Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 5 de 5
Filtrar
Más filtros











Base de datos
Intervalo de año de publicación
1.
Polymers (Basel) ; 15(1)2022 Dec 25.
Artículo en Inglés | MEDLINE | ID: mdl-36616426

RESUMEN

Tires are often in service under dynamic conditions. Realizing the high-precision prediction of the mechanical response of rubber materials under cyclic loading can provide guidance for the design of high-performance tires. In this work, the tensile recovery stress-strain responses of rubber materials in nine different components of a truck and bus radial (TBR) tire were obtained through experiments. Before fitting, an experimental data processing method was proposed to facilitate the parameter identification for a hyper-pseudo-viscoelastic model, that is, the raw experimental data were changed to the adjusted test data. The HyperFit software was used to fit the adjusted test data based on the Yeoh hyperelastic model and the Ogden-Roxburgh pseudoelastic model to obtain the initial material parameters for the two models. In order to describe the permanent set, the Prony series viscoelastic model was introduced. The Isight software was adopted to optimize the parameters. The results showed that the hyper-pseudo-viscoelastic model (i.e., the combination of Yeoh, Ogden-Roxburgh and Prony series models) can describe the tensile recovery mechanical responses (loading curve, unloading curve and permanent set) of nine different rubber components in TBRs. The fitting results are in good agreement with the adjusted data, and all the coefficients of determination (R2) exceed 0.975. Finally, the cyclic deformation simulation of a dumbbell rubber specimen was carried out based on the above constitutive model and fitted parameters. R2 was used to describe the simulation accuracy and its value reached 0.968.

2.
J Mech Behav Biomed Mater ; 121: 104588, 2021 09.
Artículo en Inglés | MEDLINE | ID: mdl-34091153

RESUMEN

A primary cause of bioprosthetic heart valve failure is premature degeneration of the pericardial leaflets, owing specifically to mechanical fatigue. There remains a paucity of experimental data and understanding of the fatigue-damage behaviour of this collagenous tissue under complex loading regimes. To meet this knowledge gap, a novel pressure inflation system was designed and built, to cyclically load circular samples of glutaraldehyde fixed bovine pericardium, under equibiaxial bulge conditions. A study up to 60 million cycles revealed new insights into the fatigue behaviour of pericardial tissue, where a statistically significantly higher level of permanent set was found in samples with high collagen fibre dispersion, in comparison to those with highly aligned fibres. Whilst permanent set is known to occur in the non-collagenous matrix of pericardium, this study demonstrates that at physiological loads, which elicit a matrix dominant mechanical response, permanent set and thus tissue-level damage, is still mediated by the underlying collagen fibres.


Asunto(s)
Bioprótesis , Prótesis Valvulares Cardíacas , Animales , Bovinos , Glutaral , Válvulas Cardíacas , Pericardio
3.
J Mech Behav Biomed Mater ; 115: 104277, 2021 03.
Artículo en Inglés | MEDLINE | ID: mdl-33429172

RESUMEN

An effective description of the mechanical behavior of biodegradable copolymers suture threads requires the analysis of their response under cyclic loading and the prediction of the fundamental damage and residual stretches effects. In this paper we propose a micromechanically-based model adopting a new form of Worm Like Chain free energy for the copolymer chains, which takes care of the insurgence of residual stretches on the basis of a rigorous statistical mechanics result. Under the affinity hypothesis we subsequently derive the macroscopic response of the material. The obtained model has a clear physical interpretation and depends on a small number of parameters, which can be fitted by a simple uniaxial test. The effectiveness of the theoretical results has then been verified by performing cyclic tests on Monocryl® monofilament sutures and showing the ability of the model in predicting with high accuracy the history dependence, the damage and permanent deformations in the obtained response.


Asunto(s)
Polímeros , Suturas , Fenómenos Físicos
4.
J Cardiovasc Transl Res ; 10(2): 194-205, 2017 Apr.
Artículo en Inglés | MEDLINE | ID: mdl-28213846

RESUMEN

Bioprosthetic heart valves (BHVs), derived from glutaraldehyde crosslinked (GLUT) porcine aortic valve leaflets or bovine pericardium (BP), are used to replace defective heart valves. However, valve failure can occur within 12-15 years due to calcification and/or progressive structural degeneration. We present a novel fabrication method that utilizes carbodiimide, neomycin trisulfate, and pentagalloyl glucose crosslinking chemistry (TRI) to better stabilize the extracellular matrix of BP. We demonstrate that TRI-treated BP is more compliant than GLUT-treated BP. GLUT-treated BP exhibited permanent geometric deformation and complete alteration of apparent mechanical properties when subjected to induced static strain. TRI BP, on the other hand, did not exhibit such permanent geometric deformations or significant alterations of apparent mechanical properties. TRI BP also exhibited better resistance to enzymatic degradation in vitro and calcification in vivo when implanted subcutaneously in juvenile rats for up to 30 days.


Asunto(s)
Bioprótesis , Carbodiimidas/farmacología , Reactivos de Enlaces Cruzados/farmacología , Fijadores/farmacología , Implantación de Prótesis de Válvulas Cardíacas/instrumentación , Prótesis Valvulares Cardíacas , Taninos Hidrolizables/farmacología , Neomicina/farmacología , Pericardio/efectos de los fármacos , Pericardio/trasplante , Fijación del Tejido/métodos , Animales , Fenómenos Biomecánicos , Calcinosis/etiología , Calcinosis/patología , Bovinos , Glutaral/farmacología , Supervivencia de Injerto , Implantación de Prótesis de Válvulas Cardíacas/efectos adversos , Xenoinjertos , Masculino , Ratas Sprague-Dawley , Resistencia a la Tracción , Factores de Tiempo , Trasplante Heterólogo
5.
J Biomech ; 49(13): 2863-2869, 2016 09 06.
Artículo en Inglés | MEDLINE | ID: mdl-27416779

RESUMEN

Prior to testing, soft tissues are usually maintained in different media and additives (solution, air, cryopreservant…) under various environment conditions (temperature, storage duration….). In many cases, results from mechanical tests performed on these stored tissues are supposed to be as closed as possible to the fresh ones. In the present work, cyclic tensile tests were performed with increasing values of strain on porcine skin tissues (excised following the Langer's lines) to enhance tissues mechanical nonlinearity such as softening behavior and permanent set. Optical methods were used to follow the in-plane strains evolution. These latest values were used as data to simulate the structural behavior of these heterogeneous materials. The numerical simulation is based on the constitutive pseudo-elastic model accounting for the softening behavior as well as the permanent set. As a result, reliable material parameters were extracted from the experiments/model comparison for each storage solution. The result of this study reveals that preservation conditions must be carefully chosen: at low strain the tissues store in fridge in a saline solution during a short time, or in freezer (-80°C) in water with cryopreservant and the fresh one lead to a similar mechanical response. For larger strain, the freezing (-80°C) in water with cryopreservant is the only procedure for which the tissue recovers its initial behavior.


Asunto(s)
Criopreservación , Ensayo de Materiales , Modelos Estadísticos , Piel/citología , Estrés Mecánico , Porcinos , Animales , Dinámicas no Lineales , Resistencia a la Tracción
SELECCIÓN DE REFERENCIAS
DETALLE DE LA BÚSQUEDA