RESUMO

AIM: Our objective was to compare guided virtual surgery to conventional surgery in terms of angular deviation of single dental implants placed in the posterior mandible. MATERIALS AND METHODS: Patients with bilateral homologous single teeth missing in the posterior mandible were eligible for this split-mouth randomized clinical trial. Cone beam computed tomography (CBCT) was performed for virtual planning of implant position and manufacturing of the stereolithographic guides. One week after the surgery, a second CBCT scan was superimposed to the initial planning. Primary endpoint was the angular deviation between virtual and clinical implant position. Secondary endpoints were linear deviations and patient-reported outcomes collected with a questionnaire. RESULTS: Data from 12 patients were available for analysis. Angular deviation was significantly lower using stereolithographic guides as compared to conventional guides (2.2 ± 1.1° vs. 3.5 ± 1.6°, p = .042). Linear deviations were similar for both techniques in the coronal (2.34 ± 1.01 vs. 1.93 ± 0.95 mm) and apical (2.53 ± 1.11 vs. 2.19 ± 1.00 mm) dimensions (p Ëƒ .05). The selection of the surgical technique had no significant impact on the patient-reported outcomes. CONCLUSION: Our data suggest that the angular discrepancy between the virtual and the clinical implant position is slightly lower when using stereolithographic guides as compared to conventional guides.

Assuntos

Implantes Dentários , Cirurgia Assistida por Computador , Desenho Assistido por Computador , Tomografia Computadorizada de Feixe Cônico , Implantação Dentária Endóssea , Humanos , Imageamento Tridimensional , Boca , Planejamento de Assistência ao Paciente

RESUMO

OBJECTIVES: After tooth loss, dimensional alterations on the alveolar bone ridge can occur that can negatively affect the placement of dental implants. The purpose of this study was to evaluate the synthesis, and mechanical properties of ß-tricalcium phosphate (ß-TCP) scaffolds coated with bioabsorbable polymers, namely, collagen and poly (D, L-lactic acid) (PDLLA). MATERIALS AND METHODS: ß-TCP powder was obtained by reactive milling and then characterized by X-ray diffraction and scanning electron microscopy/energy dispersive X-ray spectroscopy (SEM/EDS). ß-TCP scaffolds were obtained by replica method, in which polyurethane foams are immersed in ß-TCP suspension and thereafter submitted to a thermal treatment to remove the polyurethane and sinter the ceramic. Type-I collagen or PDLLA were used to coat the ß-TCP scaffolds by dip-coating method. Scaffolds were separated in four groups depending on the coating material: noncoated (Group A), double immersion in collagen (Group B), double immersion in PDLLA (Group C), and ten immersions in PDLLA (Group D). Samples were characterized by compressive tests and SEM/EDS. Data were statistically analyzed through two-way ANOVA (p = 0.05). RESULTS: Chemical and microscopic analyses revealed proper morphology and chemical composition of powder particles and scaffolds with or without polymeric coatings. Scaffolds coated with PDLLA showed higher compressive strength (0.11 ± 0.054 MPa) than those of collagen (0.022 ± 0.012 MPa) or noncoated groups (0.024 ± 0.012 MPa). CONCLUSIONS: The coating method of ß-TCP with PDLLA revealed a potential strategy to increase the mechanical strength of porous ceramic materials while collagen can enhance cell migration.