RESUMEN

The goal was to evaluate the efficacy of the sausage technique in reconstructing the crestal buccal bone thickness, focusing on the distribution shape of the regenerated volume. Ten implants were placed in five patients with Cawood-Howell class IV defects. A cone beam computed tomography (CBCT) was executed at T0 (before surgery). Guided bone regeneration (GBR) with the sausage technique utilized a resorbable collagen membrane, made of a 50% autologous bone and a 50% anorganic bovine bone matrix (ABBM) mixture. After 6 months, a CBCT (T1) was performed before implant placement. Using CBCT software, a plane parallel to the implant axis intersected perpendicular planes every 1.5 mm from the crest level. T0 and T1 CBCT sections were analyzed, yielding 140 measurements. Statistical analysis via SPSS revealed a significant increase in thickness (average 2.82 ± 1.79 mm). Maximum gains occurred at 4.5 mm from the coronal crest line (3.8 ± 1.51 mm). The GBR sausage technique was effective with minimal post-operative complications, yielding the biggest gain at the mid-ridge sagittal area. Within the analysis limitations, it can be assumed that the sausage technique is effective for horizontal GBR in the maxilla, but a lesser volume might be achieved at the crestal level because it seems to follow a bowed regeneration shape.

RESUMEN

Bone augmentation techniques have been used in atrophic ridges to attain appropriate bone volume and enable dental implant insertion. By reducing the need for autogenous bone and decreasing morbidity at the donor sites, the use of bone substitutes has improved patient comfort and satisfaction. One of the major challenges in implant dentistry is achieving an optimal esthetic result with implant-supported crowns in the esthetic zone. Multiple prosthetic and surgical aspects need to be carefully planned and executed to achieve the final esthetic result. This is a report describing bone augmentation using the sausage technique and subsequent prosthetic rehabilitation in two cases.

RESUMEN

BACKGROUND: Resorption of alveolar bone is a common sequela of tooth loss and presents a clinical problem, especially in the esthetic zone. When ridge resorption occurs, adequate bone augmentation is essential to obtain satisfactory esthetic results. The purpose of this study was to determine the increase and retention rate of bone height or width in patients who received extensive bone augmentation and to analyze factors affecting its prognosis and stability. METHODS: This study was performed on patients who received extensive bone augmentation by sausage technique at the Department of Oral and Maxillofacial Surgery at Ewha Womans University Mok-dong Hospital from January 1, 2018, to February 28, 2022. CBCT images were taken before and 6 months after surgery to compare the amount of increase in bone height or width at the graft site. They were measured using reliable points such as adjacent implants or cephalometric landmarks, inferior alveolar nerve canals as reference points. RESULTS: A total of 8 patients underwent extensive bone grafting during the given period (mean age was 53.75 years, 2 males and 6 females). Four patients received horizontal augmentation, and 4 received vertical augmentation. When divided by surgical site, 4 patients are in maxilla and 4 in mandible. The average amount of increase in bone width or bone height was 5.38 mm, and the retention rate was about 79.9% after 6 months. The retention rate of horizontal augmentation was 88.8%, which was higher than that of vertical augmentation, which was 74.5%. The maxillary area accounted for 92.2%, and the amount of bone resorption was lower than that of the mandibular area, which was 72.6%. The average stitch out period was about 2.4 weeks, and postoperative dehiscence was observed about 37.5% of the total, more frequently in the mandible (50.0%) than in the maxilla (25.0%). CONCLUSION: In conclusion, extensive bone augmentation achieved significant horizontal or vertical bone height or width increase, and the retention rate after 6 months was also high. In addition, surgery in the maxillary region showed a more successful bone augmentation than in the mandible, with a higher maintenance rate and fewer cases of dehiscence.

RESUMEN

INTRODUCTION: Studies evaluating guided bone regeneration (GBR) on knife-edge ridges using absorbable membranes with staged approaches have reported various horizontal bone gains. This study compared the horizontal bone gain obtained via a conventional technique of GBR and a recently-reported technique. Bone loss during the healing process was also measured. METHODS: Consecutive patients who underwent GBR on knife-edge ridges via a conventional technique (control group) or the Sausage Technique (test group) were included in this study. GBR was performed using a collagen membrane and deproteinized bovine bone mineral combined with an autogenous graft at a 1:1 ratio. Cone-beam computed tomography (CBCT) was performed preoperatively, postoperatively, and after the patient healed. Horizontal bone width was measured on CBCT images 2 mm apical from the top of the crest. The preoperative CBCT and posthealing CBCT were superimposed to calculate the bone gain after healing, and the preoperative and postoperative CBCT scans were superimposed to calculate the bone gain after surgery. Bone loss during healing was calculated by subtracting the width of the ridge after healing from the postoperative width. RESULTS: The mean horizontal bone gain was significantly lower in the control group (2.7 ± 1.8 mm; 83.2%) than in the test group (5.3 ± 2.3 mm; 216.8%) (p = 0.003). The average horizontal bone loss between regeneration and implant placement was 0.9 mm in the control group (27.9%) and 2.1 mm in the test group (29.4%). While the absolute bone loss was significantly different (p = 0.012), the percentage of bone resorption was not (p = 0.608). CONCLUSION: The new technique resulted in significantly more bone gain than a conventional GBR technique. The rate of graft resorption during healing was stable regardless of the amount of grafted material.

Asunto(s)

RESUMEN

BACKGROUND: Calvarial bone grafts have been one of the grafting options that provides predictable results for three-dimensional reconstruction of severely atrophied ridges owing to their low resorption and rapid revascularization, thus providing adequate volume for implant insertion. The aim of this study was to introduce a computer-guided technique for calvarial graft harvest to minimize the complications known with grafting from this donor site. MATERIALS AND METHODS: Eight patients, suffering from severely atrophied, completely edentulous maxillary ridges, with an age range (21-30 years) were operated on (six males and two females). A custom-made guide for each patient based on preoperative computed tomography (CT) was fabricated for harvesting the outer table cortical bone blocks from the parietal bone, then particulate bone was collected with an auto-chip maker. Bilateral sinus lifting was indicated in all cases. The bone blocks were fixed intraorally and the bone particulates filled the gaps and the volume created by sinus lifting, then the whole complex was covered with collagen membranes fixed with titanium tacks. Immediate and 6 months CT were requested for evaluation of the guide accuracy and the graft integration, respectively. RESULTS: In all cases, the guide was found to accurately fit into its preplanned position and to correctly locate the anticipated harvest site with the needed dimensions of the bone blocks. No intraoperative complications were encountered such as breakage through the inner table or cerebrospinal fluid leakage. Postoperatively, all the cases showed uneventual healing except one case that had an anterior dehiscence. CONCLUSION: The computer-guided calvarial bone blocks harvest from the parietal bone is safe and predictable technique for three-dimensional reconstruction of severely atrophic edentulous maxilla.

Asunto(s)

RESUMEN

Reconstruir a região posterior de mandíbula é sempre um grande desafio. Atualmente a confecção e liberação adequada de retalhos têm sido um dos grandes pilares para o sucesso dos enxertos nesse local. Além disso, a escolha de uma técnica reconstrutiva associada ao material de enxerto também são essenciais para o sucesso. Nesse sentido, abordamos neste trabalho um caso clínico com defeito em espessura em região posterior de mandíbula, cujo manejo do mesmo envolveu todos esses pilares (AU).

Asunto(s)