RESUMEN
In this study, the association behavior of pyrene with different dissolved humic materials (DHM) was investigated utilizing the recently developed segmented frequency-domain fluorescence lifetime method. The humic materials involved in this study consisted of three commercially available International Humic Substances Society standards (Suwannee River fulvic acid reference, SRFAR, Leonardite humic acid standard, LHAS, and Florida peat humic acid standard, FPHAS), the peat derived Amherst humic acid (AHA), and a chemically bleached Amherst humic acid (BAHA). It was found that the three commercial humic materials displayed three lifetime components, while both Amherst samples displayed only two lifetime components. In addition, it was found that the chemical bleaching procedure preferentially removed red wavelength emitting fluorophores from AHA. In regards to pyrene association with the DHM, different behavior was found for all commercially available humics, while AHA and BAHA, which displayed strikingly similar behavior in terms of fluorescence lifetimes. It was also found that there was an enhancement of pyrene's measured lifetime (combined with a decrease in pyrene emission) in the presence of FPHAS. The implications of this long lifetime are discussed in terms of (1) quenching mechanism and (2) use of the fluorescence quenching method used to determine the binding of compounds to DHM.
Asunto(s)
Fluorescencia , Colorantes Fluorescentes/química , Sustancias Húmicas , Mediciones Luminiscentes/métodos , Pirenos/química , Adsorción , Colorantes Fluorescentes/normas , Oxígeno/química , Pirenos/normas , Solubilidad , Propiedades de Superficie , Factores de TiempoRESUMEN
A new method was proposed to determine pyrene in mucus, which combined the synchronous fluorimetry with the multiple standard addition method (SFMSA). The method was used to determine pyrene in mucus directly without pretreatment. The method detection limit (MDL) for pyrene in mucus was measured as 0.47 ng/ml with a relative standard deviation of 12.7% (n = 7). The standard addition graph was linear in the range 0.05-50.00 ng/ml (r(2) = 0.9989). SFMSA was validated using a GC/MS method as a reference method, and nice agreement was found. The pyrene in mucus can be directly monitored by SFMSA without solvent extraction of samples. This indicates that SFMSA is more timesaving, less laborious and cheaper than the GC/MS method with solvent extraction. SFMSA has lower MDL and higher average recovery than the GC/MS method.
Asunto(s)
Fluorometría/métodos , Moco/química , Pirenos/química , Animales , Carpas/metabolismo , Cromatografía de Gases y Espectrometría de Masas , Pirenos/análisis , Pirenos/normas , Reproducibilidad de los ResultadosRESUMEN
1-Hydroxypyrene is a metabolite of pyrene, a member of the class of polycyclic aromatic hydrocarbons (PAHs) whose toxic properties in some cases include carcinogenicity. The determination of 1-hydroxypyrene in human urine is used as a biological indicator for exposure to PAHs, which is related to the combustion of organic materials, like smoking, living in urban environments, and eating grilled or smoked food. The determination of 1-hydroxypyrene by high-performance liquid chromatography (HPLC) with fluorescence detection has very good sensitivity but it is not highly specific: this can reduce accuracy in the quantitative determination of low levels of analyte in a complex matrix like urine. An HPLC method that uses triple quadrupole mass detection has been validated with the objective both to improve the signal-to-noise (S/N) ratio and to achieve the maximum specificity for the analyte in those urine samples that are richer in possible inteferents. The calibration range for 1-hydroxypyrene is from 0.005-0.1 microg/L in the urine of non-smoking healthy volunteers. After solid-phase extraction, samples were analyzed by HPLC/tandem mass spectrometry (MS/MS) in the multiple reaction monitoring (MRM) mode. In order to obtain reliable results quantitative analysis must be performed by means of the internal standard method (we used deuterium-labelled 1-hydroxypyrene): the method accuracy is not less than 85%. The S/N ratio at a concentration of 0.1 microg/L is about 10, and therefore this can be considered the lowest limit of quantitation. The method performance does not change if urine samples are measured using a calibration curve prepared in methanol, thus reducing the time of analysis and costs.