RESUMO
The purpose of this study was to assess the anaerobic degradation of black liquor with and without additional carbon sources. Batch experiments were conducted using black liquor, from an integrated pulp and paper mill adding ethanol, methanol and nutrients. The PCR/DGGE technique was used to characterize the structure of the microbial community. The addition of extra sources of carbon did not significantly influence the degradation of black liquor under the conditions evaluated and the microbial community was similar in all experiments. It was observed an increase in some members of the archaeal in reactors that had the best efficiencies for removal of black liquor (around 7.5%). Either ethanol or methanol can be used as co-substrates because the produce the same quantitative and qualitative effect.
Assuntos
Reatores Biológicos/microbiologia , Resíduos Industriais/prevenção & controle , Papel , Eliminação de Resíduos Líquidos/métodos , Anaerobiose , Archaea/genética , Archaea/metabolismo , Etanol/metabolismo , Metanol/metabolismo , Reação em Cadeia da PolimeraseRESUMO
The main purpose of this study was to evaluate the performance of a UASB reactor treating diluted black liquor from a Kraft pulp mill, which simulates an unbleached Kraft plant wastewater, under different operational conditions, including partial recycling of the effluent. The reactor's performance was evaluated from the standpoint of COD, pH, volatile acid concentration, alkalinity, concentration of methane in the biogas, and microbiological examinations of the sludge. Without recirculation the reduction of the HRT from 36 to 30h did not significantly affect the average COD removal efficiency. The parameter displaying the greatest variation was the average concentration of effluent volatile acids, which increased by 16%. With recirculation the reduction of the HRT from 30 to 24h increased the average COD removal efficiency from 75% to 78%. In this case, the average effluent alkalinity also showed an increase. The use of partial recirculation of the effluent did not improve significantly the COD removal under the operational conditions tested in this work, but it was possible to operate the reactor with lower hydraulic retention time without disintegration of the granules.
Assuntos
Bactérias Anaeróbias/metabolismo , Reatores Biológicos/microbiologia , Lignina/metabolismo , Esgotos/microbiologia , Eliminação de Resíduos Líquidos/métodos , Poluentes Químicos da Água/análise , Purificação da Água/métodos , Anaerobiose , Estudos de Avaliação como Assunto , Concentração de Íons de Hidrogênio , Metano/análise , Microscopia Eletrônica de Varredura , Esgotos/química , Microbiologia da ÁguaRESUMO
The main objective of this paper was to perform a preliminary comparative study between chemical and electrochemical coagulation processes, both followed by flocculation and sedimentation of an effluent from an upflow anaerobic sludge blanket (UASB) reactor treating simulated wastewater from an unbleached Kraft pulp mill. The electrochemical treatment removed up to 67% (with aluminum electrodes) and 82% (with stainless-steel electrodes) of the remaining chemical oxygen demand (COD) and 84% (stainless steel) and 98% (aluminum) of the color in the wastewater. These efficiencies were achieved with an energy consumption ranging from 14 to 20 Wh l(-1). The coagulation-flocculation treatment with ferric chloride and aluminum sulfate removed up to 87% and 90% of COD and 94% and 98% of color, respectively. The addition of a high molecular weight cationic polymer enhanced both COD and color removal efficiencies. The two post-treatment processes proved to be technically feasible; however the economical feasibility could not be assessed since the experiments were performed with small reactors that could distort scale factors.
Assuntos
Esgotos/química , Eliminação de Resíduos Líquidos/instrumentação , Eliminação de Resíduos Líquidos/métodos , Anaerobiose , Eletroquímica/métodos , Floculação , Resíduos IndustriaisRESUMO
The main purpose of this study was to evaluate the performance of the electrochemical oxidation process as a post-treatment for the effluents of a bench-scale UASB reactor treating simulated wastewater from an unbleached pulp plant. The oxidation process was performed using a single compartment cell with two plates as electrodes. The anode was made of Ti/Ru0.3Ti0.7O2 and the cathode of stainless steel. The following variables were evaluated: current density (75, 150 and 225 mA cm(-2)) and recirculation flow rate in the electrochemical cell (0.22, 0.45 and 0.90 L h(-1)). The increase in current density from 75 to 225 mA cm(-2) did not increased the color removal efficiency for the tested flow rates, 0.22, 0.45 and 0.90 L h(-1), however the energy consumption increased significantly. The results indicated the technical feasibility of the electrochemical treatment as post-treatment for UASB reactors treating wastewaters from pulp and paper plants.
Assuntos
Celulose/química , Eletroquímica/métodos , Resíduos Industriais , Papel , Poluentes Químicos da Água , OxirreduçãoRESUMO
This paper presents results from exploratory experiments to test the technical feasibility of electrolytic treatment and coagulation followed by flocculation and sedimentation as post-treatment for the effluent of an UASB reactor treating simulated wastewater from an unbleached Kraft pulp mill. The electrolytic treatment provided up to 67% removal of the remaining COD and 98% of color removal. To achieve these efficiencies the energy consumption ranged from 14 Wh x l(-1) to 20 Wh x l(-1). The coagulation-flocculation treatment followed by settling required 350-400 mg x l(-1) of aluminium sulfate. The addition of a high molecular weight cationic polymer enhanced both COD and color removal. Both post-treatment processes are technically feasible.
Assuntos
Reatores Biológicos , Celulose , Eletrólise , Resíduos Industriais , Eliminação de Resíduos Líquidos/métodos , Compostos de Alúmen/química , Anaerobiose , Bactérias Anaeróbias/metabolismo , Cor , Floculação , Concentração de Íons de Hidrogênio , Oxigênio/metabolismo , Polímeros/química , Esgotos , Purificação da Água/métodosRESUMO
This paper presents the performance of two bench scale Upflow Anaerobic Sludge Blanket reactors (UASB) used for the treatment of synthetic substrates that simulate bleached and unbleached cellulose pulp plant wastewaters. The control reactor was fed with diluted black liquor and the treatment reactor with the same substrate plus a mixture of chlorinated organics. The total concentration of the chlorinated compounds was gradually increased from 2.5 mg l-1 to 15.0 mg l-1. The average COD removal efficiency during the last phase of the experiment was 81% in the control reactor and 76% in the treatment reactor. These results indicate the capability of UASB reactors to treat this kind of wastewater and the low impact of the chlorinated organics on COD removal efficiency. The minimum overall chlorinated organics removal efficiency was 71% and the maximum was 99.7%. The experiment indicates that under the conditions used in this research the presence of chlorinated organics does not negatively impact the treatment process.