RESUMEN
Semiconductors, such as metal oxides and metal sulfides (MSX), are widely investigated as effectively catalytic materials to convert carbon dioxide (CO2) and water into chemicals under simulated solar light. These valuable investigations might address both the energy crisis and climate change in our modern society. Herein, a novel strategy to construct leaf-like heterojunctions of VS-ZnIn2S4/TiN-x is reported. The new semiconductor heterojunctions were then applied to photoelectrocatalytic CO2 reduction, achieving excellent performance (formate formation rate of 1173.2 µM h-1 cm-2) attributed to the plant cell-like morphology and enhanced electron mobility from the heterojunction interfaces to the active sites on the surface. Our findings suggest that titanium nitride (TiN) with good conductivity can improve the photoelectrocatalytic ability of MSX through heterojunction construction. The photocathode VS-ZnIn2S4/TiN-3 exhibits 81.0 % selectivity toward C2 products by optimizing the material structure and reaction conditions. According to the systematic investigation of operando Fourier transform infrared (FTIR) spectra, common intermediates such as *COO-, *COOH, *CO, *CHO, *COCHO, and *COCH3 reported in the literature were carefully verified. Among these, the carbene specie serve as the key intermediate responsible for generating other intermediates and resulting in all products.
RESUMEN
The defects and interface engineering are efficient approaches to adjust the physical and chemical properties of nanomaterials to enhance catalytic performance. In this study, we report a new MOFs-driven porous Cu2S/MoS2-Vs octahedral semiconductor with heterostructure and photothermal effect. The introduction of sulfur vacancies directly improves the adsorption performance of CO2, and the formation of heterostructure significantly increases the charge transfer rate. The C-penetrating material obtained from MOFs not only acts as an octahedral skeleton support, but also gives photothermal effects under photoelectric conditions. The formation rate of sole C2 products in photoelectrocatalytic CO2 reduction by using Cu2S/MoS2-Vs heterostructure is up to 52 µM·h-1·cm-2 equal to the total electron transfer rate of 541 µM·h-1·cm-2. The carbene mechanism and reaction pathways were proposed and verified by 13CO2 isotopic labelling and operando Fourier transform infrared (FT-IR) spectra. The important intermediates of *CO2-, *CO, *CHO and *CHO-CHO were identified by operando FT-IR spectra. In the comparative experiments, the photothermal electrons are beneficial to C2 products. DFT calculations indicate that the presence of S vacancies (Vs) reduces the energy barrier for product generation.
RESUMEN
Actinide-based catalysts have been regarded as promising candidates for N2 fixation owing to their unique 5f orbital with flexible oxidation states. Herein, we report for the first time the dispersion of uranium (U) single atoms on TiO2 nanosheets via oxygen vacancy confinement for N2 electroreduction. The single-atom U catalyst exhibited a high NH3 yield of 40.57 µg h-1 mg-1, with a reasonably high Faraday efficiency of 25.77%, ranking first among the reported nitrogen-free catalysts. Isotope-labeling operando synchrotron infrared spectroscopy verifies that the key *N2Hy intermediate species was derived from the N2 gas of the feed. By using operando X-ray absorption spectroscopy, we found enhanced metal-support interaction between U single atoms and TiO2 lattice with more U-Olatt coordination under working conditions. Theoretical simulations suggest that the evolved 1Oads-U-4Olatt moieties act as a critical electron-feedback center, lowering the thermodynamic energy barrier for the N2 dissociation and the first hydrogenation step. This work provides the possibility of tailoring the interaction between metal active sites and supports for designing high-performance actinide-based single-atom catalysts.
RESUMEN
Single atom tailored metal nanoparticles represent a new type of catalysts. Herein, we demonstrate a single atom-cavity coupling strategy to regulate performance of single atom tailored nano-catalysts. Selective atomic layer deposition (ALD) was conducted to deposit Ru single atoms on the surface concavities of PtNi nanoparticles (Ru-ca-PtNi). Ru-ca-PtNi exhibits a record-high activity for methanol oxidation reaction (MOR) with 2.01â A mg-1 Pt . Also, Ru-ca-PtNi showcases a significant durability with only 16 % activity loss. Operando electrochemical Fourier transform infrared spectroscopy (FTIR) and theoretical calculations demonstrate Ru single atoms coupled to cavities accelerate the CO removal by regulating d-band center position. Further, the high diffusion barrier of Ru single atoms in concavities accounts for excellent stability. The developed Ru-ca-PtNi via single atom-cavity coupling opens an encouraging pathway to design highly efficient single atom-based (electro)catalysts.
RESUMEN
The electronic and structural properties of Au/ZnO under industrial and idealized methanol synthesis conditions have been investigated. This was achieved by kinetic measurements in combination with time-resolved operando infrared (DRIFTS) as well as inâ situ near-ambient pressure X-ray photoelectron spectroscopy (NAP-XPS) and X-ray absorption near-edge spectroscopy (XANES) measurements at the O K-edge together with high-resolution electron microscopy. The adsorption of CO during the reaction revealed the presence of negatively charged Au nanoparticles/Au sites during the initial phase of the reaction. Near-ambient-pressure XPS and XANES demonstrate the build-up of Oâ vacancies during the reaction, which goes along with a substantial increase in the rate of methanol formation. The results are discussed in comparison with previous findings for Cu/ZnO and Au/ZnO catalysts.
RESUMEN
An original step-by-step approach to synthesize and characterize a bifunctional heterogeneous catalyst consisting of isolated Ti(3+) centers and strong Lewis acid Al(3+) sites on the surface of a chlorinated alumina has been devised. A wide range of physicochemical and spectroscopic techniques were employed to demonstrate that the two sites, in close proximity, act in a concerted fashion to synergistically boost the conversion of ethylene into branched polyethylene, using ethylene as the only feed and without any activator. The coordinatively unsaturated Al(3+) ions promote ethylene oligomerization through a carbocationic mechanism and activate the Ti(3+) sites for the traditional ethylene coordination polymerization.