RESUMO
Several researchers have reported zeolite synthesis using coal ash for a wide range of applications. However, little attention has been given to green processes, including moderate synthesis conditions, using waste as raw material and effluent reuse or reduction. In this study, Brazilian coal fly ashes were used for integrated synthesis of zeolites 4A and Na-P1 by two different routes and under moderate operating conditions (temperature and pressure). Both procedures produced zeolites with similar conversions (zeolite 4A at 82% purity and zeolite Na-P1 at 57-61%) and high CEC values (zeolites 4A: 4.5meqCa(2+)g(-1) and zeolites Na-P1: 2.6-2.8meqNH4(+)g(-1)). However, process 1 generated less effluent for the zeolite mass produced (7mLg(-1)), with low residual Si and Al levels and 74% of the Si available in the coal fly ash incorporated into the zeolite, while only 55% is used in process 2. For use as a builder in detergents, synthetic zeolite 4A exhibited conformity parameters equal to or greater than those of the commercial zeolite adopted as reference. Treatment of swine wastewater with zeolite Na-P1 resulted in a high removal capacity for total ammoniacal nitrogen (31mgg(-1)).
Assuntos
Compostos de Amônio/isolamento & purificação , Cinza de Carvão/química , Detergentes/síntese química , Química Verde , Zeolitas/síntese química , Animais , Suínos , Purificação da ÁguaRESUMO
The chlorite ion is the principal by-product of the treatment of drinking water by chlorine dioxide. In function of the chlorite salt instability, standard solutions of this ion need standardization by iodometric titration, which is a reliable method although labor intensive and time consuming. An alternative method to standardization of aqueous chlorite solutions, based on its direct UV absorption measurement, was presented. Besides the maximum absorption (260 nm) generally used in other studies, the minimum (239 nm) and isosbestic (248 nm) wavelengths were proposed as supplementary points to chlorite quantification and their molar absorptivity coefficients were estimated (155.2+/-0.6, 104.5+/-1.0 and 69.0+/-1.2 L cm(-1) mol(-1), respectively). The direct spectrophotometric determination of chlorite could be made selectively even in the presence of high concentration of major contaminants (chorine dioxide, chloride and chlorate), being a simple and rapid method, consuming very low volume of sample and generating low quantities of laboratory wastes.