RESUMO

Waste Opuntia is an abundant source of biomass to produce biogas and biofertilizer in a small and commercial scale. This crop has a high biomass yield, wide adaptation to diverse climatic zones, rapid growth, and low input requirements. This study aimed to evaluate the combined effect of adjusting C/N ratio and an alkaline pretreatment (AP) of waste Opuntia heliabravoana Scheinvar in the production of biogas and biofertilizer in anaerobic reactors. AP bioreactors produced more biogas than the control (C, without the combined effect of AP); besides, in this process, it was not necessary to use additional water due to the high content of water that is present in the tissue of this crop. On the other hand, both biofertilizers (C and AP) had enssential microbial groups that help to enhance plant nutrition as S-reducers, S-oxidizers, amylolytic, cellulolytic bacteria, anaerobic S-mineralizers, cellulolytic fungi, and P-solubilizers. Also, the AP treatment to help to increase 1.5:1 total nitrogen (TN) concentration decreased the pathogenic microorganisms in the biofertilizer compared to the C treatment. For this reason, Opuntia spp. is a good substrate for production of biogas and biofertilizer with essential nutrients for many crops in area with water scarcity.

Assuntos

RESUMO

Urban runoff (UR) is a promising new resource that may alleviate growing tensions in numerous arid and semi-arid regions of the world. However, it is precisely in these zones that the available UR quality characteristics are scarcer. This work aims to evaluate a wide set of parameters to establish a detailed approach to both the quality of UR in a midsized city in Central Mexico and the feasibility of using UR to recharge aquifers. UR from an institutional land use site was sampled during wet and dry seasons and assessed for suspended solids, organic matter, nutrients, microorganisms, metals, and persistent organic chemicals (i.e., polycyclic aromatic hydrocarbons, PAH). The results were analyzed using multivariate statistical methods to identify relationships among the variables, the sampling sites and the seasons. The soil erosion and the leaching of materials due to the water flow through vegetated areas were identified as the most influencing factor on the quality of the site runoff in both dry and wet seasons. Additionally, data were more heterogeneous during the dry season, and higher pollutant concentrations were found both during the dry season and in more pervious zones. We consider UR a promising water source for recharging aquifers in arid and semi-arid zones if a program is implemented that can integrate an adequate runoff treatment system, soil protection, and other non-structural measures.

Assuntos

RESUMO

The aim of this research was to investigate the use of a natural adsorbent like nopal (Opuntia albicarpa L. Scheinvar) for removing cadmium from aqueous solutions with low concentrations of this metal. Two treatments were applied to the cladodes: a dehydration to get dehydrated nopal (DHN) and heating up to 90°C to obtain a thermally treated nopal (TN). After examining the effect of various pH values (2-7), the capacity of each biosorbent was examined in batch sorption tests at different dosages (0, 500, 1000, 1500, 2000, and 3000 mg L(-1)). The results indicated that adsorption of cadmium to biomass of DHN and TN was highly dependent on pH and biosorbent dosage. The best removal of cadmium (53.3%, corresponding to q e of 0.155 mg g(-1)) was obtained at pH 4.0 by using the TN sorbent. Infrared and Raman spectra confirmed that cadmium removal occurred via adsorption to -OH functional groups.

Assuntos

RESUMO

Activated sludges are an inoculum source commonly used in biodegradation studies, as wastewater treatment facilities constitute an entry point to the environment for many chemicals. In this paper, the main issues relating to the use of activated sludge in biodegradability tests are presented. Special attention is also devoted to discussing the factors affecting both the activity of the microbial communities and the test results. After a short survey of the state of the art of microbiology of activated sludge, the paper focuses on the methods used to reduce the variations in the diversity, quality and quantity of these communities. Finally, use of surrogates as reference materials in biodegradability tests is discussed.

Assuntos

RESUMO

Soil, sediments, water and plant samples from the mining zone of Molango were collected and analyzed and Mn-tolerant and Mn-accumulator plants were identified. Soil and sediments presented moderately alkaline and reducing conditions, a normal electrical conductivity, a sandy texture and medium-to-high cation exchange capacities. These properties favored the presence of Mn(2+), which is the form most easily assimilated by plants, and the total Mn concentration (11,637-106,104 mg kg(-1) dried weight, DW) was at phytotoxic level. Water was also an important Mn source. Equisetum hyemale and Telypteris kunthii survived in the presence of such Mn concentrations using an exclusion strategy, while Cnidoscolus multilobus, Platanus mexicana, Solanum diversifolium, Asclepius curassavica L. and Pluchea sympitifolia employed an accumulation strategy. These plants could be useful to re-vegetate and stabilize Mn tailings in order to decrease the erosion effects.

