RESUMEN

While between- and within-worker variability have been studied quite extensively, hardly any research is available that examines long-term trends in the variability of occupational exposure. In this first study on trends in occupational exposure variability temporal changes in the variability of respirable dust and respirable quartz concentrations within the European industrial minerals sector were demonstrated. Since 2000 the European Industrial Minerals Association's Dust Monitoring Program (IMA-DMP) has systematically collected respirable dust and respirable quartz measurements. The resulting IMA-DMP occupational exposure database contains at present approximately 40 000 personal full-shift measurements, collected at 177 sites owned by 39 companies, located in 23 European countries. Repeated measurements of workers performing their duties within a specific site-job-campaign combination allowed estimation of within- and between-worker variability in exposure concentrations. Overall day-to-day variability predominated the between-worker variability for both respirable dust concentrations and quartz concentrations. The within-worker variability in concentrations by job was two to three times higher for respirable quartz than for respirable dust. The median between-worker variability in respirable dust concentrations was low and further reduced over time. For quartz concentrations the same phenomenon albeit somewhat less strong was observed. In contrast, for the within-worker variability in concentrations downward and upward temporal trends were apparent for both respirable dust and respirable quartz. The study shows that the (relative) size of temporal variability is large and unpredictable and therefore regular measurement campaigns are needed to ascertain compliance to occupational exposure limit values.

Asunto(s)

RESUMEN

Cases of Lyme disease in humans are on the rise in the United States and Canada. The vector of the bacteria that causes this disease is the blacklegged tick, Ixodes scapularis. Current control methods for I. scapularis mainly involve chemical acaricides. Unfortunately, ticks are developing resistance to these chemicals, and more and more, the public prefers non-toxic alternatives to chemical pesticides. We discovered that volcanic glass, ImergardTM WP, and other industrial minerals such as Celite 610 were efficacious mechanical insecticides against mosquitoes, filth flies, and agricultural pests. In this report, when 6-10- and 50-70-day old unfed I. scapularis nymphs were dipped for 1-2 s into Celite, the time to 50% mortality (LT50) was 66.8 and 81.7 min, respectively, at 30 °C and 50% relative humidity (RH). The LT50 was actually shorter at a higher 70% RH, 43.8 min. Scanning electron microscopy showed that the ticks were coated over most of their body surface, including partial to almost total coverage of the opening to their respiratory system. The other mechanical insecticide, Imergard, had similar efficacy against blacklegged unfed nymphs with an LT50 at 30 °C and 50% RH of 70.4 min. Although more research is needed, this study suggests that industrial minerals could be used as an alternative to chemical pesticides to control ticks and Lyme disease.

RESUMEN

OBJECTIVES: Since 2000 the European Industrial Minerals Association's Dust Monitoring Programme (IMA-DMP) has systematically collected respirable dust and respirable quartz measurements from 35 companies producing industrial minerals. The IMA-DMP initiative allowed for estimating overall temporal trends in exposure concentrations for the years 2002-2016 and for presenting these trends by type of mineral produced, by jobs performed and by time of enrolment into the DMP. METHODS: Approximately 32 000 personal exposure measurements were collected during 29 sampling campaigns during a 15-year period (2002-2016). Temporal trends in respirable dust and respirable quartz concentrations were studied by using linear mixed effects models. RESULTS: Concentrations varied widely (up to three to four orders of magnitude). However, overall decreases in exposure levels were shown for the European minerals industry over the 15-year period. Statistically significant overall downward temporal trends of -9.0% and -3.9% per year were observed for respirable dust and respirable quartz, respectively. When analyses were stratified by time period, no downward trends (and even slight increasing concentrations) were observed between 2008 and 2012, most likely attributable to the recent global economic crisis. After this time period, downward trends became visible again. CONCLUSIONS: Consistent and statistically significant downward trends were found for both exposure to respirable dust and respirable quartz. These downward trends became less or even reversed during the years of the global economic crisis. To our knowledge, this is the first time that analyses of long-term temporal trends point at an effect of a global economic crisis on personal exposure concentrations of workers from sites across Europe.

Asunto(s)

RESUMEN

INTRODUCTION: In 2000, a prospective Dust Monitoring Program (DMP) was started in which measurements of worker's exposure to respirable dust and quartz are collected in member companies from the European Industrial Minerals Association (IMA-Europe). After 15 years, the resulting IMA-DMP database allows a detailed overview of exposure levels of respirable dust and quartz over time within this industrial sector. Our aim is to describe the IMA-DMP and the current state of the corresponding database which due to continuation of the IMA-DMP is still growing. The future use of the database will also be highlighted including its utility for the industrial minerals producing sector. METHODS: Exposure data are being obtained following a common protocol including a standardized sampling strategy, standardized sampling and analytical methods and a data management system. Following strict quality control procedures, exposure data are consequently added to a central database. The data comprises personal exposure measurements including auxiliary information on work and other conditions during sampling. RESULTS: Currently, the IMA-DMP database consists of almost 28,000 personal measurements which have been performed from 2000 until 2015 representing 29 half-yearly sampling campaigns. The exposure data have been collected from 160 different worksites owned by 35 industrial mineral companies and comes from 23 European countries and approximately 5000 workers. CONCLUSION: The IMA-DMP database provides the European minerals sector with reliable data regarding worker personal exposures to respirable dust and quartz. The database can be used as a powerful tool to address outstanding scientific issues on long-term exposure trends and exposure variability, and importantly, as a surveillance tool to evaluate exposure control measures. The database will be valuable for future epidemiological studies on respiratory health effects and will allow for estimation of quantitative exposure response relationships.

Asunto(s)

RESUMEN

In accordance with the European regulation for classification, labelling and packaging of substances and mixtures (CLP) as well as the criteria as set out in the Globally Harmonized System (GHS), fine fraction of crystalline silica (CS) has been classified as a specific target organ toxicity, the specific organ in this case being the lung. Generic cut-off values for products containing a fine fraction of CS trigger the need for a method for the quantification of the fine fraction of CS in bulk materials. This article describes the so-called SWeRF method, the size-weighted relevant fine fraction. The SWeRF method combines the particle size distribution of a powder with probability factors from the EN 481 standard and allows the relevant fine fraction of a material to be calculated. The SWeRF method has been validated with a number of industrial minerals. This will enable manufacturers and blenders to apply the CLP and GHS criteria for the classification of mineral products containing RCS a fine fraction of CS.

Asunto(s)