RESUMO
The main objective of this study was to evaluate the impact of the length and retention time of a tubular helical flow flocculator (THFF) on the elimination of turbidity and color from raw water, to obtain quality treated water for consumption in areas rural. For this, a large-scale field experimental system was used, the THFF was built with 4-inch diameter polyethylene hose and coupled to a sedimentation and filtration process. For the different experimental tests, aluminum sulfate was chosen as the coagulant. To find the optimal dose of coagulant, jar tests were previously carried out. For the tests the length of the THFF was varied (50 m and 75 m), flow rates of 0.25, 0.5, 0.75, 1 and 2 L/s and turbidity ranges of <10, 10-20, 21-50, 51-100 and > 100 NTU of raw water were tested. An evaluation of the hydraulic behavior of the THFF was carried out through an analysis of the temporal distribution curve of the concentration of a tracer, applying the Wolf-Resnick model. The average results revealed a haze and color removal efficiency of 98.07 % and 98.50 %, respectively. The residence time and velocity gradient exhibited variations in a range of 2.25-35.0 min and 3.64 to 56.94 s-1, respectively. It was evident that the operation and effectiveness of THFF are directly influenced by the turbidity of the raw water, the residence time and the velocity gradient. These findings indicate that THFF could play a valuable role as a flocculation unit in a purification system, mainly the existence of a plug-type flow was observed. The findings indicate that THFF, complemented by settling and filtration processes, could be a valuable tool for implementation in rural areas.
RESUMO
This article presents a set of data obtained during the evaluation of a horizontal flow tubular flocculator for the provision of drinking water in developing communities. The HFTF is presented as an alternative technology to replace conventional flocculators, allowing high efficiency in the subsequent sedimentation and filtration processes. For obtaining the data, experimental tests were carried out using lengths of 68.4 m and 97.6 m for the HFTF, these lengths were combined with flow rates of 0.25, 0.5, 0.75, 1.0 and 2.0 L/s, as well as raw water turbidities of 10, 20, 50, 100 and 200 NTU. The data set generated from measurements and observations made during experimental field tests is detailed. The resulting data set covers the main parameters that determine the quality of drinking water, such as turbidity and colour, as well as flocculation efficiency data. The data from the experimental system were compared with a conventional treatment plant that has a baffle flocculator. Likewise, data on the retention time and velocity gradient are presented that allowed the hydraulic characteristics of the HFTF are evaluated. This data set has significant potential for reuse in future research and development related to water treatment technologies in developing community settings. Detailed data has been collected on various operating conditions of the HFTF, such as different lengths, water flow rates and turbidity levels, as well as measurements of key parameters such as turbidity, colour, flocculation efficiency, retention time and velocity gradient, these Data could be used in future research and development related to water treatment technologies. Furthermore, a comparison of data from the experimental system with a conventional treatment plant provides useful insight into the relative performance of different water treatment technologies, which could be of interest to researchers, system designers and public policymakers in the field of drinking water supply in developing communities.
RESUMO
The bulk chlorine decay rate in drinking water supply systems depend on many factors, including temperature. In this document, the method to determine the order of reaction of chlorine with water is reported, as well as the method to estimate Kb (Bulk reaction rate constant). Experiments were carried out to determine the bulk chlorine decay, for which a set of water samples to determine the free residual chlorine every hour were analyzed. Chlorine concentrations were graphed against time and adjusted appropriately to the developed model. The experimental results showed that the average value of the mass decomposition rate was 0.15 h-1. It was shown that temperature affects the variation of the reaction rate of chlorine with water, Kb increases as temperature increases. In this manuscript it is reported:â¢The method that allows determining the reaction kinetic order of chlorine with drinking water.â¢The method that can help residual chlorine modelers in the correct definition of the bulk reaction rate constant.â¢The effectiveness of the method for evaluating the decomposition of residual chlorine in drinking water distribution networks as a function of temperature.
RESUMO
The data of this document highlights a comparative analysis between the Phragmites Australis and Cyperus Papyrus planted in vertical subsurface flow constructed wetland (VSSFCW) independently implemented at pilot scale for the treatment of domestic wastewater. At the exit of the primary lagoon a pipe was installed to feed a constant flow of 0.6 m3/day to each of the two constructed wetlands. Each unit had a retention time of 1.12 days and a hydraulic load rate of 0.2â¯m/day. To evaluate the efficiency of the treatment, physical, chemical and biological parameters were monitored for three consecutive months. Water samples in the influent and effluent of each experimental wetland were analyzed. At the end of the monitoring, Cyperus Papyrus had a better removal of total phosphorus (50%), ammoniacal nitrogen (69.69%), biochemical oxygen demand (69.87%), chemical oxygen demand (80.69%), total coliforms (98.08%) and fecal coliforms (95.61%). Meanwhile, Phragmites Australis eliminated total solids better (62.85%). These data may be useful for comparative purposes on domestic wastewater treatment using Phragmites Australis and Cyperus Papyrus planted in VSSFCW.
RESUMO
This review goal is to reflect on the challenges and prospects for water quality in the face of the pandemic caused by the new SARS-CoV-2 coronavirus (COVID-19). Based on the information available so far, the detection of SARS-CoV-2 RNA in wastewater has raised interest in using it as an early warning method, to detect the resurgence of infections and to report the risk associated with contracting SARS-CoV-2 in contact with untreated water or inadequately treated wastewater is discharged. The wastewater-based epidemiological approach can be used as an early indicator of infection within a specific population. On the other hand, it is necessary to collect information from the managers of drinking water supply companies and professionals who are related to water quality, to know SARS-CoV-2 data and information, and its influence on drinking water quality. The basic purpose of this review article is to try to provide a valuable and quick reference guide to COVID-19. Important topics were discussed, such as detection of SARS-CoV-2 in wastewater in various parts of the world; wastewater screening to monitor COVID-19; persistence of SARS-CoV-2 in aquatic systems; the presence of SARS-CoV-2 in drinking water; clean water as a mechanism to deal with the COVID-19 pandemic; chlorine as a disinfectant to eliminate SARS-CoV-2 and damage to ecosystems by the use of chlorine. Currently does not exist extensive literature on the effectiveness of water and wastewater treatment processes that ensure the correct elimination of SARS-CoV-2. Excessive use of disinfectants such as chlorine is causing effects on the environment. This document highlights the need for further research to establish the behavior of the SARS-CoV-2 virus in aquatic systems. This study presents an early overview of the observed and potential impacts of COVID-19 on the environment.
RESUMO
This document presents the physical-chemical parameters with the objective of evaluating and analyzing the drinking water quality in the Azogues city applying the water quality index (WQI) and to research the water stability in the distribution network using corrosion indexes. Thirty samples were collected monthly for six months throughout the drinking water distribution network; turbidity, temperature, electric conductivity, pH, total dissolved solids, total hardness, calcium, magnesium, alkalinity, chlorides, nitrates, sulfates and phosphates were determined; the physical-chemical parameters were measured using standard methods. The processed data revealed that the average values ââof LSI, RSI and PSI were 0.5 (±0.34), 6.76 (±0.6), 6.50 (±0.99) respectively. The WQI calculation indicated that 100% of the samples are considered excellent quality water. According to the Langelier, Ryznar and Pukorius indexes showed that drinking water in Azogues is corrosive. The quality of drinking water according to the WQI is in a good and excellent category.