RESUMEN
INTRODUCTION: This study evaluated the effect of residual substances derived from irrigant solutions and intracanal medications on the rheological properties of a silicone, gutta-percha, and bioactive glass-based sealer in comparison with an epoxy resin-based sealer. METHODS: Thin films of contaminants (0.5 µL) (3% sodium hypochlorite [NaOCl], chlorhexidine digluconate [CHX], 17% EDTA, calcium hydroxide, 40% citric acid, or distilled water [DW]) were applied along with freshly mixed GuttaFlow Bioseal (GFB; Coltene/Whaledent, Langenau, Germany) or AH Plus Jet (Dentsply DeTrey, Konstanz, Germany) on the lower plate of a dynamic rheometer. Rheological measurements were performed in oscillating mode at the strain amplitude, angular frequency, and constant temperature of 0.01%, 10 rad/s, and 37°C, respectively. Samples without contaminants served as controls. All measurements were performed 5 times. The Kolmogorov-Smirnov test and 1-way analysis of variance followed by the Student-Newman-Keuls test were performed to analyze the results (P < .05). RESULTS: The contaminants did not alter the setting time of GFB compared with the controls; however, CHX and calcium hydroxide decreased its complex viscosity (Æ*) (P < .05). The setting time of AH Plus Jet was increased by DW, CHX, citric acid, and EDTA (P < .05). All contaminants decreased its Æ* at the setting point (P < .05). NaOCl led to the greatest alteration of its rheological parameters. CONCLUSIONS: Irrigant solutions and intracanal medications adversely affected at least 1 of the tested rheological properties of both sealers, except for DW and 3% NaOCl, which did not alter any rheological property of GFB.