RESUMEN
Distributed acoustic sensors (DAS) utilize optical fibers to monitor vibrations across thousands of independent locations. However, the measured acoustic waveforms experience significant variations along the sensing fiber. These differences primarily arise from changes in coupling between the fiber and its surrounding medium as well as acoustic interferences. Here, a correlation-based method is proposed to automatically find the spatial locations of DAS where temporal waveforms are repeatable. Signal repeatability is directly associated with spatial monitoring locations with both good coupling and low acoustic interference. The DAS interrogator employed is connected to an over 30-year-old optical fiber installed alongside a railway track. Thus, the optical fiber exhibits large coupling changes and different installation types along its path. The results indicate that spatial monitoring locations with good temporal waveform repeatability can be automatically discriminated using the proposed method. The correlation between the temporal waveforms acquired at locations selected by the algorithm proved to be very high considering measurements taken for three days, the first two on consecutive days and the third one a month after the first measurement.
RESUMEN
A method for adjusting the working distance and spot size of a fiber probe while suppressing or enhancing the back-coupling to the lead-in fiber is presented. As the optical fiber probe, a lensed optical fiber (LOF) was made by splicing a short piece of coreless silica fiber (CSF) on a single-mode fiber and forming a lens at the end of the CSF. By controlling the length of the CSF and the radius of lens curvature, the optical properties of the LOF were adjusted. The evolution of the beam in the LOF was analyzed by using the Gaussian ABCD matrix method. To confirm the idea experimentally, 17 LOF samples were fabricated and analyzed theoretically and also experimentally. The results show that it is feasible in designing the LOF to be more suitable for specific or dedicated applications. Applications in physical sensing and biomedical imaging fields are expected.
RESUMEN
In this study, an innovative approach based on fiberoptically coupled substrate-integrated hollow waveguide (iHWG) gas cells for the analysis of low sample volumes suitable for remote broad- and narrow-band mid-infrared (MIR; 2.5-20 µm) sensing applications is reported. The feasibility of remotely addressing iHWG gas cells, configured in a double-pass geometry via a reflector, by direct coupling to a 7-around-1 mid-infrared fiber bundle is demonstrated, facilitating low-level hydrocarbon gas analysis. For comparison studies, two iHWGs with substrate dimensions of 50 × 50 × 12 mm (L × W × H) and geometric channel lengths of 138 and 58.5 mm, serving as miniature light-guiding gas cells, were fiber-coupled to a Fourier transform infrared spectrometer enabling broadband MIR sensing. In addition to the fundamental feasibility of this concept, the achievable sensitivity toward several gaseous hydrocarbons and the reproducibility of assembling the fiber-iHWG interface were investigated.