RESUMO
In this paper, we propose a highly sensitive temperature sensor based on two cascaded Mach-Zehnder interferometers (MZIs) that work using the Vernier effect. The all-fiber MZIs were assembled by splicing a segment of capillary hollow-core fiber (CHCF) between two sections of multimode fibers (MMFs). This cascaded configuration exhibits a temperature sensitivity of 1.964 nm/°C in a range from 10 to 70 °C, which is ~67.03 times higher than the sensitivity of the single MZI. Moreover, this device exhibits a high-temperature resolution of 0.0153 °C. A numerical analysis was carried out to estimate the devices' temperature sensitivity and calculate the magnification of the sensitivity produced by the Vernier effect. The numerical results have an excellent agreement with the experimental results and provide a better insight into the working principle of the MZI devices. The sensor's performance, small size, and easy fabrication make us believe that it is an attractive candidate for temperature measurement in biological applications.
Assuntos
Interferometria , Refratometria , Temperatura Alta , TemperaturaRESUMO
In this paper, we propose and experimentally demonstrate a simple technique to enhance the curvature sensitivity of a bending fiber optic sensor based on anti-resonant reflecting optical waveguide (ARROW) guidance. The sensing structure is assembled by splicing a segment of capillary hollow-core fiber (CHCF) between two single-mode fibers (SMF), and the device is set on a steel sheet for measuring different curvatures. Without any surface treatment, the ARROW sensor exhibits a curvature sensitivity of 1.6 dB/m-1 in a curvature range from 0 to 2.14 m-1. By carefully coating half of the CHCF length with polydimethylsiloxane (PDMS), the curvature sensitivity of the ARROW sensor is enhanced to -5.62 dB/m-1, as well as an increment in the curvature range (from 0 to 2.68 m-1). Moreover, the covered device exhibits a low-temperature sensitivity (0.038 dB/°C), meaning that temperature fluctuations do not compromise the bending fiber optic sensor operation. The ARROW sensor fabricated with this technique has high sensitivity and a wide range for curvature measurements, with the advantage that the technique is cost-effective and easy to implement. All these features make this technique appealing for real sensing applications, such as structural health monitoring.
RESUMO
We propose a microfluidic method to measure the refractive index of liquids. This method is based on the dynamic focusing by a capillary when liquids with different refractive indexes are inserted into it. Fabrication of such a refractometer has been done by encapsulating two fibers and a capillary. A calibration method is proposed.
RESUMO
We show that it is possible to make biconvex microlenses at the end of capillary tubes. These lenses can be fixed to the flat end of photonic crystal fibers and can collimate their light.
RESUMO
A large-mode-area holey fiber was tapered to a point in which the airholes collapsed, and its dependence on temperature and strain was studied. The transmission spectrum of such a fiber exhibits a series of peaks owing to the interference between the modes of the solid taper waist. We found that the interference peaks shifted to shorter wavelengths as the taper was elongated. However, the peaks were insensitive to temperature. The fabrication and advantages of our novel wavelength-encoded temperature-independent strain sensor compared with other optical fiber strain sensors are discussed.