RESUMEN
Slow dissolution/hydrolysis of insoluble/macromolecular organics and poor sludge filterability restrict the application potential of anaerobic membrane bioreactor (AnMBR). Bubble-free membrane microaeration was firstly proposed to overcome these obstacles in this study. The batch anaerobic digestion tests feeding insoluble starch and soluble peptone with and without microaeration showed that microaeration led to a 65.7-144.8% increase in methane production and increased critical flux of microfiltration membrane via driving the formation of large sludge flocs and the resultant improvement of sludge settleability. The metagenomic and bioinformatic analyses showed that microaeration significantly enriched the functional genes and bacteria for polysaccharide and protein hydrolysis, microaeration showed little negative effects on the functional genes involved in anaerobic metabolisms, and substrate transfer from starch to peptone significantly affected the functional genes and microbial community. This study demonstrates the dual synergism of microaeration to enhance the dissolution/hydrolysis/acidification of insoluble/macromolecular organics and sludge filterability for AnMBR application.
Asunto(s)
Reactores Biológicos , Filtración , Membranas Artificiales , Aguas del Alcantarillado , Reactores Biológicos/microbiología , Aguas del Alcantarillado/microbiología , Anaerobiosis , Filtración/métodos , Metano/metabolismo , Hidrólisis , Almidón/metabolismoRESUMEN
A process of denitrification filter (DNF) coupled with ultrafiltration (UF) and ozonation (DNF-UF-O3) has been widely applied to advanced nitrogen removal for wastewater reclamation. Despite of the effective removal of nitrogen by DNF, the influence of DNF stage on the operation of UF was still unclear. In this study, a laboratory filtration system was used to investigate the membrane fouling potential of DNF effluent and the fouling control of ozonation. The membrane fouling potential was proved to be increased significantly after DNF stage and alleviated with ozonation treatment. With the help of UV-vis, fluorescence spectroscopy, scanning electron microscopy (SEM) and molecular weight (MW) analysis, the change of DOM component characteristics was proved to be in accordance with the change of fouling potential. The water samples were further fractionated into six hydrophobic/hydrophilic acidic/basic/neutral fractions, among which hydrophobic acids (HOA) and hydrophobic neutrals (HON) dominated the membrane fouling potential of DNF effluent. Detailed study of each fraction revealed that higher MW components in HOA and HON played a crucial role in the fouling of UF membrane. The dominant component of membrane fouling could be degraded and removed by ozonation, and therefore significant fouling alleviation was achieved. These results indicated that in the process of wastewater reclamation, besides conventional water quality indexes, more detailed water features should also be taken into consideration to optimize the whole process. Moreover, the control effects by ozonation could be monitored simply according to the change of specific UV absorbance (SUVA) and fluorescence intensity as surrogates in engineering applications. According to these results, a modified DNF-O3-UF process with O3 dosage of 3 mg/L was proposed simply by reversing the sequence of UF and O3 with no more infrastructure. This modified DNF-O3-UF process was expected to enlarge the produce capacity of reclaimed water with much lower electricity costs and chemical consumption.
Asunto(s)
Ozono , Purificación del Agua , Desnitrificación , Membranas Artificiales , Ultrafiltración , Aguas ResidualesRESUMEN
In this study, the properties of unstable and stable flocs were investigated under the steady operation of a membrane bioreactor (MBR). The extracellular polymeric substances (EPS) composition, surface charge, and hydrophobicity of unstable and stable flocs were examined and compared. Interfacial interactions of the membrane with unstable flocs, unstable flocs themselves, and unstable and stable flocs were assessed using the extended Derjaguin-Landau-Verwey-Overbeek (XDLVO) models. Cake layer resistance was found to contribute more than 80% of total resistance under steady operating conditions. Compared with stable flocs, unstable flocs possessed a higher level of EPS, more diverse protein, more negative charge, weaker hydrophobicity, and higher fouling potential. Thermodynamic analyses showed that unstable flocs had a higher adhesive strength (- 63.4 mJ/m2) with the membrane, lower self-cohesive strength (- 18.3 mJ/m2), and higher cohesive strength (- 54.3 mJ/m2) with stable flocs. Therefore, some unstable flocs remained on the membrane surface to form the cake layer due to their poor cohesion strength.
Asunto(s)
Reactores Biológicos , Aguas del Alcantarillado/análisis , Interacciones Hidrofóbicas e Hidrofílicas , TermodinámicaRESUMEN
Membrane fouling remains a major challenge for wider application of membrane bioreactors (MBRs) to wastewater treatment. Membrane fouling is mainly caused by microorganisms and their excreted microbial products. For development of more effective control strategies, it is important to identify and characterize the microorganisms that are responsible for membrane fouling. In this study, 41 bacterial strains were isolated from fouled microfiltration membranes in a pilot-scale MBR treating real municipal wastewater, and their membrane fouling potentials were directly measured using bench-scale cross-flow membrane filtration systems (CFMFSs) and related to their cellular properties. It was found that the fouling potential was highly strain dependent, suggesting that bacterial identification at the strain level is essential to identify key fouling-causing bacteria (FCB). The FCB showed some common cellular properties. The most prominent feature of FCB was that they formed convex colonies having swollen podgy shape and smooth lustrous surfaces with high water, hydrophilic organic matter and carbohydrate content. However, general and rigid biofilm formation potential as determined by microtiter plates and cell surface properties (i.e., hydrophobicity and surface charge) did not correlate with the fouling potential in this study. These results suggest that the fouling potential should be directly evaluated under filtration conditions, and the colony water content could be a useful indicator to identify the FCB.