RESUMEN

In this study, cladodes of Opuntia ficus indica (OFIC), chemically modified with NaOH (OFICM), have been prepared, characterized, and tested as an effective biomass to remove Pb(II) and/or Cd(II) from aqueous media. At an optimum pH of 4.5, the adsorption capacity, qe, of treated OFICM was almost four times higher than that of untreated OFIC. The maximum adsorption capacities (qmax) in the single removal of Pb(II) and Cd(II) were 116.8 and 64.7 mg g-1, respectively. These values were 12.1% and 70.6% higher than those for the corresponding qmax in binary removal, which indicates the strong inhibitive effect of Pb(II) on the co-cation Cd(II) in a binary system. Structural and morphological characterization have been carried out by FTIR, SEM/EDX, and point of zero charge (pHPZC) measurements. The SEM/EDX results confirmed that the metals are adsorbed on the surface. The presence of C-O, C=O, and COO- functional groups were identified by FTIR on both OFIC and OFICM surfaces. On the other hand, we found that the adsorption processes followed the pseudo-second-order kinetics for both single and binary systems, with a fast biosorption rate of Pb(II) and Cd(II). The equilibrium data (adsorption isotherms) were better described by Langmuir and modified-Langmuir models for single and binary systems, respectively. A good regeneration of OFICM was obtained with an eluent of 0.1 M HNO3. Therefore, OFICM can be efficiently reused to remove Pb or Cd, up to three times.

Asunto(s)

Opuntia , Contaminantes Químicos del Agua , Cadmio/análisis , Opuntia/química , Plomo , Contaminantes Químicos del Agua/análisis , Biomasa , Adsorción , Cinética , Concentración de Iones de Hidrógeno

RESUMEN

Arabica-coffee and Theobroma-cocoa agroindustrial wastes were treated with NaOH and characterized to efficiently remove Pb(II) from the aqueous media. The maximum Pb(II) adsorption capacities, qmax, of Arabica-coffee (WCAM) and Theobroma-cocoa (WCTM) biosorbents (qmax = 303.0 and 223.1 mg·g−1, respectively) were almost twice that of the corresponding untreated wastes and were higher than those of other similar agro-industrial biosorbents reported in the literature. Structural, chemical, and morphological characterization were performed by FT-IR, SEM/EDX, and point of zero charge (pHPZC) measurements. Both the WCAM and WCTM biosorbents showed typical uneven and rough cracked surfaces including the OH, C=O, COH, and C-O-C functional adsorbing groups. The optimal Pb(II) adsorption, reaching a high removal efficiency %R (>90%), occurred at a pH between 4 and 5 with a biosorbent dose of 2 g·L−1. The experimental data for Pb(II) adsorption on WACM and WCTM were well fitted with the Langmuir-isotherm and pseudo-second order kinetic models. These indicated that Pb(II) adsorption is a chemisorption process with the presence of a monolayer mechanism. In addition, the deduced thermodynamic parameters showed the endothermic (ΔH0 > 0), feasible, and spontaneous (ΔG0 < 0) nature of the adsorption processes studied.

Asunto(s)

Cacao , Coffea , Contaminantes Químicos del Agua , Café , Plomo , Espectroscopía Infrarroja por Transformada de Fourier , Contaminantes Químicos del Agua/química , Concentración de Iones de Hidrógeno , Termodinámica , Agua/química , Cinética , Adsorción

RESUMEN

A new biosorbent based on Nostoc commune (NC) cyanobacteria, chemically modified with NaOH (NCM), has been prepared, characterized and tested as an effective biomass to remove Pb(II) in aqueous media. The adsorption capacity of NCM was determined to be qe = 384.6 mg g−1. It is higher than several other biosorbents reported in the literature. Structural and morphological characterization were performed by FTIR, SEM/EDX and point zero of charge pH (pHPZC) measurements. NCM biosorbent showed more porous surfaces than those NC with heterogeneous plates including functional adsorption groups such as OH, C = O, COO−, COH or NH. Optimal Pb(II) adsorption occurred at pH 4.5 and 5.5 with a biomass dose of 0.5 g L−1. The experimental data of the adsorption process were well fitted with the Freundlich-isotherm model and pseudo-2nd order kinetics, which indicated that Pb(II) adsorption was a chemisorption process on heterogeneous surfaces of NCM. According to the thermodynamic parameters, this process was exothermic (∆H0 < 0), feasible and spontaneous (∆G0 < 0). NCM can be regenerated and efficiently reused up to 4 times (%D > 92%). NCM was also tested to remove Pb (%R~98%) and Ca (%R~64%) from real wastewater.

Asunto(s)

Nostoc commune , Contaminantes Químicos del Agua , Plomo , Biomasa , Contaminantes Químicos del Agua/química , Termodinámica , Cinética , Adsorción , Concentración de Iones de Hidrógeno

RESUMEN

Tridimensional cubic mesoporous silica, SBA-16, functionalized with aminopropyl groups, were employed as adsorbents for Pb2+ ion removal from aqueous solution. The adsorption capacity was investigated for the effect of pH, contact time, temperature, and concentration of 3-aminopropyltriethoxysilane (APTES) employed for adsorbent functionalization. The textural properties and morphology of the adsorbents were evaluated by N2 physisorption, small-angle X-ray diffraction (XRD), diffuse reflectance spectroscopy (UV-vis), and transmission electron microscopy (TEM). The functionalization of the SBA-16 was evaluated by elemental analysis (N), thermogravimetric analysis (TG), Fourier transform infrared spectroscopy (FT-IR), and X-ray photoelectron spectroscopy (XPS). Batch adsorption studies show that the total Pb2+ ions removal was archived on adsorbent having an optimized amount of aminopropyl groups (2N-SBA-16). The maximum of Pb2+ ions removal occurred at optimized adsorption conditions: pH = 5-6, contact time 40 min, and at a low initial lead concentration in solution (200 mg L-1). Under the same adsorption conditions, the amino-functionalized SBA-16 with cubic 3D unit cell structure exhibited higher adsorption capability than its SBA-15 counterpart with uniform mesoporous channels.