RESUMEN
Squamous cell carcinoma is a common malignant condition affecting the oral cavity and may involve the surrounding maxillofacial regions. Treatment commonly involves resection of the tumor, followed by prosthetic rehabilitation of the resection defect. This clinical report presents a 62-year-old Asian male patient who had previously undergone surgical resection, resulting in a post-surgical Aramany Class II maxillary defect. The patient's medical history included severe trismus, characterized by restricted mouth opening, as well as a diagnosis of maxillary sinus verrucous squamous cell carcinoma. This report provides a comprehensive account of the rapid fabrication of an interim obturator using digitally assisted dentistry techniques.
RESUMEN
@#Lip print is useful in forensic investigations for individual identification. The present study aimed to discriminate sex based on lip print patterns in Malaysian Malay population in Klang Valley using a scanning technique. Lip prints of 360 subjects (180 males and 180 females) were taken using the lipstick-cellophane tape technique, pasted onto A4 papers. These papers were then scanned using Brother DCP-J100 printer (300dpi resolution). The images were analysed using a software based on Suzuki and Tsuchihashi’s classification. The lip print images were divided into six sections which are upper left, upper middle, upper right, lower right, lower middle and lower left. The Pearson chi-square test showed that there are significant differences (p < 0.05) between sexes in each section except for the upper middle section. In males, type V (irregular pattern) was the dominant pattern for upper left, upper right, lower right and lower left sections (ranging from 71.1% to 86.7%) while type IV (reticular pattern) was dominant at upper and middle sections (ranging from 57.2% to 66.1%). Type IV (48.3%) was dominant in upper middle section for female, while for the rest of the sections, type V was the dominant lip print pattern (ranging from 40% to 82.8%). These results showed that sex differentiation between males and females in Malaysian Malay population, Klang Valley can be suggested to be used for identification in forensic investigation.
RESUMEN
In industrial production processes, rotational speed is a key parameter for equipment condition monitoring and fault diagnosis. To achieve rotational speed measurement of rotational equipment under a condition of high temperature and heavy dust, this article proposes a digital approach using an electrostatic sensor. The proposed method utilizes a strip of a predetermined material stuck on the rotational shaft which will accumulate a charge because of the relative motion with the air. Then an electrostatic sensor mounted near the strip is employed to obtain the fluctuating signal related to the rotation of the charged strip. Via a signal conversion circuit, a square wave, the frequency of which equals that of the rotation shaft can be obtained. Having the square wave, the M/T method and T method are adopted to work out the rotational speed. Experiments were conducted on a laboratory-scale test rig to compare the proposed method with the auto-correlation method. The largest relative errors of the auto-correlation method with the sampling rate of 2 ksps, 5 ksps are 3.2% and 1.3%, respectively. The relative errors using digital approaches are both within ±4. The linearity of the digital approach combined with the M/T method or T method is also superior to that of the auto-correlation method. The performance of the standard deviations and response speed was also compared and analyzed to show the priority of the digital approach.