Assuntos

RESUMO

La biodegradabilidad es una propiedad de las sustancias químicas que determina su persistencia ambiental. Diversos organismos han estandarizado métodos para la evaluación de esta propiedad, entre los que destacan, por su amplio uso a nivel internacional, las pruebas de la Organización para la Cooperación y el Desarrollo Económico (OCDE). En este trabajo se presenta una descripción general de estas pruebas, y se discuten sus principales ventajas e inconvenientes. Para tal efecto, se utiliza la estructura propuesta por dicha organización, que distingue tres niveles sucesivos de ensayo: las pruebas de biodegradabilidad inmediata, de biodegradabilidad intrínseca y de simulación. La complejidad de las condiciones experimentales empleadas aumenta en el mismo orden, por lo que dicho esquema permite evaluar a bajo costo el potencial de biodegradación de cualquier molécula orgánica. En este artículo se sugieren algunas mejoras a los métodos, tales como la aplicación de modelos cinéticos para la expresión de los resultados y el uso de la sustancia de prueba como fuente de N, P o S. Se revisan en particular las pruebas de simulación, que permiten conocer el comportamiento de las sustancias en medios naturales o industriales específicos, y se destaca la importancia de normalizar nuevos métodos de simulación y de optimizar los existentes para hacerlos más accesibles a los posibles usuarios. Entre los medios naturales susceptibles de ser normalizados destacan los anóxicos en presencia de distintos aceptores externos de electrones (i.e., nitratos, sulfatos o hierro). Finalmente, se presentan aplicaciones recientes de estas pruebas, así como algunas áreas de investigación futura.

As knowledge of the biodegradability of organic compounds is essential to determine their environmental fate, several standardized biodegradability tests have been proposed by regulatory agencies. This paper presents an overview of the most commonly used standardized methods for biodegradability assessment of chemicals, those of the Organization for Economic Cooperation and Development (OECD). A general description is given of these tests and of their most important advantages and disadvantages. The tests presentation follows the OECD strategy, which classifies the assays in three successive levels: ready, inherent and simulation tests. Since experimental complexity increases in the same order, this strategy permits the biodegradability assessment of any organic compound in a cost-effective way. Some improvements to the tests are suggested, such as the application of kinetic models for the expression of test results and the use of the test compound as a source of N, P or S. The simulation tests, which allow the study of the behavior of chemicals in specific natural or industrial environments, are reviewed. The need of both new simulation methods and the optimization of available ones in order to extend their use is emphasized. A relevant simulation test to be standardized is the anoxic medium with external electron acceptors (i.e., nitrates, sulfates or iron). Finally, some recent applications of these tests as well as some proposals for future research in the field are presented.

A biodegradabilidade é uma propriedade das substâncias químicas que determina sua persistência ambiental. Diversos organismos tem estandardizado métodos para a avaliação desta propriedade, entre os que destacam, por seu amplo uso a nível internacional, as provas da Organização para a Cooperação e o Desenvolvimento Econômico (OCDE). Neste trabalho apresenta-se uma descrição geral destas provas, e discutem-se suas principais vantagens e inconvenientes. Para tal efeito, utiliza-se a estrutura proposta por dita organização, que distingue três níveis sucessivos de ensaios: as provas de biodegradabilidade imediata, de biodegradabilidade intrínseca e de simulação. A complexidade das condições experimentais empregadas aumenta na mesma ordem, pelo que dito esquema permite avaliar a baixo custo o potencial de biodegradação de qualquer molécula orgânica. Neste artigo se sugerem algumas melhoras aos métodos, tais como a aplicação de modelos cinéticos para a expressão dos resultados e o uso da substância de prova como fonte de N, P ou S. Revisam-se em particular as provas de simulação, que permitem conhecer o comportamento das substâncias em meios naturais ou industriais específicos, e se destaca a importância de normalizar novos métodos de simulação e de melhorar os existentes para fazê-los mais acessíveis aos possíveis usuários. Entre os meios naturais susceptíveis de ser normalizados destacam os anóxicos na presença de distintos aceptores externos de elétrons (i.e., nitratos, sulfatos ou ferro). Finalmente, se apresentam aplicações recentes destas provas, assim como algumas áreas de investigação futura.