE: The objective of this study was to assess the influence of immediate dentin sealing (IDS) on the fatigue behavior of laminate occlusal veneers fabricated with CAD/CAM lithium disilicate ceramic and resin composite. METHODS: Forty sound human molars were prepared and randomly divided into 4 groups (n = 10): RC-IDS+ (IDS and resin composite occlusal laminate veneer); RC-IDS- (resin composite occlusal laminate veneer without IDS); LD-IDS+ (IDS and lithium disilicate laminate veneer); LD-IDS- (lithium disilicate occlusal laminate veneer without IDS). The restorations were obtained using a digital workflow. After surface conditioning and bonding, thermocycling and accelerated fatigue tests (20 Hz, 5000 cycles with an initial load of 300 N, step-size of 100 N for 10,000 cycles, up to 1000 N, and then a step-size of 50 N until failure) were conducted. Fatigue data were recorded for both outcomes (crack or fracture) and statistically analyzed. Fractographic and adhesive interface analysis were conducted. RESULTS: The indirect resin composite groups showed better fatigue behavior compared to lithium disilicate. IDS only had a positive effect for the survival of resin composite restorations for the 'fracture' outcome. Evident presence of micro-gaps at the adhesive interface in the LD-IDS- group could be noted. SIGNIFICANCE: Immediate dentin sealing improved fatigue resistance behavior of resin composite occlusal veneers. However, this effect was not observed in lithium disilicate veneers.