RESUMO
To prevent neural tube defects and other cardiovascular diseases in newborns, folic acid (FA) is recommended in pregnant women. A daily dose of 600 µg FA consumption is widely prescribed for women during pregnancy and 400 µg for women with childbearing potential. FA is a class IV compound according to the Biopharmaceutics Classification System (BCS) due to its low permeability (1.7 × 10-6 cm/s) and low solubility (1.6 mg/L); therefore, it must be administered via a formulation that enhances its solubility. Studies reported in the literature have proved that co-amorphization and salt formation of a poorly soluble drug with amino acids (AA) can significantly increase its solubility. Although arginine has been used with FA as a supplement, there is no information on the effect of basic AA (arginine and lysine) on the physical and chemical properties of FA-AA binary formulations. The present study implemented a conductimetric titration methodology to find the effective molar ratio to maximize FA solubility. The results showed that a 1:2.5 FA:AA molar ratio maximized solubility for arginine and lysine. Binary formulations were prepared using different methods, which led to an amorphous system confirmed by the presence of a glass transition, broad FTIR bands, and the absence of an X-ray diffraction pattern. Results of FA:AA (1:2.5) solubility increased in the range of 5500-6000 times compared with pure FA. In addition to solubility enhancement, the binary systems presented morphological properties that depend on the preparation method and whose consideration could be strategic for scaling purposes.
RESUMO
Almost half of orally administered active pharmaceutical ingredients (APIs) have low solubility, which affects their bioavailability. In the last two decades, several alternatives have been proposed to modify the crystalline structure of APIs to improve their solubility; these strategies consist of inducing supramolecular structural changes in the active pharmaceutical ingredients, such as the amorphization and preparation of co-crystals or polymorphs. Since many APIs are thermosensitive, non-thermal emerging alternative techniques, such as mechanical activation by milling, have become increasingly common as a preparation method for drug formulations. This review summarizes the recent research in preparing pharmaceutical formulations (co-amorphous, co-crystals, and polymorphs) through ball milling to enhance the physicochemical properties of active pharmaceutical ingredients. This report includes detailed experimental milling conditions (instrumentation, temperature, time, solvent, etc.), as well as solubility, bioavailability, structural, and thermal stability data. The results and description of characterization techniques to determine the structural modifications resulting from transforming a pure crystalline API into a co-crystal, polymorph, or co-amorphous system are presented. Additionally, the characterization methodologies and results of intermolecular interactions induced by mechanical activation are discussed to explain the properties of the pharmaceutical formulations obtained after the ball milling process.
RESUMO
One-third of the population of the USA suffers from metabolic syndrome (MetS). Treatment of patients with MetS regularly includes drugs prescribed simultaneously to treat diabetes and cardiovascular diseases. Therefore, the development of novel multidrug formulations is recommended. However, the main problem with these drugs is their low solubility. The use of binary co-amorphous systems emerges as a promising strategy to increase drug solubility. In the present study, irbesartan (IBS) and glimepiride (GMP), class II active pharmaceutical ingredients (API), widely used in the treatment of arterial hypertension and diabetes, were selected to develop a novel binary co-amorphous system with remarkable enhancement in the dissolution of both APIs. The phase diagram of IBS-GMP was constructed and co-amorphous systems were prepared by melt-quench, in a wide range of compositions. Dissolution profile (studied at pH 1.2 and 37°C for mole fractions 0.01, 0.1, and 0.5) demonstrated that the xGMP = 0.01 formulation presents the highest enhancement in its dissolution. GMP went from being practically insoluble to reach 3.9 ± 0.9 µg/mL, and IBS showed a 12-fold increment with respect to the dissolution of its crystalline form. Infrared studies showed that the increase in the dissolution profile is related to the intermolecular interactions (hydrogen bonds), which were dependent of composition. Results of structural and thermal characterization performed by XRD and DSC showed that samples have remained in amorphous state for more than 10 months of storage. This work contributes to the development of a highly soluble co-amorphous drugs with potential used in the treatment of MetS.
Assuntos
Hipoglicemiantes/química , Irbesartana/química , Compostos de Sulfonilureia/química , Varredura Diferencial de Calorimetria , Cromatografia Líquida de Alta Pressão , Estabilidade de Medicamentos , Quimioterapia Combinada , Humanos , Ligação de Hidrogênio , Hipoglicemiantes/administração & dosagem , Irbesartana/administração & dosagem , Difração de Pó , Solubilidade , Espectroscopia de Infravermelho com Transformada de Fourier , Compostos de Sulfonilureia/administração & dosagemRESUMO
The high index of simultaneous incidence of hypertension and hypercholesterolemia in the population of many countries demands the preparation of more efficient drugs. Therefore, there is a significant area of opportunity to provide as many alternatives as possible to treat these illnesses. Taking advantage of the solubility enhancement that can be achieved when an active pharmaceutical ingredient (API) is obtained and stabilized in its amorphous state, in the present work, new drug-drug co-amorphous formulations (Simvastatin SIM- Nifedipine NIF) with enhanced solubility and stability were prepared and characterized. Results show that the co-amorphous system (molar ratio 1:1) is more soluble than the pure commercial APIs studied separately. Aqueous dissolution profiles showed increments of solubility of 3.7 and 1.7 times for SIM and NIF, correspondingly, in the co-amorphous system. The new co-amorphous formulations, monitored in time, (molar fractions 0.3, 0.5 and 0.7 of SIM) remained stable in the amorphous state for more than one year when stored at room temperature and did not show any signs of crystallization when re-heating. Inspection on the remainder of a sample after six hours of dissolution showed no recrystallization, confirming the stability of co-amorphous system. The enhanced solubility of the co-amorphous formulations makes them promising for simultaneously targeting of hypertension and hypercholesterolemia through combination therapy.