RESUMO

This study reports the synthesis of porous nano alumina employing carboxylato-alumoxanes [Al(O) x (OH) y (O2CR) z ] n as precursors for controlling the pore size, pore size distribution and porosity of the alumina, using a new process ecofriendly. The carboxylato-alumoxanes was prepared by the reaction of boehmite with carboxylic acids. The boehmite was obtained by the hydrolysis of aluminum alkoxide in an aqueous solution. The colophony extract is employed as a source of carboxylic acids. The materials were characterized, using XRD, TGA, N2 physical adsorption, SEM, TEM, NMR and FTIR. A mechanism was proposed for the formation of the synthesized structures. TEM measurements confirmed particle size ranged from 5 to 8 nm.

RESUMO

Novel MoO(2)/C nano/microcomposites were prepared via a bottom-up approach by hydrothermal carbonization of a solution of glucose as a carbon precursor in the presence of polyoxometalates (POMs: phosphomolybdic acid [H(3)PMo(12)O(40)] and ammonium heptamolybdate tetrahydrate [(NH(4))(6)Mo(7)O(24)]·4H(2)O). The structural characterization by FT-IR, XRPD, SEM and TEM analyses revealed the controlled formation of hierarchical MoO(2)/C composites with different morphologies: strawberry-like, based on carbon microspheres decorated with MoO(2) nanoparticles; MoO(2)/C core-shell composites; and irregular aggregates in combination with ring-like microstructures bearing amorphous Mo species. These composites can be fine-tuned by varying reaction time, glucose/POM ratio and type of POM precursor. Subsequent transformations in the solid state through calcinations of MoO(2)/C core-shell composites in air lead to hollow nanostructured molybdenum trioxide microspheres together with nanorods and plate microcrystals or cauliflower-like composites (MoO(2)/C). In addition, the MoO(2)/C composite undergoes a morphology evolution to urchin-like composites when it is calcined under nitrogen atmosphere (MoO(2)/C-N(2)). The MoO(2)/C strawberry-like and MoO(2)/C-N(2) composites were transformed into Mo carbide and nitride supported on carbon microspheres (Mo(2)C/C, MoN/C, and MoN/C-N(2)). These phases were tested as precursors in thiophene hydrodesulphurization (HDS) at 400 °C, observing the following trend in relation to the thiophene steady-state conversion: MoN/C-N(2) > MoN/C > Mo(2)C/C > MoO(2)/C-N(2) > MoO(2)/C. According to these conversion values, a direct correlation was observed between higher HDS activity and decreasing crystal size as estimated from the Scherrer equation. These results suggest that such composites represent interesting and promising precursors for HDS catalysts, where the activity and stability can be modified either by chemical or structural changes of the composites under different conditions.

Assuntos

RESUMO

Ni nanoparticles were synthesized using two water-in-oil emulsions formulated with different surfactants and using n-heptane as the organic phase and aqueous nickel acetate as the catalytic metallic precursor. Characterization by transmission electron microscopy showed that the Ni nanoparticles have diameters ranging from 3 to 12 nm, and that the surface is lightly oxidized. The decomposition of diluted methane catalyzed by the as-prepared Ni nanoparticles was studied in a thermogravimetric analyzer (TGA), operated in the 25-930°C range. The weight gains measured during the analysis showed that the Ni nanoparticles decomposed methane above 480°C, producing similar g.C/g.cat ratios (6-7) at the end of the tests. High resolution transmission electron microscopy (HRTEM) confirmed that the carbons collected at 930°C were bamboo-shaped carbon nanotubes (BSCNTs) with well defined conical compartments. The average outside diameter of the tubes was between 30 and 60 nm.