RESUMEN
Fibre-reinforced composites (FRCs) are already well established in several industrial sectors such as aerospace, automotive, plant engineering, shipbuilding and construction. The technical advantages of FRCs over metallic materials are well researched and proven. The key factors for an even wider industrial application of FRCs are the maximisation of resource and cost efficiency in the production and processing of the textile reinforcement materials. Due to its technology, warp knitting is the most productive and therefore cost-effective textile manufacturing process. In order to produce resource-efficient textile structures with these technologies, a high degree of prefabrication is required. This reduces costs by reducing the number of ply stacks, and by reducing the number of extra operations through final path and geometric yarn orientation of the preforms. It also reduces waste in post-processing. Furthermore, a high degree of prefabrication through functionalisation offers the potential to extend the application range of textile structures as purely mechanical reinforcements by integrating additional functions. So far, there is a gap in terms of an overview of the current state-of-the-art of relevant textile processes and products, which this work aims to fill. The focus of this work is therefore to provide an overview of warp knitted 3D structures.
RESUMEN
In this paper, two most representative hernia repair meshes were prepared with 0.15 mm polypropylene monofilaments via warp knitting technology, and their mechanical properties were tested in various aspects. Meanwhile, a focused investigation of the boundary conditions between the sutures and the mesh was simulated in several directions innovatively. The results revealed that the hernia repair mesh with different structures has different mechanical properties, and the mechanical properties of standard hernia repair mesh were superior to that of lightweight hernia repair mesh. In order to reduce foreign body sensation and postoperative adverse reactions significantly, the lightweight hernia repair mesh may be preferred. At the same time, the mesh should be placed in the proper direction to comply with the anisotropy of abdominal wall during operation. The area where the hernia mesh is in contact with the sutures was vulnerable to damage. The curved or wrinkled area of the hernia repair mesh increases with the increase of load, which may lead to poor tissue growth, a strong inflammatory response, and even the recurrence of the hernia. Therefore, the hernia repair meshes with different structures may require unique suture techniques. And they also should be further treated prior to implantation. This study provides a theoretical basis for development, utilization and improvement of meshes. Further research will focus on the biomechanical properties of the mesh after implantation in vivo studies.
Asunto(s)
Pared Abdominal , Herniorrafia , Hernia , Humanos , Polipropilenos , Mallas QuirúrgicasRESUMEN
Glass warp-knitted fabrics have been widely used as complex structural reinforcements in composites, such as wind turbine blades, boats, vehicles, etc. Understanding the mechanical behavior and formability of these textiles is very necessary for the simulation of forming processes before manufacturing. In this paper, the shear deformation mechanics of glass warp-knitted non-crimp fabrics (WKNCF) were experimentally investigated based on a picture frame testing apparatus equipped to a universal testing machine. Three commercially available fabrics of WKNCFs were tested for four cycles by the picture frame method. The aim was to characterize and compare the shear behavior of relatively high areal density fabrics during preform processing for composites. The energy normalization theory was used to obtain the normalized shear force from the testing machine data; then, the shear stress against the shear angle was fitted by cubic polynomial regression equations. The results achieved from the equations demonstrated that the in-plane shear rigidity modulus was associated with the shear angle. The effect of the shearing cycles and stitching pattern on shear resistance was also analyzed.