RESUMO
Herein, a novel graphite/sulfur iron tailing composite was applied as a peroxydisulfate (PDS) activator for rhodamine B (RhB) degradation in the water. The superior catalytic efficiency of graphite/sulfur iron tailing was achieved through radical (SO4â¢- and â¢OH) and non-radical (1O2) processes according to the radical quenching experiments and electron paramagnetic resonance analysis. The carbonyl group and Fe species were the main active sites on the surface of graphite/sulfur iron tailing, which was demonstrated by combining Fourier transform infrared spectroscopy (FT-IR), X-ray photoelectron spectroscopy (XPS), and reaction kinetic experiments, and a possible degradation mechanism was also proposed. Overall, activated with 0.30 g/L of C-1, PDS achieved a 94.8% removal rate for RhB and maintained a removal rate of over 85% even after five consecutive operation cycles, and this study will benefit the application of iron/carbon composite materials in practical water treatment.
Assuntos
Grafite , Ferro , Rodaminas , Poluentes Químicos da Água , Rodaminas/química , Grafite/química , Ferro/química , Catálise , Poluentes Químicos da Água/química , Purificação da Água/métodos , Enxofre/química , Cinética , Espectroscopia de Infravermelho com Transformada de Fourier , Sulfatos/químicaRESUMO
Branched surfactants exhibit a lower surface tension, excellent low defoaming performance, and better wetting ability compared with linear surfactants, making them promising for applications in industrial cleaning. In this study, 2-hexyl-1-decene (C8 olefin dimer), obtained from the dimerization of 1-octene, was used as the hydrophobe to synthesize branched nonionic surfactants via hydroxylation and ethoxylation. The hydroxylation of the C8 olefin dimer to synthesize 2-hexyldecane-1,2-diol (C8 BD) using H2O2 and HCOOH was investigated systematically. Under the optimal reaction conditions (H2O2/C8 olefin dimer molar ratio: 1.5, HCOOH/C8 olefin dimer molar ratio: 4.0, reaction time: 10 h, reaction temperature: 50 °C), the conversion of the C8 olefin dimer and selectivity toward C8 BD were found to reach 99.96 and 79.89%, respectively. Further, branched nonionic surfactants (C8 BDEn) were synthesized via ethoxylation of C8 BD with ethylene oxide and characterized using FTIR, LCMS, 1H NMR, and 13C NMR techniques. The presence of a tertiary hydroxyl group in C8 BD increases the reactivity of the primary hydroxyl group, leading to a narrower range of products and lower residual substrate content. The physicochemical properties and surface properties of C8 BDEn with different degrees of ethoxylation at various concentrations were investigated and compared with those of commercially available Guerbet alcohol polyoxyethylene ethers (C8 GAEO9 and C6 GAEO9). The results show that, compared with C8 GAEO9 and C6 GAEO9, C8 BDE6 displayed a higher surface activity with a lower equilibrium surface tension (27.14 mN·m-1), superior wettability with a smaller contact angle (39.2°), better emulsification performance with a longer emulsification time of 548 s, and excellent foaming properties (initial foam volume of 11.6 mL). This strategy of utilizing coal-based α-olefins for the synthesis of branched nonionic surfactants presents a route to prepare value-added fine chemicals from coal-based resources.
RESUMO
To effectively carry out the bioremediation of a Pb2+ polluted environment, a lead-tolerant strain named D1 was screened from the activated sludge of a factory in Hefei, and its lead removal in a solution with Pb2+ concentration of 200 mg/L could reach 91% under optimal culture conditions. Morphological observation and 16S rRNA gene sequencing were used to identify D1 accurately, and its cultural characteristics and lead removal mechanism were also preliminarily studied. The results showed that the D1 strain was preliminarily identified as the Sphingobacterium mizutaii strain. The experiments conducted via orthogonal test showed that the optimal conditions for the growth of strain D1 were pH 7, inoculum volume 6%, 35 °C, and rotational speed 150 r/min. According to the results of scanning electron microscopy and energy spectrum analysis before and after the D1 exposure to lead, it is believed that the lead removal mechanism of D1 is surface adsorption. The Fourier transform infrared spectroscopy (FTIR) results revealed that multiple functional groups on the surface of the bacterial cells are involved in the Pb adsorption process. In conclusion, the D1 strain has excellent application prospects in the bioremediation of lead-contaminated environments.