RESUMO
Food packaging faces the negative impact of synthetic materials on the environment, and edible coatings offer one alternative from filmogenic suspensions (FS). In this work, an active edible FS based on chitosan (C) and quinoa protein (QP) cross-linked with transglutaminase was produced. Thyme (T) and rosemary (R) essential oils (EOs) were incorporated as antimicrobial agents. Particle size, Z potential, and rheological parameters were evaluated. The antimicrobial activity against Micrococcus luteus (NCIB 8166) and Salmonella sp. (Lignieres 1900) was monitored using atomic force microscopy and image analysis. Results indicate that EOs incorporation into C:QP suspensions did not affect the Z potential, ranging from -46.69 ± 3.19 mV to -46.21 ± 3.83 mV. However, the polydispersity index increased from 0.51 ± 0.07 to 0.80 ± 0.04 in suspensions with EO. The minimum inhibitory concentration of active suspensions against Salmonella sp. was 0.5% (v/v) for thyme and 1% (v/v) for rosemary. Entropy and fractal dimension of the images were used to confirm the antimicrobial effect of EOs, which modified the surface roughness.
RESUMO
Recently, the use of different types of natural fibers to produce paper and textiles from agave plants has been proposed. Agave atrovirens can be a good source of cellulose and lignin; nevertheless, the microstructural changes that happen during delignification have scarcely been studied. The aim of this work was to study the microstructural changes that occur during the delignification of agave fibers by means of microscopy techniques and image analysis. The fibers of A. atrovirens were obtained from leaves using convective drying, milling, and sieving. Fibers were processed using the Acetosolv pulping method at different concentrations of acetic acid; increasing acid concentration promoted higher levels of delignification, structural damage, and the breakdown of fiber clumps. Delignification followed by spectrometric analysis and microstructural studies were carried out by light, confocal laser scanning and scanning electron microscopy and showed that the delignification process follows three stages: initial, bulk, and residual. Microscopy techniques and image analysis were efficient tools for microstructural characterization during delignification of agave fibers, allowing quantitative evaluation of the process and the development of linear prediction models. The data obtained integrated numerical and microstructural information that could be valuable for the study of pulping of lignocellulosic materials.