RESUMEN
The discovery of brain therapeutics faces a significant challenge due to the low translatability of preclinical results into clinical success. To address this gap, several efforts have been made to obtain more translatable neuronal models for phenotypic screening. These models allow the selection of active compounds without predetermined knowledge of drug targets. In this review, we present an overview of various existing models within the field, examining their strengths and limitations, particularly in the context of neuropathic pain research. We illustrate the usefulness of these models through a comparative review in three crucial areas: i) the development of novel phenotypic screening strategies specifically for neuropathic pain, ii) the validation of the models for both primary and secondary screening assays, and iii) the use of the models in target deconvolution processes.
Asunto(s)
Neuralgia , Humanos , Neuralgia/tratamiento farmacológico , EncéfaloRESUMEN
The number of models for assessing the solubility of active pharmaceutical ingredients (APIs) in polymeric matrices on the one hand and the extent of available associated data on the other hand has been rising steadily in the past few years. However, according to our knowledge an overview on the methods used for prediction and the respective experimental data is missing. Therefore, we compiled experimental data, the techniques used for their determination and the models used for estimating the solubility. Our focus was on polymers commonly used in spray drying and hot-melt extrusion to form amorphous solid dispersions (ASDs), namely polyvinylpyrrolidone grades (PVP), polyvinyl acetate (PVAc), vinylpyrrolidone-vinyl acetate copolymer (copovidone, COP), polyvinyl caprolactam-polyvinyl acetate-polyethylene glycol graft polymer (Soluplus®, SOL), different types of methacrylate copolymers (PMMA), polyethylene glycol grades (PEG) and hydroxypropyl-methylcellulose grades (HPMC). The literature data were further supplemented by our own results. The final data set included 37 APIs and two sugar derivatives. The majority of the prediction models was constituted by the melting point depression method, dissolution endpoint measurements, indirect solubility determination by Tg and the use of low molecular weight analogues. We observed that the API solubility depended more on the working group which conducted the experiments than on the measuring technique used. Furthermore, this compilation should assist researchers in choosing a prediction method suited for their investigations. Furthermore, a statistical assessment using recursive feature elimination was performed to identify descriptors of molecules, which are connected to the API solubility in polymeric matrices. It is capable of predicting the criterium 20% API soluble at 100⯰C (Yes/No) for an unknown compound with a balanced accuracy of 71%. The identified 8 descriptors to be connected to API solubility in polymeric matrices were the number of hydrogen bonding donors, three descriptors related to the hydrophobicity of the molecule, glass transition temperature, fractional negative polar van der Waals surface area, out-of-plane potential energy and the fraction of rotatable bonds. Finally, in addition to our own model, the data set should help researchers in training their own solubility prediction models.
Asunto(s)
Preparaciones Farmacéuticas/química , Polímeros/química , Solubilidad/efectos de los fármacos , Química Farmacéutica/métodos , Composición de Medicamentos/métodos , Derivados de la Hipromelosa/química , Polietilenglicoles/química , Polivinilos/química , Povidona/análogos & derivados , Povidona/química , Pirrolidinas/química , Temperatura de Transición , Compuestos de Vinilo/químicaRESUMEN
The composition of the human intestinal fluids varies both intra- and inter-individually. This will influence the solubility of orally administered drug compounds, and hence, the absorption and efficacy of compounds displaying solubility limited absorption. The purpose of this study was to assess the influence of simulated intestinal fluid (SIF) composition on the solubility of poorly soluble compounds. Using a Design of Experiments (DoE) approach, a set of 24 SIF was defined within the known compositions of human fasted state intestinal fluid. The SIF were composed of phospholipid, bile salt, and different pH, buffer capacities and osmolarities. On a small scale semi-robotic system, the solubility of 6 compounds (aprepitant, carvedilol, felodipine, fenofibrate, probucol, and zafirlukast) was determined in the 24 SIF. Compound specific models, describing key factors influencing the solubility of each compound, were identified. Although all models were different, the level of phospholipid and bile salt, the pH, and the interactions between these, had the biggest influences on solubility overall. Thus, a reduction of the DoE from five to three factors was possible (11-13 media), making DoE solubility studies feasible compared to single SIF solubility studies. Applying this DoE approach will lead to a better understanding of the impact of intestinal fluid composition on the solubility of a given drug compound.
