RESUMO
The use of the angular spectrum method (ASM) to simulate the reflection of airborne ultrasound beams from a thin membrane separating air from a mixture of air and another gas is examined. The main advantage of this method is its high computing speed and efficiency for practical design calculations, suitable for sensing applications. The implemented ASM code is validated against custom Rayleigh integral code in a pure propagation simulation. In addition, ultrasound beam reflection calculations using ASM with finite element numerical results and experimental measurements are compared, finding good agreement in both cases. Then, ASM is used to estimate the sensitivity of specular reflection signals to variations in the composition of the incidence medium as a function of the angle of incidence. Conditions for which a reflection signal using inexpensive commercial ultrasound emitter/receiver at 40 kHz, in a simple configuration, offer a high enough sensitivity suitable for monitoring air quality indoors are found.
RESUMO
Today, visual classification of the degree of lipemia in blood samples is frequently performed in clinical laboratories. However, achieving standardization of this classification at low cost and with fewer resources is an objective that is still under development. In this work, a comparison is made between the visual inspection and optical measurements of blood plasma for quantifying lipemia. The plasma refractive index's real part was measured using an Abbe refractometer and transmittance measurements were made at a 589 nm wavelength and wavelengths ranging from 320 to 1100 nm in the spectral region, respectively. Taking the slope of the transmittance spectrum at two specific wavelengths, it is possible to establish a more standardized selection criterion and implement it quickly using low-cost optical devices. Furthermore, using the proposed transmittance-spectrum-slope method, statistically significant differences (p < 0.05) were found between healthy blood samples and lipemia 1, 2, 3, and 4. However, there were no statistical differences between lipemia 1 and 2.
RESUMO
We study the optical reflectivity of confined colloidal films as a function of the angle of incidence in an internal reflection configuration. Two effective medium models and an extended coherent-scattering model for thin colloidal films are compared against experimental measurements with gold, latex, and titanium dioxide colloids. A derivation of the coherent scattering model for confined colloidal films used in this work is presented in a comprehensive way. The model lies within the framework of the multiple-scattering theory and is valid for any angle of incidence and for colloids of small or large particles compared to the wavelength of light, however, only for small and moderately small particles' volume fraction. Reflectivity versus angle of incidence curves for an opaque colloidal film in an internal reflection configuration show the effects of two critical angles. Within the two critical angles, there is a high sensitivity to the presence of colloidal particles, while the volume of colloidal samples needed is in the microliter range. Upon comparing theory with experiment, no model fitting was done in any case. The experimental setup and its calibration procedure are discussed. The results provide physical insight into applications involving optical properties of colloidal systems.
RESUMO
We derive a simple model for the angular-intensity profiles of diffuse light transmitted from a turbid colloid into a transparent medium of higher refractive index (RI) near the critical angle. Adjusting this model to experimental profiles obtained with an Abbe-type refractometer offers a sensitive and robust way of measuring the complex effective RI of highly scattering media.
RESUMO
The transmission of an optical beam through the compound cell of a differential refractometer with an absorbing sample is analyzed. Formulas for the lateral shift and the deflection angle of the transmitted optical beam for a complex refractive-index difference are obtained.
RESUMO
We present a new all-optical fiber-referencing scheme for intensity-modulated sensors. It consists of a closed loop traversed by sensing and reference optical signals in opposite directions. With the proposed scheme the noise induced by power fluctuations of the optical source and mechanical perturbations can be greatly reduced. We experimentally demonstrate the efficiency of the scheme and discuss its use in a sensor array.