RESUMO

In this work, a CE equipment, online hyphenated to an IT MS analyzer by a linear sheath liquid interface promoting ESI, was used to develop a method for quantitative determination of amino acids. Under appropriate conditions (BGE composition, 0.8% HCOOH, 20% CH3OH; sheath liquid composition, 0.8% HCOOH, 60% methanol; V ESI, +4.50 kV), analytical curves of all amino acids from 3 to 80 mg/L were recorded presenting acceptable linearity (r >0.99). LODs in the range of 16-172 micromol/L were obtained. BSA, a model protein, was submitted to different hydrolysis procedures (classical acid and basic, and catalyzed by the H+ form of a cation exchanger resin) and its amino acid profiles determined. In general, the resin-mediated hydrolysis yields were overall similar or better than those obtained by classical acid or basic hydrolysis. The resulting experimental-to-theoretical BSA concentration ratios served as correction factors for the quantitation of amino acids in Brazil nut resin generated hydrolysates.

Assuntos

RESUMO

Different beta-cyclodextrines (beta-cyclodextrin, heptakis (2,3,6-tri-O-methyl)-beta-cyclodextrin, hydroxypropyl-beta-cyclodextrin, and sulfated beta-cyclodextrin) were investigated as additives for the enantioselective separation of the R-form from rivastigmine ((S)-N-ethyl-3-[(1-dimethylamino) ethyl]-N-methyl-phenyl carbamate), contained as impurity in this drug, which is used for the treatment of Alzheimer's disease. Electrophoresis was performed in an acidic background electrolyte (triethanolammonium phosphate, 75 mM, pH 2.5) with various concentrations of the additives. The electrophoretic mobilities measured are typical functions of the additive concentrations, with complex constants (obtained by fitting the appropriate binding curve on the data) ranging between about 180 and 770 M(-1). Best separation was obtained with 7.5 mM beta-cyclodextrin, with the R-enantiomer as impurity migrating before the main S-compound. Intra- and interday reproducibility (n = 6 and 18, respectively) of migration time and peak area was in the low percentage range, linearity of the calibration line for the quantitation of the impurity in the range between 2.3 and 50 microg/ml, expressed by the linear correlation coefficient, was 0.9998. The limits of detection and quantitation, respectively, were 0.7 and 2.3 microg/ml, corresponding to 0.05 and 0.15%, m/m of the R- relative to the S-compound. Analysis can be carried out at 18 degrees C in less than 19 min.

Assuntos

RESUMO

Retention (capacity) factors (k' values) of immunosuppressive drugs were determined in microemulsion electrokinetic chromatography (MEEKC) systems as a tool for the indirect estimation of partition coefficients (POW) between 1-octanol and water. The microemulsions were based on phosphatidylcholine (PC) and bile acids (BAs) as biosurfactants and isopropyl myristate (IPM) as oil. Immunosuppressants were azathioprine (AZA), mycophenolate mofetil (MMF), tacrolimus (FK506) and cyclosporine A (CyA). Capacity factors of the analytes were determined from electrophoretic mobilities using an aqueous phosphate buffer (20 mM; pH 7.5) for all the systems. Retention was compared with that in the most commonly used microemulsion based on sodium dodecyl sulphate (SDS). logPOW versus logk' calibration lines were constructed using reference compounds with known POW. In addition, data of logPOW of the immunosuppressants were determined by partitioning between octanol and water, and were calculated by the aid of computer program. A different sequence of logPOW for two analytes was found in the biosurfactant-based systems compared with the SDS-containing one. Excellent agreement was observed between the logPOW values derived from the microemulsions containing deoxycholate compared with the data determined by partitioning between octanol and water. It was concluded that the retention factors in the systems with biosurfactants are good estimators for the partitioning in biological systems.

Assuntos

RESUMO

Although electrochromatography in packed beds or monolithic columns has gained enormous interest, techniques based on charged pseudostationary phases like micelles are of high practical importance in electrically driven separation science. However, nonmicellar alternatives, e.g., using charged soluble polymers or smaller additives are still attractive, as they allow high concentrations of organic solvents, and their application is not limited by the critical micellar concentration. This review discusses the developments in the field of electrokinetic chromatography with these additives in the last three years, covering ionic polymeric pseudostationary phases, dendrimers and so-called micelle polymers, but also small molecules which implement separation selectivity due to their specific interaction with the analytes.

Assuntos

RESUMO

Five electrokinetic chromatography systems were compared concerning retention behavior and lipophilicity. Comparison was based on capacity (retention) factors of some steroidal drugs, and on log P(OW) values derived by the aid of reference substances. In all systems the aqueous buffer consisted of phosphate (20 mM, pH 7.5). Two systems had micelles, three systems microdroplets as negatively charged pseudostationary phases. The micelles were formed by sodium dodecyl sulfate (SDS) and sodium cholate, respectively. One microemulsion consisted (as usual) from octane as oil, butanol as cosurfactant and SDS as charged tenside. Two microemulsions were made from biosurfactants (phosphatidylcholine, isopropylmyristate) to better simulate biopartitioning of the drugs. Even for noncharged analytes a change in migration sequence and thus in log P(OW) was observed for the systems consisting of the biosurfactants, compared to the others. For the former systems, log P(OW) derived from the capacity factors agree for all analytes with those obtained from calculation by computer software based on the structure of the drugs, and with experimental data directly obtained from octanol/water partitioning.

Assuntos

RESUMO

Mobilities of different chromatographic particles obtained from two electrokinetic methods were determined and compared. The particles were all based on porous silica, between 3 and 15 microm diameter, and were either native, or derivatized. As intermediate of chemical modification 3-mercaptopropyl-modified silica particles (TP-silica) are obtained. These particles were finally transformed into weakly basic anion exchangers with O-9-(tert-butylcarbamoyl)quinine (tBuCQN) as chiral selector. The electrophoretic mobility of the particles was determined from their migration velocity in an electric field using microelectrophoresis. Electrokinetic chromatography with a capillary column packed with the same particles was used to measure the electroosmotic flow generated. All measurements were carried out in background electrolytes of equal ionic strength (10(-2) mol/L), at pH varying between 3.5 and 9.5. From these data a rough estimation of the zeta-potential was made, taking Helmholtz-Smoluchowski conditions into consideration. With both methods the zeta-potential of the native silica particles is negative throughout, and its value increases with pH. The weakly basic tBuCQN particles have positive zeta-potentials at pH lower than about 7.5, but exhibit a negative zeta-potential above this pH, indicating the dominating effect of residual silanol groups at the silica surface. The zeta-potential for these anion-exchange particles ranged between +30 and -40 mV. The zeta-potentials derived with electrophoresis and electroosmosis agree, showing the adequacy of the approach, although many limitations must be taken into account in the treatment of the electrokinetic phenomena in such porous systems. These restrictions in interpreting mobility and zeta-potential were discussed.

Assuntos

Assuntos