Asunto(s)
Secreciones Intestinales/química , Modelos Biológicos , Preparaciones Farmacéuticas/química , Administración Oral , Ácidos y Sales Biliares , Humanos , Concentración de Iones de Hidrógeno , Estructura Molecular , Concentración Osmolar , Preparaciones Farmacéuticas/administración & dosificación , Fosfolípidos/química , SolubilidadRESUMEN
Upon oral administration the solubility of a drug in intestinal fluid is a key property influencing bioavailability. It is also recognised that simple aqueous solubility does not reflect intestinal solubility and to optimise in vitro investigations simulated intestinal media systems have been developed. Simulated intestinal media which can mimic either the fasted or fed state consists of multiple components each of which either singly or in combination may influence drug solubility, a property that can be investigated by a statistical design of experiment technique. In this study a design of experiment covering the full range from the lower limit of fasted to the upper limit of fed parameters and using a small number of experiments has been performed. The measured equilibrium solubility values are comparable with literature values for simulated fasted and fed intestinal fluids as well as human fasted and fed intestinal fluids. The equilibrium solubility data range is statistically equivalent to a combination of published fasted and fed design of experiment data in six (indomethacin, phenytoin, zafirlukast, carvedilol, fenofibrate and probucol) drugs with three (aprepitant, tadalafil and felodipine) drugs not equivalent. In addition the measured equilibrium solubility data sets were not normally distributed. Further studies will be required to determine the reasons for these results however it implies that a single solubility measurement without knowledge of the solubility distribution will be of limited value. The statistically significant media factors which promote equilibrium solubility (pH, sodium oleate and bile salt) were in agreement with published results but the number of determined significant factors and factor interactions was fewer in this study, lecithin for example did not influence solubility. This may be due to the reduction in statistical sensitivity from the lower number of experimental data points or the fact that using the full range will examine media parameters ratios that are not biorelevant. Overall the approach will provide an estimate of the solubility range and the most important media factors but will not be equivalent to larger scale focussed studies. Further investigations will be required to determine why some drugs do not produce equivalent DoE solubility distributions, for example combined fasted and fed DoE, but this simply may be due to the complexity and individuality of the interactions between a drug and the media components.
Asunto(s)
Ayuno , Secreciones Intestinales/química , Intestinos/fisiología , Modelos Biológicos , Preparaciones Farmacéuticas , Administración Oral , Ácidos y Sales Biliares , Humanos , SolubilidadRESUMEN
1,4-dihydropyridine antihypertensives (DHPs) are almost all dispensed in solid pharmaceutical formulations for their easy lability when exposed to light. This paper reports a study on the photoprotective effect of containers in different glassy or polymeric matrices with regard to four known DHPs when in solutions. The samples were subjected to forced degradation by means of a Xenon lamp, in accordance with the international rules on drug stability evaluation. The simultaneous determination of the drugs and their photoproducts was carried out by applying the multivariate curve resolution (MCR) methodology to the spectral data recorded along the irradiation test. This technique was able to determine the kinetic parameters and resolve the spectra of the photoproducts. The time required to reduce by 10% the concentration of the drug (t0.1) was adopted as a criterion to compare the protective ability of the containers. A significant photoprotection for all drugs tested was obtained by the use of polyethylene terephthalate (PET) containers. The best result was achieved for the felodipine solution in blue PET transparent bottle of 0.6mm thickness, reaching an almost complete stabilization up to six hours under stressing irradiation. In contrast, the glass containers, whether or not coloured, did not provide a satisfactory photoprotection of the drugs, showing in any case t0.1 values under 24min. These results can be a good opportunity to design new photoprotective pharmaceutical packaging for DHPs in liquid dosage form.
Asunto(s)
Antihipertensivos/química , Dihidropiridinas/química , Embalaje de Medicamentos , Polímeros/química , Estabilidad de Medicamentos , Almacenaje de Medicamentos , Felodipino/química , Vidrio , Luz , Soluciones Farmacéuticas , Fotólisis , Tereftalatos Polietilenos/química , Factores de TiempoRESUMEN
Ethanol can increase the solubility of poorly soluble and hence present a higher drug concentration in the gastrointestinal tract. This may produce a faster and more effective absorption resulting in variable and/or high drug plasma concentrations, both of which can lead to adverse drug reactions. In this work we therefore studied the solubility and absorption effects of nine diverse compounds when ethanol was present. The apparent solubility was measured using the µDiss Profiler Plus (pION, MA) in four media representing gastric conditions with and without ethanol. The solubility results were combined with in-house data on solubility in intestinal fluids (with and without ethanol) and pharmacokinetic parameters extracted from the literature and used as input in compartmental absorption simulations using the software GI-Sim. Apparent solubility increased more than 7-fold for non-ionized compounds in simulated gastric fluid containing 20% ethanol. Compounds with weak base functions (cinnarizine, dipyridamole and terfenadine) were completely ionized at the studied gastric pH and their solubility was therefore unaffected by ethanol. Compounds with low solubility in intestinal media and a pronounced solubility increase due to ethanol in the upper gastric compartments showed an increased absorption in the simulations. The rate of absorption of the acidic compounds indomethacin and indoprofen was slightly increased but the extent of absorption was unaffected as the complete doses were readily absorbed even without ethanol. This was likely due to a high apparent solubility in the intestinal compartment where the weak acids are ionized. The absorption of the studied non-ionizable compounds increased when ethanol was present in the gastric and intestinal media. These results indicate that concomitant intake of alcohol may significantly increase the solubility and hence, the plasma concentration for non-ionizable, lipophilic compounds with the potential of adverse drug reactions to occur.