RESUMO
Two new water soluble dendronized polymers (PLn) from acrylate Behera amine monomer of different molecular weights were successfully synthesized. The polymers were characterized by FTIR, NMR, GPC and DLS. Both GPC and DLS results indicated that these PLn have a remarkable tendency to form aggregates in solution that lead to apparent molecular weights that are much higher than their theoretical values, as well as large diameters in solution. However, the addition of any PLn to water did not cause any increase in viscosity up to concentrations of 1000 ppm. The possible interactions of PLn with the cationic surfactant CTAT were explored by solution rheometry. A synergistic viscosity enhancement was found by adding small amounts of dendronized PLn polymers to a CTAT solution composed of entangled worm-like micelles. The highest association tendency with CTAT was found for PL1 at the maximum polymer concentration before phase separation (i.e., 100 ppm). The solution viscosity at low-shear rates could be increased by an order of magnitude upon addition of 100 ppm of PL1 to a 20mM CTAT solution. For this mixture, the fluid obtained was highly structured and exhibited only shear thinning behavior from the smallest shear rates employed. These PL1/CTAT mixtures exhibited an improved elastic character (as determined by dynamic rheometry) that translated in a much longer value of the cross-over relaxation time and a pronounced thixotropic behavior which are indicative of a strong intermolecular interaction. In the case of the polymer with a higher theoretical molecular weight, PL2, its association with CTAT leads to an extraordinary doubling of solution viscosity with just 0.25 ppm polymer addition to a 20mM CTAT solution. However, such synergistic viscosity enhancement saturated at rather low concentrations (25 ppm) indicating an apparent lower solubility as compared to PL1, a fact that may be related to its higher molecular weight.
RESUMO
The influence of the morphology of ethylene glycol dimethacrylate-hydroxyethyl methacrylate copolymer [poly(EGDMA-co-HEMA)] base support to obtain different Fe(3+)-containing sorbents and their properties in retention of O-phosphothreonine [Thre(P)] is examined in this paper. Three base supports poly(EGDMA-co-HEMA) (I-III) were obtained using different quantities of initiator in suspension polymerization reactions. These products were submitted to chemical modifications using 1,4-butanediol diglycidyl ether (BDGE) in activation reactions and different chelating agents (iminodiacetic acid, IDA; disodium ethylenediamine tetraacetate, EDTA; and hexamethylenediamine tetrapropanoic acid, HMDTP) in coupling reactions to attain Fe(3+)-containing sorbents. Properties such as specific surface area (S(s)), specific pore volume (V(p)), scanning electron microscopy (SEM), IR spectroscopy, quantity of functional groups (oxirane and carboxyl), amount of chelated metal ion, ligand occupation (L), swelling studies as well as quantity of O-phosphoamino acid retained were used as comparative parameters for matrices. In general, the derivatization reactions proved to be more efficient when higher S(s) of macropores (50-400,000 nm) were available in the matrix. In our case, it was observed when highest percentage of initiator was used. On the other hand, the effect of accessibility of surface area on the yield of coupling reactions was noticed when comparing the different chelating agents since the number of carboxyl groups present in products was higher when the molecular size of the chelating agent was lower. Although all Fe(3+)-containing sorbents resulted efficient to retain Thre(P), the values of retention of the amino acid were slightly higher when IDA-containing matrices were used irrespective of the quantity of metal chelated. This could be probably due to the fact that the IDA ligand could be bounded to the matrix in sites that though accessible for the center of adsorption were hard for Thre(P) to access.