RESUMEN
Over the last two years, global regulatory authorities have raised safety concerns on nitrosamine contamination in several drug classes, including angiotensin II receptor antagonists, histamine-2 receptor antagonists, antimicrobial agents, and antidiabetic drugs. To avoid carcinogenic and mutagenic effects in patients relying on these medications, authorities have established specific guidelines in risk assessment scenarios and proposed control limits for nitrosamine impurities in pharmaceuticals. In this review, nitrosation pathways and possible root causes of nitrosamine formation in pharmaceuticals are discussed. The control limits of nitrosamine impurities in pharmaceuticals proposed by national regulatory authorities are presented. Additionally, a practical and science-based strategy for implementing the well-established control limits is notably reviewed in terms of an alternative approach for drug product N-nitrosamines without published AI information from animal carcinogenicity testing. Finally, a novel risk evaluation strategy for predicting and investigating the possible nitrosation of amine precursors and amine pharmaceuticals as powerful prevention of nitrosamine contamination is addressed.
RESUMEN
Risedronate is a nitrogen-containing bisphosphonate for the treatment and prevention of postmenopausal osteoporosis. The current work aims to develop a novel green HPLC-UV method for the rapid analysis of risedronate sodium in bulk and tablet formulation. The analyzed samples were separated on Waters Atlantis dC18 (150 mm × 3.9 mm; 5 µm) column using a green mobile phase consisting of potassium phosphate buffer pH 2.9 and potassium edetate buffer pH 9.5 in a ratio of 1:2, the final pH was adjusted to 6.8 with phosphoric acid, the mobile phase was pumped at a rate of 1.0 mL/min, with column temperature set at 30 °C, eluted samples were detected at 263 nm and the chromatographic run time was 3.0 min. The method was found to be linear over the concentration range of 14-140 µg/mL with a correlation coefficient (r2) of 0.9994. Accuracy and precision were evaluated from three QC samples (LQC, MQC and HQC) together with the five calibrators where the percentage accuracy was found to be 101.84%. Processed quality control samples of risedronate sodium were tested for stability at different conditions, short term, long term and freeze- thaw stability. The current method was further extended to study the content uniformity of Actonel® tablets following United States Pharmacopoeia (USP) guidelines. The proposed method was fully validated as per ICH guidelines.
RESUMEN
Lamotrigine is a BCS class II drug with pH dependent solubility. The bilayered gastric mucoadhesive tablets of lamotrigine were designed such that the drug and controlled release polymers were incorporated in the upper layer and the lower layer had the mucoadhesive polymers. The major ingredients selected for the upper layer were the drug and control release polymer (either HPMC K15M or polyox) while the lower MA layer predominantly comprised of Carbopol 974P. A 2(3) full factorial design was constructed for this study and the tablets were optimized for parameters like tablet size, shape, ex vivo mucoadhesive properties and unidirectional drug release. Oval tablets with an average size of 14 mm diameter were set optimum. Maximum mucoadhesive bond strength of 79.3 ± 0.91 * 10(3) dyn/cm(2) was achieved with carbopol when used in combination with a synergistic resin polymer. All the tested formulations presented a mucoadhesion time of greater than 12 h. The incorporation of methacrylic polymers in the lower layer ensured unidirectional drug release from the bilayered tablets. The unidirectional drug release was confirmed after comparing the dissolution results of paddle method with those of a modified basket method. Model independent similarity and dissimilarity factor methods were used for the comparison of dissolution results. Controlled drug release profiles with zero order kinetics were obtained with polyox and HPMC K15M which reported t 90% at 6th and 12th hours, respectively. The "n" value with polyox was 0.992 and that with HPMC K15M was 0.946 indicating an approximate case II transport. These two formulations showed the potential for oral administration of lamotrigine as bilayered gastric mucoadhesive tablets by yielding highest similarity factor values, 96.06 and 92.47, respectively, between the paddle and modified basket method dissolution release profiles apart from reporting the best tablet physical properties and maximum mucoadhesive strength.