RESUMO
The immobilization of Re(I) complexes onto metal oxide surfaces presents an elegant strategy to enhance their stability and reusability toward photocatalytic CO2 reduction. In this study, the photocatalytic performance of fac-[ClRe(CO)3(dcbH2)], where dcbH2 = 4,4'-dicarboxylic acid-2,2'-bipyridine, anchored onto the surface of 1%m/m CuO/Nb2O5 was investigated. Following adsorption, the turnover number for CO production (TONCO) in DMF/TEOA increased significantly, from ten in solution to 370 under visible light irradiation, surpassing the TONCO observed for the complex onto pristine Nb2O5 or CuO surfaces. The CuO/Nb2O5 heterostructure allows for efficient electron injection by the Re(I) center, promoting efficient charge separation. At same time CuO clusters introduce a new absorption band above 550 nm that contributes for the photoreduction of the reaction intermediates, leading to a more efficient CO evolution and minimization of side reactions.
RESUMO
Graphite sheet (GS) electrodes are flexible and versatile substrates for sensing electrochemical; however, their use has been limited to incorporate (bio)chemical modifiers. Herein, we demonstrated that a cold (low temperature) CO2 plasma treatment of GS electrodes provides a substantial improvement of the electrochemical activity of these electrodes due to the increased structural defects on the GS surface as revealed by Raman spectroscopy (ID/IG ratio), and scanning electron microscopy images. XPS analyses confirmed the formation of oxygenated functional groups at the GS surface after the plasma treatment that are intrinsically related to the substantial increase in the electron transfer coefficient (K0 values increased from 1.46 × 10-6 to 2.09 × 10-3 cm s-1) and with reduction of the resistance to charge transfer (from 129.8 to 0.251 kΩ). The improved electrochemical activity of CO2-GS electrodes was checked for the detection of emerging contaminant species, such as chloramphenicol (CHL), ciprofloxacin (CIP) and sulphanilamide (SUL) antibiotics, at around + 0.15, + 1.10 and + 0.85 V (versus Ag/AgCl), respectively, by square wave voltammetry. Limit of detection values in the submicromolar range were achieved for CHL (0.08 µmol L-1), CIP (0.01 µmol L-1) and SFL (0.11 µmol L-1), which enabled the sensor to be successfully applied to natural waters and urine samples (recovery values from 85 to 119%). The CO2-GS electrode is highly stable and inexpensive ($0.09 each sensor) and can be easily inserted in portable 3D printed cells for environmental on-site analyses.
Assuntos
Cloranfenicol , Grafite , Ciprofloxacina , Sulfanilamida , Dióxido de Carbono , EletrodosRESUMO
Material processing has become essential for the proper control, tuning and consequent application of the properties of micro/nanoparticles. In this case, we report herein the capability of the microwave-assisted hydrothermal (MAH) method to prepare the SrTiO3 compound, as a case study of inorganic compounds. Analyses conducted by X-ray diffraction, X-ray photoelectron and X-ray absorption spectroscopies confirmed that the MAH route enables the formation of pristine SrTiO3. The results indicated that the combination of thermal and non-thermal effects during the MAH treatment provides ideal conditions for an efficient and rapid synthesis of pristine SrTiO3 mesocrystals. Scanning electron microscopy images revealed a cube-like morphology (of ca. 1 µm) formed via a self-assembly process, influenced by the MAH time. Additionally, photoluminescence measurements revealed a broad blue emission related to intrinsic defects, which decreased with the MAH synthesis time.
RESUMO
Strontium titanate nanoparticles have attracted much attention due to their physical and chemical properties, especially as photocatalysts under ultraviolet irradiation. In this paper, we analyze the effect of heating rate during the crystallization process of SrTiO3 nanoparticles in the degradation of organic pollutants. The relationship between structural, morphological and photocatalytic properties of the SrTiO3 nanoparticles was investigated using different techniques. Transmission electron microscopy and N2 adsorption results show that particle size and surface properties are tuned by the heating rate of the SrTiO3 crystallization process. The SrTiO3 nanoparticles showed good photoactivity for the degradation of methylene blue, rhodamine B and methyl orange dyes, driven by a nonselective process. The SrTiO3 sample with the largest particle size exhibited higher photoactivity per unit area, independent of the molecule to be degraded. The results pointed out that the photodegradation of methylene blue dye catalyzed by SrTiO3 is caused by the action of valence band holes (direct pathway), and the indirect mechanism has a negligible effect, i.e. degradation by O2 (-â¢) and (â¢) OH radicals attack.