RESUMEN
Renewable electricity from splitting water to produce hydrogen is a favorable technology to achieve carbon neutrality, but slow anodic oxygen evolution reaction (OER) kinetics limits its large-scale commercialization. Electron spin polarization and increasing the reaction temperature are considered as potential ways to promote alkaline OER. Here, it is reported that in the alkaline OER process under an AC magnetic field, a ferromagnetic ordered electrocatalyst can simultaneously act as a heater and a spin polarizer to achieve significant OER enhancement at a low current density. Moreover, its effect obviously precedes antiferromagnetic, ferrimagnetic, and diamagnetic electrocatalysts. In particular, the noncorrected overpotential of the ferromagnetic electrocatalyst Co at 10 mA cm-2 is reduced by a maximum of 36.6% to 243 mV at 4.320 mT. It is found that the magnetic heating effect is immediate, and more importantly, it is localized and hardly affects the temperature of the entire electrolytic cell. In addition, the spin pinning effect established on the ferromagnetic/paramagnetic interface generated during the reconstruction of the ferromagnetic electrocatalyst expands the ferromagnetic order of the paramagnetic layer. Also, the introduction of an external magnetic field further increases the orderly arrangement of spins, thereby promoting OER. This work provides a reference for the design of high-performance OER electrocatalysts under a magnetic field.
RESUMEN
The dynamic voltage is a unique phenomenon of superconducting materials. It arises when the superconductor is carrying a DC transport current and spontaneously in subject to an AC magnetic field. This study excavates the aspects that previous studies have not comprehensively investigated: the dynamic voltage in a DC-carrying superconducting tape exposed to different oscillating AC magnetic fields. First, the fundamental physics of dynamic voltage/flux of superconductors is reviewed and further analysed in detail. We used the superconducting modelling method using the H-formulation merged into the finite-element method (FEM) software, to re-produce the typical dynamic voltage behaviour of a superconducting tape. The modelling was verified by both the analytical and experimental results, in order to precisely prove the reliability of the modelling. Afterwards, the modelling was performed for a DC-carrying superconducting tape under four different oscillating magnetic fields (sine, triangle, sawtooth and square), and their corresponding dynamic voltages and energy losses were analysed and compared. Results show the sinusoidal magnetic field can lead to the optimal combination of reasonable dynamic voltage but relatively lower loss, which is suitable for those superconducting applications requiring dynamic voltage as the energy source, e.g., flux pumps. This article presents novel investigation and analysis of the dynamic voltage in superconducting materials, and both the methodology and results can provide useful information for the future design/analysis of superconducting applications with DC transport currents and AC magnetic fields.
RESUMEN
As an ideal hydrogen production route, electrolyzed water still faces the challenges of high cost of noble-metal electrocatalysts and low performance of non-noble-metal catalysts in scalable applications. Recently, introduction of external fields (such as magnetic fields, light fields, etc.) to improve the electrocatalytic water splitting performance of non-noble-metal catalysts has attracted great attention due to their simplicity. Here, a simple method for preparing magnetic superstructure (NiFe2O4@MOF-74) is described, and the hydrogen evolution reaction (HER) behavior of its carbonized derivative, a ferromagnetic superstructure, is revealed in a wide range of applied voltage under an AC magnetic field. The overpotential (@10 mA cm-2) required for the HER of the obtained ferromagnetic superstructure in 1 M KOH was reduced by 31 mV (7.7%) when a much small AC magnetic field (only 2.3 mT) is applied. Surprisingly, the promotion effect of the AC magnetic field is not monotonically increasing with the increase of the applied voltage or the strength of AC magnetic field, but increasing first, then weakening. This unusual behavior is believed to be mainly caused by the enhanced induced electromotive force and the additional energy by the applied AC magnetic field. This discovery provides a new idea for adjusting the performance of electrocatalytic reactions.
RESUMEN
A new stimulus-responsive drug delivery system using Fe3O4 nanoparticles coated with molecularly imprinted polymer (MIP) is reported. Magnetic thermal seeds (MTS) with their size controlled between 10 and 20 nm that could generate heat under an alternate current (AC) magnetic field were modified with a thermal-responsive MIP by grafting polymerization for effective release of an anticancer drug, methotrexate (MTX). The MIP-coated MTS showed the superparamagnetic property as well as the selective adsorption ability toward MTX, and 80% of MXT adsorbed on the MIP-coated MTS was stimulus released at 60 °C by cleaving hydrogen bonding in the recognition sites. Finally, the MTX release from the MTX-loaded MIP-coated MTS under an AC magnetic field within 10 min was successfully demonstrated.
RESUMEN
We present a simple method for efficient DNA ligation utilizing the heat generation of ferromagnetic particles subjected to an ac magnetic field. We carry out the ligation of DNA fragments with cohesive ends using T4 DNA ligase immobilized on the surface of ferromagnetic particles. When a radio frequency alternating magnetic field is applied, ferromagnetic particles dissipate heat and DNA ligase on the particles is selectively heated up and activated with little influence on the annealing of DNA ends, as a result of which the ligation efficiency increases. We show that the ligation efficiency increases with an increase in the field amplitude.
RESUMEN
Two types of shaking coils are focused on reducing screening currents induced in solenoid coils wound with high-temperature superconducting (HTS) tapes. One is a pair of copper shaking coils coaxially located inside and outside the HTS coil to apply an ac magnetic field in the axial direction. The other is an HTS shaking coil with notch located only outside the HTS coil to minimize the radial components of local ac fields applied to windings of the HTS coil as small as possible. It is found that the copper shaking coils yield the allowable amount of power dissipation in liquid helium. The effectiveness of the HTS shaking coil to reduce screening-current-induced fields generated by another magnetized HTS coil is also experimentally validated in liquid nitrogen using a commercially available coated conductor with narrow width.